- 您现在的位置：买卖IC网 > PDF目录80008 > LM2592HV3.3MWC (NATIONAL SEMICONDUCTOR CORP) 4 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, UUC PDF资料下载
参数资料
| 型号： | LM2592HV3.3MWC |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 4 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, UUC |
| 封装： | WAFER |
| 文件页数： | 9/24页 |
| 文件大小： | 720K |
| 代理商： | LM2592HV3.3MWC |
Application Information (Continued)
Because of differences in the operation of the inverting
regulator, the standard design procedure is not used to
select the inductor value. In the majority of designs, a 33 H,
4A inductor is the best choice. Capacitor selection can also
be narrowed down to just a few values.
This type of inverting regulator can require relatively large
amounts of input current when starting up, even with light
loads. Input currents as high as the LM2592HV current limit
(approx 4A) are needed for at least 2 ms or more, until the
output reaches its nominal output voltage. The actual time
depends on the output voltage and the size of the output
capacitor. Input power sources that are current limited or
sources that can not deliver these currents without getting
loaded down, may not work correctly. Because of the rela-
tively high startup currents required by the inverting topology,
the delayed startup feature (C1, R
11 is recommended. By delaying the regulator startup, the
input capacitor is allowed to charge up to a higher voltage
before the switcher begins operating. A portion of the high
input current needed for startup is now supplied by the input
capacitor (C
IN). For severe start up conditions, the input
capacitor can be made much larger than normal.
lNVERTING REGULATOR SHUTDOWN METHODS
To use the ON /OFF pin in a standard buck configuration is
simple, pull it below 1.3V (@25C, referenced to ground) to
turn regulator ON, pull it above 1.3V to shut the regulator
OFF. With the inverting configuration, some level shifting is
required, because the ground pin of the regulator is no
longer at ground, but is now setting at the negative output
voltage level. Two different shutdown methods for inverting
regulators are shown in
THERMAL CONSIDERATIONS
The LM2592HV is available in two packages, a 5-pin TO-220
(T) and a 5-pin surface mount TO-263 (S).
The TO-220 package needs a heat sink under most condi-
tions. The size of the heatsink depends on the input voltage,
the output voltage, the load current and the ambient tem-
perature. Higher ambient temperatures require more heat
sinking.
The TO-263 surface mount package tab is designed to be
soldered to the copper on a printed circuit board. The copper
and the board are the heat sink for this package and the
other heat producing components, such as the catch diode
and inductor. The PC board copper area that the package is
soldered to should be at least 0.4 in
2, and ideally should
have 2 or more square inches of 2 oz. (0.0028) in) copper.
Additional copper area improves the thermal characteristics,
but with copper areas greater than approximately 6 in
2, only
small improvements in heat dissipation are realized. If fur-
ther thermal improvements are needed, double sided, mul-
tilayer PC board with large copper areas and/or airflow are
recommended.
The curves shown in
Figure 14 show the LM2592HVS
(TO-263 package) junction temperature rise above ambient
temperature with a 2A load for various input and output
voltages. This data was taken with the circuit operating as a
buck switching regulator with all components mounted on a
10129442
FIGURE 12. Inverting Regulator Ground Referenced Shutdown
10129486
FIGURE 13. Inverting Regulator Ground Referenced Shutdown using Opto Device
LM2592HV
www.national.com
17
相关PDF资料 |
PDF描述 |
|---|---|
| LM3724E2.32MDC | 1-CHANNEL POWER SUPPLY SUPPORT CKT, UUC |
| LT4356HS-1#TR | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| LT4356IS-2 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| LMC28SP | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| LMA5S | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM2592HVS-3.3 | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2592HVS-3.3/NOPB | 功能描述:直流/直流开关转换器 PWR CONVERTER 150KHz 2A ST-DOWN VLTG REG RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2592HVS-5.0 | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2592HVS-5.0/NOPB | 功能描述:直流/直流开关转换器 PWR CONVERTER 150KHz 2A ST-DOWN VLTG REG RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2592HVS-5.0/NOPB | 制造商:Texas Instruments 功能描述:DC/DC Converter (DC-DC) / Switching Regu |
发布紧急采购，3分钟左右您将得到回复。