- 您现在的位置：买卖IC网 > PDF目录3801 > LPC1311FHN33,551 (NXP Semiconductors)IC MCU 32BIT 8KB FLASH 33HVQFN PDF资料下载
参数资料
| 型号： | LPC1311FHN33,551 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 19/74页 |
| 文件大小： | 0K |
| 描述： | IC MCU 32BIT 8KB FLASH 33HVQFN |
| 产品培训模块： | LPCXpresso |
| 特色产品： | LPC1300 Series Cortex-M3 MCUs |
| 标准包装： | 260 |
| 系列： | LPC13xx |
| 核心处理器： | ARM? Cortex?-M3 |
| 芯体尺寸： | 32-位 |
| 速度： | 72MHz |
| 连通性： | I²C，Microwire，SPI，SSI，UART/USART |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 28 |
| 程序存储器容量： | 8KB（8K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 4K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 33-VQFN 裸露焊盘，33-HVQFN，33-SQFN，33-DHVQFN |
| 包装： | 托盘 |
| 配用： | 622-1005-ND - USB IN-CIRCUIT PROG ARM7 LPC2K |
| 其它名称： | 568-4915 935289654551 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页
LPC1311_13_42_43
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2012. All rights reserved.
Product data sheet
Rev. 5 — 6 June 2012
26 of 74
NXP Semiconductors
LPC1311/13/42/43
32-bit ARM Cortex-M3 microcontroller
Upon power-up, any chip reset, or wake-up from Deep power-down mode, the
LPC1311/13/42/43 use the IRC as the clock source. Software may later switch to one of
the other available clock sources.
7.18.1.2
System oscillator
The system oscillator can be used as the clock source for the CPU, with or without using
the PLL. On the LPC1342/43, the system oscillator must be used to provide the clock
source to USB.
The system oscillator operates at frequencies of 1 MHz to 25 MHz. This frequency can be
boosted to a higher frequency, up to the maximum CPU operating frequency, by the
system PLL.
7.18.1.3
Watchdog oscillator
The watchdog oscillator can be used as a clock source that directly drives the CPU, the
watchdog timer, or the CLKOUT pin. The watchdog oscillator nominal frequency is
programmable between 7.8 kHz and 1.7 MHz. The frequency spread over processing and
temperature is
±40 % (see also Table 16).
7.18.2 System PLL and USB PLL
The LPC1342/43 contain a system PLL and a dedicated PLL for generating the 48 MHz
USB clock. The LPC131x contain the system PLL only. The system and USB PLLs are
identical.
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up to a high frequency with a Current Controlled Oscillator (CCO).
The multiplier can be an integer value from 1 to 32. The CCO operates in the range of
156 MHz to 320 MHz, so there is an additional divider in the loop to keep the CCO within
its frequency range while the PLL is providing the desired output frequency. The output
divider may be set to divide by 2, 4, 8, or 16 to produce the output clock. The PLL output
frequency must be lower than 100 MHz. Since the minimum output divider value is 2, it is
insured that the PLL output has a 50 % duty cycle. The PLL is turned off and bypassed
following a chip reset and may be enabled by software. The program must configure and
activate the PLL, wait for the PLL to lock, and then connect to the PLL as a clock source.
The PLL settling time is 100
μs.
7.18.3 Clock output
The LPC1311/13/42/43 features a clock output function that routes the IRC oscillator, the
system oscillator, the watchdog oscillator, or the main clock to an output pin.
7.18.4 Wake-up process
The LPC1311/13/42/43 begin operation at power-up and when awakened from Deep
power-down mode by using the 12 MHz IRC oscillator as the clock source. This allows
chip operation to resume quickly. If the main oscillator or the PLL is needed by the
application, software will need to enable these features and wait for them to stabilize
before they are used as a clock source.
相关PDF资料 |
PDF描述 |
|---|---|
| C8051F332-GM | IC 8051 MCU 4KB FLASH 20QFN |
| C8051F300-GM | IC 8051 MCU 8K FLASH 11QFN |
| USB-B1SMHSW6 | CONN USB TYPE B R/A HORIZ SMD |
| USB-A2VSW6 | CONN USB TYPE A DUAL VERTICAL |
| 5788336-1 | CONN USB VERT B RCPT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LPC1313 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 microcontroller; up to 32 kB flash and 8 kB SRAM; USB device |
| LPC1313FBD48 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT 32K FLASH CORTEX-M3 48LQFP 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, 32K FLASH, CORTEX-M3, 48LQFP |
| LPC1313FBD48,151 | 功能描述:ARM微控制器 - MCU Cortex-M0 32 kB fl MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| LPC1313FBD48/01 | 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, CORTEX-M3, 72MHZ, LQFP-48 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, CORTEX-M3, 72MHZ, LQFP-48, Controller Family/Series:LPC1300, Core Si 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, CORTEX-M3, 72MHZ, LQFP-48, Controller Family/Series:LPC1300, Core Size:32bit, No. of I/O's:42, Supply Voltage Min:2V, Supply Voltage Max:3.6V, Digital IC Case Style:LQFP, No. of Pins:48, Program Memory Size:32KB, RAM |
| LPC1313FBD48/01,15 | 功能描述:ARM微控制器 - MCU CORTEX-M3 32 KB FL 8 KB SRAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。