- 您现在的位置：买卖IC网 > PDF目录44548 > LM2577NADJ (NATIONAL SEMICONDUCTOR CORP) 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PDIP24 PDF资料下载
参数资料
| 型号： | LM2577NADJ |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PDIP24 |
| 封装： | 0.300 INCH, PLASTIC, DIP-16 |
| 文件页数： | 14/31页 |
| 文件大小： | 1406K |
| 代理商： | LM2577NADJ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
Application Hints (Continued)
FLYBACK REGULATOR
A Flyback regulator can produce single or multiple output
voltages that are lower or greater than the input supply
voltage. Figure 18 shows the LM1577/LM2577 used as a
flyback regulator with positive and negative regulated out-
puts. Its operation is similar to a step-up regulator, except the
output switch contols the primary current of a flyback trans-
former. Note that the primary and secondary windings are
out of phase, so no current flows through secondary when
current flows through the primary. This allows the primary to
charge up the transformer core when the switch is on. When
the switch turns off, the core discharges by sending current
through the secondary, and this produces voltage at the
outputs. The output voltages are controlled by adjusting the
peak primary current, as described in the step-up regulator
section.
Voltage and current waveforms for this circuit are shown in
Figure 17, and formulas for calculating them are given in
FLYBACK REGULATOR DESIGN PROCEDURE
1. Transformer Selection
A family of standardized flyback transformers is available for
creating flyback regulators that produce dual output volt-
20lists these transformers with the input voltage, output
voltages and maximum load current they are designed for.
2. Compensation Network (C
C,RC) and
Output Capacitor (C
OUT) Selection
As explained in the Step-Up Regulator Design Procedure,
C
C,RC and COUT must be selected as a group. The following
procedure is for a dual output flyback regulator with equal
turns ratios for each secondary (i.e., both output voltages
have the same magnitude). The equations can be used for a
single output regulator by changing
∑I
LOAD(max) to ILOAD(max)
in the following equations.
A. First, calculate the maximum value for R
C.
Where
∑I
LOAD(max) is the sum of the load current (magni-
tude) required from both outputs. Select a resistor less than
or equal to this value, and no greater than 3 k
.
B. Calculate the minimum value for
∑C
OUT (sum of COUT
at both outputs) using the following two equations.
The larger of these two values must be used to ensure
regulator stability.
01146817
FIGURE 17. Flyback Regulator Waveforms
LM1577/LM2577
www.national.com
21
相关PDF资料 |
PDF描述 |
|---|---|
| LM2577S-15/NOPB | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PSSO5 |
| LM2577SADJ | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PSSO5 |
| LM2577S-12X | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PSSO5 |
| LM2577TADJFLOWLB03 | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PZFM5 |
| LM2578MWC | 0.75 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, UUC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM2577N-ADJ | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2577N-ADJ/NOPB | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2577S-12 | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2577S-12/NOPB | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2577S-12/NOPB | 制造商:Texas Instruments 功能描述:DC/DC Converter IC |
发布紧急采购，3分钟左右您将得到回复。