参数资料
型号: L6590N
厂商: STMICROELECTRONICS
元件分类: 稳压器
英文描述: 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDIP8
封装: MINI, DIP-8
文件页数: 9/23页
文件大小: 383K
代理商: L6590N
Obsolete
Product(s)
- Obsolete
Product(s)
17/23
L6590
Another problem is the spurious restarts that are likely to occur during converter power down if the input voltage
decays slowly (e.g. with a large input bulk capacitor) and that cause the output voltage not to decay to zero
monothonically.
Converter shutdown can be accomplished with the L6590D by means of an internal comparator that can be
used to sense the voltage across the input bulk capacitor. This comparator is internally referenced to 2.5V and
disables the PWM if the voltage applied at its non-inverting input, externally available, is below the reference.
PWM operation is re-enabled as the voltage at the pin is more than 2.5V.
The brownout comparator is provided with current hysteresis instead of a more usual voltage hysteresis: an in-
ternal 50 A current generator is ON as long as the voltage applied at the non-inverting input exceeds 2.5V and
is OFF if the voltage is below 2.5V. This approach provides an additional degree of freedom: it is possible to set
the ON threshold and the OFF threshold separately by properly choosing the resistors of the external divider,
which is not possible with voltage hysteresis.
Overvoltage Protection
The IC incorporates an Overvoltage Protection (OVP) that can be particularly useful to protect the converter and
the load against voltage feedback loop failures. This kind of failure causes the output voltage to rise with no
control and easily leads to the destruction of the load and of the converter itself if not properly handled.
If such an event occurs, the voltage generated by the auxiliary winding that supplies the IC will fly up tracking
the output voltage. An internal comparator continuously monitors the Vcc voltage and stops the operation of the
IC if the voltage exceeds 16.5 V. This condition is latched and maintained until the Vcc voltage falls below the
UVLO threshold. The converter will then operate intermittently.
Figure 36. OVP internal schematic
Overcurrent Protection
The device uses pulse-by-pulse current limiting for Overcurrent Protection (OCP), in order to prevent overstress
of the internal MOSFET: its current during the ON-time is monitored and, if it exceeds a determined value, the
conduction is terminated immediately. The MOSFET will be turned on again in the subsequent switching cycle.
As previously mentioned, the internal powerMOSFET has a SenseFET structure: the source of a few cells are
connected together and kept separate from the other source connections so as to realize a 1:100 current divider.
The "sense" portion is connected to a ground referenced, sense resistor having a low thermal coefficient. The
OCP comparator senses the voltage drop across the sense resistor and resets the PWM latch if the drop ex-
ceeds a threshold, thus turning off the MOSFET. In this way the overcurrent threshold is set at about 0.65 A
(typical value).
Vcc
DRAIN
+
-
to OVP
latch
GND
to
MOSFET
OVP
相关PDF资料
PDF描述
LM4040DIM7X-4.1/NOPB 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 4.096 V, PDSO5
LXM1618-12-42 SPECIALTY ANALOG CIRCUIT, XMA
LC020B3 DC-DC REG PWR SUPPLY MODULE
LTC4270CIUKG#PBF SPECIALTY ANALOG CIRCUIT, PQCC52
LTH2911HDDB-4#TRM POWER SUPPLY SUPPORT CKT, PDSO8
相关代理商/技术参数
参数描述
L6591 功能描述:开关变换器、稳压器与控制器 PWM CONTROLLER ZVS HALF-BRIDGE RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
L6591TR 功能描述:开关变换器、稳压器与控制器 PWM CONTROLLER ZVS HALF-BRIDGE RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
L6598 功能描述:PMIC 解决方案 High Volt Reson Cont RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
L6598_04 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:HIGH VOLTAGE RESONANT CONTROLLER
L6598D 功能描述:PMIC 解决方案 High Volt Reson Cont RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel