参数资料
| 型号： | KSZ9021GN TR |
| 厂商： | Micrel Inc |
| 文件页数： | 11/53页 |
| 文件大小： | 0K |
| 描述： | TXRX ETHERNET GB GMII/MII 64MLF |
| 标准包装： | 1,000 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 8/8 |
| 规程： | 千兆位以太网 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-VFQFN 裸露焊盘 |
| 供应商设备封装： | 64-QFN（8x8） |
| 包装： | 带卷 (TR) |
| 配用： | 576-3873-ND - BOARD EVALUATION FOR KSZ9021GN |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页
Micrel, Inc.
KSZ9021GN
September 2010
19
M9999-091010-1.1
Pair- Swap, Alignment, and Polarity Check
In 1000Base-T mode, the KSZ9021GN
Detects incorrect channel order and automatically restore the pair order for the A, B, C, D pairs (four channels)
Supports 50±10ns difference in propagation delay between pairs of channels in accordance with the IEEE
802.3 standard, and automatically corrects the data skew so the corrected four pairs of data symbols are
synchronized
Incorrect pair polarities of the differential signals are automatically corrected for all speeds.
Wave Shaping, Slew Rate Control and Partial Response
In communication systems, signal transmission encoding methods are used to provide the noise-shaping feature and to
minimize distortion and error in the transmission channel.
For 1000Base-T, a special partial response signaling method is used to provide the band-limiting feature for the
transmission path.
For 100Base-TX, a simple slew rate control method is used to minimize EMI.
For 10Base-T, pre-emphasis is used to extend the signal quality through the cable.
PLL Clock Synthesizer
The KSZ9021GN generates 125MHz, 25MHz and 10MHz clocks for system timing. Internal clocks are generated from
the external 25 MHz crystal or reference clock.
Auto-Negotiation
The KSZ9021GN conforms to the auto-negotiation protocol, defined in Clause 28 of the IEEE 802.3 Specification.
Auto-negotiation allows UTP (Unshielded Twisted Pair) link partners to select the highest common mode of operation.
During auto-negotiation, link partners advertise capabilities across the UTP link to each other, and then compare their
own capabilities with those they received from their link partners. The highest speed and duplex setting that is common
to the two link partners is selected as the mode of operation.
The following list shows the speed and duplex operation mode from highest to lowest.
Priority 1: 1000Base-T, full-duplex
Priority 2: 1000Base-T, half-duplex
Priority 3: 100Base-TX, full-duplex
Priority 4: 100Base-TX, half-duplex
Priority 5: 10Base-T, full-duplex
Priority 6: 10Base-T, half-duplex
If auto-negotiation is not supported or the KSZ9021GN link partner is forced to bypass auto-negotiation for 10Base-T
and 100Base-TX modes, then the KSZ9021GN sets its operating mode by observing the input signal at its receiver.
This is known as parallel detection, and allows the KSZ9021GN to establish link by listening for a fixed signal protocol in
the absence of auto-negotiation advertisement protocol.
The auto-negotiation link up process is shown in the following flow chart.
相关PDF资料 |
PDF描述 |
|---|---|
| KSZ9021GQI | TXRX GIG ETH GMII/MII 128-PQFP |
| KSZ9021RL | IC TXRX 10/100/1000 SGL 64LQFP |
| KSZ9692PB | IC ARM9 PHY 5MBPS 400-PBGA |
| KSZ9692XPB | IC ARM9 PHY 5MBPS 400-PBGA |
| KXPC823ZT81B2T | IC MPU POWERQUICC 81MHZ 256-PBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ9021GQ | 功能描述:以太网 IC Gigabit Ethernet Transceiver with GMII/MII, Lead Free RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ9021GQI | 功能描述:以太网 IC Gigabit Ethernet Transceiver w/ GMII/MII, I-Temp RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ9021RL | 功能描述:以太网 IC Gigabit Ethernet Transceiver with GMII RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ9021RL-EVAL | 制造商:Micrel Inc 功能描述:GIGABIT ETHERNET TRANSCEIVER W 制造商:Micrel Inc 功能描述:KIT EVALUATION FOR KSZ9021RL |
| KSZ9021RLI | 功能描述:以太网 IC Gigabit Ethernet Transceiver with RGMII, I-Temp RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。