- 您现在的位置：买卖IC网 > PDF目录14440 > LM2596TVADJG (ON Semiconductor)IC REG BUCK ADJ 3A TO220-5 PDF资料下载
参数资料
| 型号： | LM2596TVADJG |
| 厂商： | ON Semiconductor |
| 文件页数： | 19/25页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A TO220-5 |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.23 V ~ 37 V |
| 输入电压： | 4.5 V ~ 40 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 150kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-5 成形引线 |
| 包装： | 管件 |
| 供应商设备封装： | TO-220-5 |
| 其它名称： | LM2596TVADJG-ND LM2596TVADJGOS |
LM2596
+V in
+V in
1
LM2596 ? XX
+V
0
On
Off
R2
Shutdown
Input
5.0 V
0
On
Off
Shutdown
Input
R3
470
C in R1
100 m F 47 k
5
ON/OFF 3
R2
GN
D
+V in
5.6 k
C in
100 m F
Q1
+V in
1
LM2596 ? XX
47 k
2N3906
5
ON/OFF 3
GN
-V out
D
MOC8101
R1
12 k
-V out
NOTE: This picture does not show the complete circuit.
Figure 24. Inverting Buck ? Boost Regulator Shutdown
Circuit Using an Optocoupler
With the inverting configuration, the use of the ON/OFF
pin requires some level shifting techniques. This is caused
by the fact, that the ground pin of the converter IC is no
longer at ground. Now, the ON/OFF pin threshold voltage
(1.3 V approximately) has to be related to the negative
output voltage level. There are many different possible shut
down methods, two of them are shown in Figures 24 and 25.
NOTE: This picture does not show the complete circuit.
Figure 25. Inverting Buck ? Boost Regulator Shutdown
Circuit Using a PNP Transistor
Negative Boost Regulator
This example is a variation of the buck ? boost topology
and it is called negative boost regulator. This regulator
experiences relatively high switch current, especially at low
input voltages. The internal switch current limiting results in
lower output load current capability.
The circuit in Figure 26 shows the negative boost
configuration. The input voltage in this application ranges
from ? 5.0 V to ? 12 V and provides a regulated ? 12 V output.
If the input voltage is greater than ? 12 V, the output will rise
above ? 12 V accordingly, but will not damage the regulator.
R4
Feedback
C out
470 m F
+V in
LM2596 ? ADJ
C in
100 m F/
50 V
ON/OFF
GND
D1
1N5822
R3
? 12 V @ 0.7 A
Regulated
Output
? 12 V
Unregulated
DC Input
L1
33 m H
Figure 26. Negative Boost Regulator
Design Recommendations:
The same design rules as for the previous inverting
buck ? boost converter can be applied. The output capacitor
C out must be chosen larger than would be required for a what
standard buck converter. Low input voltages or high output
currents require a large value output capacitor (in the range
of thousands of m F). The recommended range of inductor
values for the negative boost regulator is the same as for
inverting converter design.
Another important point is that these negative boost
converters cannot provide current limiting load protection in
the event of a short in the output so some other means, such
as a fuse, may be necessary to provide the load protection.
http://onsemi.com
19
相关PDF资料 |
PDF描述 |
|---|---|
| LQG15HN18NJ02D | INDUCTOR 18NH 300MA 0402 |
| LQG15HN15NJ02D | INDUCTOR 15NH 300MA 0402 |
| LM2574DW-ADJR2G | IC REG BUCK ADJ 0.5A 16SOICW |
| LM2574N-3.3G | IC REG BUCK 3.3V 0.5A 8DIP |
| LQG15HN12NJ02D | INDUCTOR 12NH 300MA 0402 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM2597HVM-12 | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2597HVM-12/NOPB | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2597HVM-12/NOPB | 制造商:Texas Instruments 功能描述:DC/DC Converter IC |
| LM2597HVM-3.3 | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| LM2597HVM-3.3/NOPB | 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。