- 您现在的位置：买卖IC网 > PDF目录67754 > L6566BTR (STMICROELECTRONICS) 0.8 A POWER FACTOR CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | L6566BTR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 0.8 A POWER FACTOR CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | LEAD FREE, SOP-16 |
| 文件页数： | 29/51页 |
| 文件大小： | 624K |
| 代理商： | L6566BTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页
L6566B
Application information
35/51
5.11
OVP block
The OVP function of the L6566B monitors the voltage on the ZCD pin (11) in MOSFET’s
OFF-time, during which the voltage generated by the auxiliary winding tracks converter’s
output voltage. If the voltage on the pin exceeds an internal 5 V reference, a comparator is
triggered, an overvoltage condition is assumed and the device is shut down. An internal
current generator is activated that sources 1 mA out of the VFF pin (15). If the VFF voltage
is allowed to reach 2 Vbe over 5 V, the L6566B will be latched off. See Section 5.9: Latched
for more details on IC’s behavior under these conditions. If the
impedance externally connected to pin 15 is so low that the 5+2 VBE threshold cannot be
reached or if some means is provided to prevent that, the device will be able to restart after
the Vcc has dropped below 5 V. Refer to the “Application examples and Ideas” section
(Table7 on page45) for additional hints.
Figure 22.
OVP function: internal block diagram
The ZCD pin will be connected to the auxiliary winding through a resistor divider RZ1, RZ2
to:
Equation 13
where VoutOVP is the output voltage value that is to activate the protection, Ns the turn
number of the secondary winding and Naux the turn number of the auxiliary winding.
Fault
2-bit
counter
R Q1
S
Monostable
M1
STROBE
OVP
COUT
2s
0.5s
Monostable
M2
-
+
5 V
ZCD
Counter
reset
FF
40kΩ
5pF
PWM latch
Q
S
R
11
to triggering
block
L6566B
Naux
Ns
Vout
5
k
OVP
OVP =
相关PDF资料 |
PDF描述 |
|---|---|
| L6706 | SWITCHING REGULATOR, QCC40 |
| L6717 | DUAL SWITCHING CONTROLLER, 575 kHz SWITCHING FREQ-MAX, QCC48 |
| L6728HTR | SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10 |
| L6728H | SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10 |
| L6728 | 1.5 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, DSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6566BTR-CUT TAPE | 制造商:ST 功能描述:L6566B Series 23 V 4.6 mA SMPS Multi-Mode Controller Surface Mount - SOIC-16N |
| L6567 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:HIGH VOLTAGE DRIVER FOR CFL |
| L6567D | 制造商:STMicroelectronics 功能描述:CFL DRVR 18V 14SOP - Rail/Tube |
| L6569 | 功能描述:功率驱动器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| L6569 | 制造商:STMicroelectronics 功能描述:IC HALF BRIDGE+OSC 6569 DIP8 |
发布紧急采购，3分钟左右您将得到回复。