- 您现在的位置：买卖IC网 > PDF目录97995 > L5962 (STMICROELECTRONICS) SWITCHING REGULATOR, PDSO36 PDF资料下载
参数资料
| 型号： | L5962 |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO36 |
| 封装： | ROHS COMPLAINT, SOP-36 |
| 文件页数： | 8/24页 |
| 文件大小： | 242K |
| 代理商： | L5962 |
Device description
L5962
Doc ID 16819 Rev 2
VLR1 (5.0 V /8.5 V) and VLR2 (3.3 V, 5.0 V, 5.5 V, 6.0 V, 7.0 V, 7.5 V, 8.0 V, 10.0 V)
The output of these two regulators can be selected through the I2C bus.
When the dropout voltage of the regulator cannot be maintained, the output tracks the VBAT
input voltage less the saturation voltage of the regulator pass element.
This regulator has a short circuit protection consisting of current limit and thermal shutdown.
If the local die temperature exceeds the thermal shutdown detection threshold, the output is
disabled. The thermal shutdown circuitry has hysteresis such that the output is enabled only
after the die temperature falls below the thermal shutdown disable threshold. Thermal
shutdown on this output doesn't directly disable any other circuitry.
VLR2 has its own power supply (VINLR2) because of its high current capability.
4.1.2
Switching regulator
The IC contains an independent, step-down, synchronous switching regulator, which is used
to produce an output voltage that is adjustable in the system by means of an external
resistor divider.
The switching regulator functionality is guaranteed in the 1.2-8.0 V output voltage range.
The switching frequency is externally synchronizable. The switcher has its own supply input
pin (VINSW) and is enabled by the EN input.
The regulator contains soft-start control to protect external devices from excessive in-rush
currents. This control is independent of the presence of a synchronizing signal on the
SYNCH input.
The switching cycle is synchronized to the internal oscillator unless a signal is present on
the SYNC input. The signal present on the SYNCH input overrides the internal oscillator to
control the switching of the regulator if its frequency gets inside the allowed range (220-
400 kHz). The IC detects a small number of edges (e.g. 2-5) prior to recognize a valid input
signal and synchronizing internal operation to the external signal.
It is designed to operate in continuous conduction mode (CCM), where the inductor current
remains continuous throughout the entire load range of the output. It can also work in DCM
mode.
This regulator has short circuit protection consisting of cycle-by-cycle duty-cycle limitation.
Upon return from over-voltage shutdown this regulator employs the soft-start.
An external bootstrap capacitor must be connected between the output (PH, phase output
pin) and the CBS pin.
The switching regulator output slew rate can be controlled with an external capacitor on the
SOST (soft start) pin. This protects the device against excessive dV/dt transients, lowering
the stress of the internal components. A maximum slews rate of 10 V/ms is suggested.
Two separate current limits for the switching regulator can be chosen in order to guarantee a
proper protection for the device at the desired load current rating. The CLIM pin should be
tied to ground for the low limit (max 3 A) or to 5.0 V for the high limit (max 6 A).
The VFB pin is the voltage feedback from the regulated output for the switching regulator;
the VCMP one is the compensation feedback for the switching regulator.
相关PDF资料 |
PDF描述 |
|---|---|
| L5973DD | 3.5 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO8 |
| L5988D | 5.6 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| L5994A | 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32 |
| L5994 | 1 A DUAL SWITCHING CONTROLLER, 345 kHz SWITCHING FREQ-MAX, PQFP32 |
| L6206PD013TR | STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L5962TR | 功能描述:低压差稳压器 - LDO Multifunction Voltage Regulator RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| L5963D-EHX | 功能描述:Linear And Switching Voltage Regulator IC 3 Output Step-Down (Buck) Synchronous (2), Linear (LDO) (1) 250kHz ~ 2MHz 36-PowerFSOP (0.295", 7.50mm Width) 制造商:stmicroelectronics 系列:- 包装:管件 零件状态:有效 拓扑:降压（降压）同步（2），线性（LDO）（1） 功能:任何功能 输出数:3 频率 - 开关:250kHz ~ 2MHz 电压/电流 - 输出 1:可编程，2.5A 电压/电流 - 输出 2:可编程，3A 电压/电流 - 输出 3:可编程，250mA 带 LED 驱动器:无 带监控器:无 带定序器:无 电压 - 电源:3.5 V ~ 26 V 工作温度:-40°C ~ 105°C 安装类型:表面贴装 封装/外壳:36-??FSOP（0.295"，7.50mm 宽） 供应商器件封装:36-PWRSSO EP 标准包装:49 |
| L5963Q-V0Y | 功能描述:IC REG BCK/LIN/SYNC TRPL 48VFQFN 制造商:stmicroelectronics 系列:- 包装:托盘 零件状态:在售 拓扑:降压同步（1），线性（LDO）（1） 功能:任何功能 输出数:3 频率 - 开关:250kHz ~ 2MHz 电压/电流 - 输出 1:可编程，2.5A 电压/电流 - 输出 2:可编程，3A 电压/电流 - 输出 3:可编程，250mA 带 LED 驱动器:无 带监控器:无 带定序器:无 电压 - 电源:3.5 V ~ 26 V 工作温度:-40°C ~ 105°C 安装类型:表面贴装 封装/外壳:48-TFQFN 裸露焊盘 供应商器件封装:48-VFQFPN（7x7） 标准包装:260 |
| L5970 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:UP TO 1A STEP DOWN SWITCHING REGULATOR |
| L5970AD | 功能描述:直流/直流开关调节器 4.4-36V 1A Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。