- 您现在的位置：买卖IC网 > PDF目录80106 > L6668 (STMICROELECTRONICS) 0.8 A SWITCHING CONTROLLER, 105 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | L6668 |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 0.8 A SWITCHING CONTROLLER, 105 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | LEAD FREE, SOP-16 |
| 文件页数： | 6/23页 |
| 文件大小： | 720K |
| 代理商： | L6668 |
L6668
14/23
At converter power-down the system will lose regulation as soon as the input voltage is so low that either
peak current or maximum duty cycle limitation is tripped. Vcc will then drop and stop IC activity as it falls
below the UVLO threshold (8.7V typ.).
The Vcc_OK signal is de-asserted as the Vcc voltage goes below a threshold Vccrestart located at about
5V. The HV generator can now restart but, if Vin < Vinstart, as shown in figure 36, HV_EN is de-asserted
too and the HV generator is disabled.
This prevents converter's re-start attempts and ensures monotonic output voltage decay at power-down.
The low restart threshold Vccrestart ensures that, during short circuits, the restart attempts of the L6668 will
have a very low repetition rate, as shown in the timing diagram of figure 37, and that the converter will
work safely with extremely low power throughput.
4.2 Frequency Foldback Block and operation at medium/light load
At heavy load, namely as the voltage on pin COMP (VCOMP) is higher than 3V, the device works at a fixed
frequency like a standard current mode PWM controller.
As the load is reduced, and the VCOMP voltage falls below 3V (approximately corresponding to 50% of the
maximum load in a fully DCM system), the oscillator frequency can be made dependent on converter's
load conditions - the lower the load, the lower the frequency and vice versa.
Figure 38. Frequency foldback function: oscillator frequency is a function of COMP voltage
This is done by adding an external resistor RSTBY between pins RCT (#16) and STBY (#13), which acti-
vates the circuit shown in figure 38.
When VCOMP is below 3 V (oscillator's peak voltage) the voltage on the STBY pin, which is internally con-
nected to a current sink, tracks VCOMP and then some of the current that charges CT is diverted to ground
through the STBY pin.
In this way the rate of rise of the voltage across CT is slowed down and the oscillator frequency decreased,
the lower VCOMP the lower the frequency. Instead, when VCOMP is greater than 3 V the STBY pin features
high impedance and the oscillator frequency fosc will be determined by RT and CT. These components can
be then calculated as it is usually done with this type of oscillator:
VCOMP
fosc
1.4
3.0
4.4
RSTBY
3.0V
-
+
RSTBY
L6668
CT
RT
Vref
13
16
8
STBY
COMP
RCT
OSCILLATOR
VCOMP
fosc
1.4
3.0
4.4
RSTBY
3.0V
-
+
RSTBY
L6668
CT
RT
Vref
13
16
8
STBY
COMP
RCT
OSCILLATOR
R
T CT
1.4
f
os c
---------
=
相关PDF资料 |
PDF描述 |
|---|---|
| LM3668SDX-3.3/NOPB | 2.05 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, DSO12 |
| LTC3851AIMSE-1#PBF | 0.05 A SWITCHING CONTROLLER, 810 kHz SWITCHING FREQ-MAX, PDSO16 |
| LM4040BEX3-5.0+T | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, PDSO3 |
| LNK304DG-TL | 0.4 A SWITCHING REGULATOR, 70 kHz SWITCHING FREQ-MAX, PDSO8 |
| LS5320-9PD9T | 2-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6668_06 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:SMART PRIMARY CONTROLLER |
| L6668B2 | 功能描述:电流型 PWM 控制器 POWER SUPPLY RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| L6668TR | 功能描述:电流型 PWM 控制器 SMART CONTROLLER RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| L667 | 制造商:BURNDY 功能描述:L-DIE |
| L-667 | 制造商:RHOMBUS-IND 制造商全称:Rhombus Industries Inc. 功能描述:Common Mode Inductor For DC/DC Power supply |
发布紧急采购，3分钟左右您将得到回复。