参数资料
型号: L6566BTR
厂商: STMICROELECTRONICS
元件分类: 稳压器
英文描述: 0.8 A POWER FACTOR CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16
封装: LEAD FREE, SOP-16
文件页数: 20/51页
文件大小: 624K
代理商: L6566BTR
L6566B
Application information
27/51
Figure 15.
Externally controlled burst-mode operation by driving pin COMP: timing
diagram
5.6
PWM comparator, PWM latch and voltage feedforward blocks
The PWM comparator senses the voltage across the current sense resistor Rs and, by
comparing it to the programming signal delivered by the feedforward block, determines the
exact time when the external MOSFET is to be switched off. Its output resets the PWM
latch, previously set by the oscillator or the ZCD triggering block, which will assert the gate
driver output low. The use of PWM latch avoids spurious switching of the MOSFET that
might result from the noise generated (“double-pulse suppression”).
Cycle-by-cycle current limitation is realized with a second comparator (OCP comparator)
that senses the voltage across the current sense resistor Rs as well and compares this
voltage to a reference value Vcsx. Its output is or-ed with that of the PWM comparator (see
the circuit schematic in Figure 17 on page 29). In this way, if the programming signal
delivered by the feedforward block and sent to the PWM comparator exceeds Vcsx, it will be
the OCP comparator to reset first the PWM latch instead of the PWM comparator. The value
of Vcsx, thereby, determines the overcurrent setpoint along with the sense resistor Rs.
The power that QR flyback converters with a fixed overcurrent setpoint (like fixed-frequency
systems) are able to deliver changes with the input voltage considerably. With wide-range
mains, at maximum line it can be more than twice the value at minimum line, as shown by
the upper curve in the diagram of Figure 16 on page 28. The device has the line feedforward
function available to solve this issue.
It acts on the overcurrent setpoint Vcsx, so that it is a function of the converter’s input voltage
Vin sensed through a dedicated pin (15, VFF): the higher the input voltage, the lower the
Vcc
(pin 5)
GD
(pin 4)
Vcc_OK
VccON
VccOFF
Vccrestart
Icharge
0.85 mA
Standby is commanded here
t
COMP
(pin 9)
t
Vout
相关PDF资料
PDF描述
L6706 SWITCHING REGULATOR, QCC40
L6717 DUAL SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, QCC48
L6728HTR SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
L6728H SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
L6728 1.5 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, DSO10
相关代理商/技术参数
参数描述
L6566BTR-CUT TAPE 制造商:ST 功能描述:L6566B Series 23 V 4.6 mA SMPS Multi-Mode Controller Surface Mount - SOIC-16N
L6567 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:HIGH VOLTAGE DRIVER FOR CFL
L6567D 制造商:STMicroelectronics 功能描述:CFL DRVR 18V 14SOP - Rail/Tube
L6569 功能描述:功率驱动器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
L6569 制造商:STMicroelectronics 功能描述:IC HALF BRIDGE+OSC 6569 DIP8