参数资料
型号: LM75BD,112
厂商: NXP Semiconductors
文件页数: 1/37页
文件大小: 520K
描述: IC TEMP SENSOR DIGITAL 8-SOIC
特色产品: Digital Temperature Sensor / Thermal Watchdog
标准包装: 100
功能: 温度监视系统(传感器),监视器
传感器类型: 内部
感应温度: -55°C ~ 125°C
精确度: ±3°C(最小值)
拓扑: ADC(三角积分型),比较器,振荡器,寄存器库
输出类型: 2 线串行,I²C?
输出警报:
输出风扇:
电源电压: 2.8 V ~ 5.5 V
工作温度: -55°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SO
包装: 管件
其它名称: 935285837112
LM75BD
LM75BD-ND
 
1.   General description
The LM75B is a temperature-to-digital converter using an on-chip band gap temperature
sensor and Sigma-Delta A-to-D conversion technique with an overtemperature detection
output. The LM75B contains a number of data registers: Configuration register (Conf) to
store the device settings such as device operation mode, OS operation mode, OS polarity
and OS fault queue as described in Section 7 
Functional description

; temperature
register (Temp) to store the digital temp reading, and set-point registers (Tos and Thyst) to
store programmable overtemperature shutdown and hysteresis limits, that can be
communicated by a controller via the 2-wire serial I
2
C-bus interface. The device also
includes an open-drain output (OS) which becomes active when the temperature exceeds
the programmed limits. There are three selectable logic address pins so that eight devices
can be connected on the same bus without address conflict.
The LM75B can be configured for different operation conditions. It can be set in normal
mode to periodically monitor the ambient temperature, or in shutdown mode to minimize
power consumption. The OS output operates in either of two selectable modes:
OS comparator mode or OS interrupt mode. Its active state can be selected as either
HIGH or LOW. The fault queue that defines the number of consecutive faults in order to
activate the OS output is programmable as well as the set-point limits.
The temperature register always stores an 11-bit twos complement data giving a
temperature resolution of 0.125 癈. This high temperature resolution is particularly useful
in applications of measuring precisely the thermal drift or runaway. When the LM75B is
accessed the conversion in process is not interrupted (that is, the I
2
C-bus section is totally
independent of the Sigma-Delta converter section) and accessing the LM75B
continuously without waiting at least one conversion time between communications will
not prevent the device from updating the Temp register with a new conversion result. The
new conversion result will be available immediately after the Temp register is updated.
The LM75B powers up in the normal operation mode with the OS in comparator mode,
temperature threshold of 80 癈 and hysteresis of 75 癈, so that it can be used as a
stand-alone thermostat with those pre-defined temperature set points.
2.   Features and benefits
n  Pin-for-pin replacement for industry standard LM75 and LM75A and offers improved 
temperature resolution of 0.125 癈 and specification of a single part over power supply
range from 2.8 V to 5.5 V
n  I
2
C-bus interface with up to 8 devices on the same bus
n  Power supply range from 2.8 V to 5.5 V
n  Temperatures range from -55 ?/SPAN>C to +125 ?/SPAN>C
LM75B
Digital temperature sensor and thermal watchdog
Rev. 5  22 January 2014
Product data sheet
相关PDF资料
PDF描述
LM75BIMX-5+ IC TEMP SENSOR WATCHDOG 8SOIC
LM92CIMX/NOPB IC SENSOR TEMP/THERM COMP 8-SOIC
LT1123CST#TRPBF IC REG CTRLR SGL 5V SOT223
LT1248IS#PBF IC PFC CTRLR AVERAGE CURR 16SOIC
LT1249IS8#PBF IC PFC CTRLR AVERAGE CURR 8SOIC
相关代理商/技术参数
参数描述
LM75BDP 制造商:NXP Semiconductors 功能描述:IC TEMP SENSOR DIGITAL 8-TSSOP 制造商:NXP Semiconductors 功能描述:IC, TEMP SENSOR, DIGITAL, 8-TSSOP
LM75BDP,118 功能描述:板上安装温度传感器 I2C LOCAL +/- 20C TS DIGITAL TEMP SENSOR RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
LM75BDP,118-CUT TAPE 制造商:NXP 功能描述:LM75 Series Digital Temperature Sensor/Thermal Watchdog Surface Mount- TSSOP - 8
LM75BDP/DG,118 功能描述:板上安装温度传感器 DIGITAL TEMP SENSOR AND THERMAL WATCHDOG RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
LM75BDP118 制造商:NXP Semiconductors 功能描述:DIGITAL TEMP SENSOR IC 11BIT +/-3C TS