- 您现在的位置：买卖IC网 > PDF目录44552 > LM3370TLX-2613/NOPB (NATIONAL SEMICONDUCTOR CORP) 1.4 A DUAL SWITCHING CONTROLLER, 2400 kHz SWITCHING FREQ-MAX, PBGA20 PDF资料下载
参数资料
| 型号： | LM3370TLX-2613/NOPB |
| 厂商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1.4 A DUAL SWITCHING CONTROLLER, 2400 kHz SWITCHING FREQ-MAX, PBGA20 |
| 封装： | 3 X 2 MM, 0.60 MM HEIGHT, 0.50 MM PITCH, , MO-211DG, MICRO, SMD-20 |
| 文件页数： | 15/26页 |
| 文件大小： | 5436K |
| 代理商： | LM3370TLX-2613/NOPB |
bias characteristics vary from manufacturer to manufacturer
and dc bias curves should be requested from them as part of
the capacitor selection process.
The output filter capacitor smooths out current flow from the
inductor to the load, helps maintain a steady output voltage
during transient load changes and reduces output voltage
ripple. These capacitors must be selected with sufficient ca-
pacitance and sufficiently low ESR to perform these functions.
The output ripple voltage can be calculated as:
Voltage peak-to-peak ripple due to capacitance =
Voltage peak-to-peak ripple due to ESR = V
PP-ESR = IPP*RESR
Voltage peak-to-peak ripple, root mean squared =
Note that the output ripple is dependent on the current ripple
and the equivalent series resistance of the output capacitor
(R
ESR). The RESR is frequency dependent (as well as temper-
ature dependent); make sure that the frequency of the R
ESR
given is the same order of magnitude as the switching fre-
quency.
TABLE 3. Suggested Capacitors and Their Suppliers
Model
Description
Case
Size
Vendor
4.7 F for C
IN
C1608X5R0J475
Ceramic, X5R,
6.3V Rating
0603
TDK
C2012X5R0J475
Ceramic, X5R,
6.3V Rating
0805
JMK212BJ475
Ceramic, X5R,
6.3V Rating
0805
Taiyo
Yuden
GRM21BR60J475
Ceramic, X5R,
6.3V Rating
0805
muRata
GRM219R60J-
475KE19D
Ceramic, X5R,
6.3V Rating
0805
(Thin)
<1mm
Height
10F C
OUT
C2012X5R0J106
Ceramic, X5R,
6.3V Rating
0805
TDK
JMK212BJ106
Ceramic, X5R,
6.3V Rating
0805
Taiyo
Yuden
GRM21BR60J106
Ceramic, X5R,
6.3V Rating
0805
muRata
GRM219R60J-
106KE19D
Ceramic, X5R,
6.3V Rating
0805
(Thin)
< 1mm
Height
POR (POWER ON RESET)
The LM3370 has an independent POR functions (nPOR) for
each buck converter. The nPOR1 and nPOR2 are open drain
circuits which pull low when the outputs are below 94% (rising
V
OUT) or 85% (falling VOUT) of the desire output. The inherent
delay between the output (at 94% of V
OUT) to the time at which
the nPOR is enabled is about 50 ms. A pullup resistor of 100
k
at nPOR pin is required. Please refer to the electrical
specification table for other timing options. The diagram be-
low illustrates the timing response of the POR function.
20167319
SPREAD SPECTRUM (SS)
The LM3370 features Spread Spectrum capability, via I2C, to
reduce the noise amplitude of the switching frequency during
data transmission. The feature can be enabled by activating
the appropriate control register bit (see register information
section for detail). The main clock of the LM3370 features
spread spectrum at F
OSC = 2 MHz ± 22 kHz ( peak frequency
deviation) with the modulation frequency of either 1 kHz (de-
fault) or 2 kHz via I2C. This help reduce noise caused by the
harmonics present in the waveforms at the switch pins of the
buck regulators. It is controlled by I2C in the following manner:
I2C bit
Modulation Frequency
SS_fmod = 1 (default)
1 kHz
SS_fmod = 0
2 kHz
BOARD LAYOUT CONSIDERATIONS
PC board layout is an important part of DC-DC converter de-
sign. Poor board layout can disrupt the performance of a DC-
DC converter and surrounding circuitry by contributing to EMI,
ground bounce, and resistive voltage loss in the traces. These
can send erroneous signals to the DC-DC converter IC, re-
sulting in poor regulation or instability.
Good layout for the LM3370 can be implemented by following
a few simple design rules:
1.
Place the LM3370, inductor and filter capacitors close
together and make the traces short. The traces between
these components carry relatively high switching
currents and act as antennas. Following this rule reduces
radiated noise. Place the capacitors and inductor within
0.2 in. (5mm) of the LM3370.
2.
Arrange the components so that the switching current
loops curl in the same direction. During the first half of
each cycle, current flows from the input filter capacitor,
through the LM3370 and inductor to the output filter
capacitor and back through ground, forming a current
loop. In the second half of each cycle, current is pulled
up from ground, through the LM3370 by the inductor, to
the output filter capacitor and then back through ground,
forming a second current loop. Routing these loops so
the current curls in the same direction prevents magnetic
field reversal between the two half-cycles and reduces
radiated noise.
3.
Connect the ground pins of the LM3370, and filter
capacitors together using generous component-side
www.national.com
22
LM3370
相关PDF资料 |
PDF描述 |
|---|---|
| LM3370TL-2613/NOPB | 1.4 A DUAL SWITCHING CONTROLLER, 2400 kHz SWITCHING FREQ-MAX, PBGA20 |
| LM3420A12.6MDA | 1-CHANNEL POWER SUPPLY SUPPORT CKT, UUC |
| LM3420A-8.2MWA | 1-CHANNEL POWER SUPPLY SUPPORT CKT, UUC |
| LM3420A-4.2MWA | 1-CHANNEL POWER SUPPLY SUPPORT CKT, UUC |
| LM3420A-4.2MDA | 1-CHANNEL POWER SUPPLY SUPPORT CKT, UUC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LM3370TLX-3006 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Dual Synchronous Step-Down DC-DC Converter with Dynamic Voltage Scaling Function |
| LM3370TLX-3006/NOPB | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| LM3370TLX-3008 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Dual Synchronous Step-Down DC-DC Converter with Dynamic Voltage Scaling Function |
| LM3370TLX-3008/NOPB | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| LM3370TLX-3022 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Dual Synchronous Step-Down DC-DC Converter with Dynamic Voltage Scaling Function |
发布紧急采购，3分钟左右您将得到回复。