- 您现在的位置：买卖IC网 > PDF目录80037 > L6726ATR (STMICROELECTRONICS) 1.5 A SWITCHING CONTROLLER, 297 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | L6726ATR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 1.5 A SWITCHING CONTROLLER, 297 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | SOP-8 |
| 文件页数： | 15/35页 |
| 文件大小： | 986K |
| 代理商： | L6726ATR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页
Application Information
L6726A
22/35
Doc ID 12754 Rev 4
9.2
Output capacitors
Output capacitors choice depends on the application constraints in point of output voltage
ripple and output voltage deviation during a load transient.
During steady-state conditions, the output voltage ripple is influenced by ESR and
capacitance of the output capacitors as follows:
Where
ΔI
L is the inductor current ripple. These contribution are not in phase, so total ripple
will be lower than the sum of their moduli. Even ESL and board parasitic inductance can
contribute significantly to output ripple.
During a load variation, the output capacitors supply to the load the additional current or
absorb the current in excess delivered by the inductor until converter reaction is completed.
In fact, even if the controller react immediately to the load transient saturating the duty cycle
to 80% or 0%, the current slew rate is limited by the inductance. At first approximation,
output voltage drop, based on ESR and capacitor charge/discharge and considering an
ideal load-step, can be estimated as follows:
Where
ΔV
L is the voltage applied to the inductor during the transient (
for
the load appliance or VOUT for the load removal).
MLCC capacitors typically have low ESR to minimize the ripple but also have low
capacitance that do not minimize the capacitive voltage deviation during load transient. On
the contrary, electrolytic capacitors usually have higher capacitance to minimize capacitive
voltage deviation during load transient, but also higher ESR value resulting in higher ripple
voltage and resistive voltage drop. For these reasons, a mix between electrolytic and MLCC
capacitor is usually suggested to minimize ripple as well as reducing voltage deviation in
dynamic conditions.
9.3
Input capacitors
The input capacitor bank is designed mainly to stand input rms current, which depends on
output current (IOUT) and duty-cycle (D) for the regulation as follows:
The equation reaches its maximum value, IOUT/2, when D = 0.5. Losses depend on input
capacitor ESR:
ΔV
OUT_ESR
ΔI
L
ESR
=
ΔV
OUT_C
ΔI
L
1
8C
OUT
F
SW
---------------------------------------
=
ΔV
OUT_ESR
ΔI
OUT
ESR
=
ΔV
OUT_C
L
ΔI
OUT
2
2C
OUT
ΔV
L
--------------------------------------
=
D
MAX
V
IN
V
OUT
–
I
rms
I
OUT
D1
D
–
()
=
PESR I
rms
2
=
相关PDF资料 |
PDF描述 |
|---|---|
| LH0070-0H/883C | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, MBCY3 |
| LQD30A48-3V3-1V8RA | 2-OUTPUT 76.5 W DC-DC REG PWR SUPPLY MODULE |
| LSN-1.2/10-D3B | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| LS4301-7ERD7TB1 | 1-OUTPUT 100 W AC-DC PWR FACTOR CORR MODULE |
| LM3705XBMM-463/NOPB | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6726-D18-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:UNIVERSAL SPEECH CIRCUIT |
| L6726G-D18-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:UNIVERSAL SPEECH CIRCUIT |
| L6726G-S18-R | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:UNIVERSAL SPEECH CIRCUIT |
| L6726G-S18-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:UNIVERSAL SPEECH CIRCUIT |
| L6726L-D18-T | 制造商:UTC-IC 制造商全称:UTC-IC 功能描述:UNIVERSAL SPEECH CIRCUIT |
发布紧急采购，3分钟左右您将得到回复。