- 您现在的位置：买卖IC网 > PDF目录1932 > LPC2106FBD48,151 (NXP Semiconductors)IC ARM7 MCU FLASH 128K 48-LQFP PDF资料下载
参数资料
| 型号： | LPC2106FBD48,151 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 14/41页 |
| 文件大小： | 0K |
| 描述： | IC ARM7 MCU FLASH 128K 48-LQFP |
| 标准包装： | 250 |
| 系列： | LPC2100 |
| 核心处理器： | ARM7 |
| 芯体尺寸： | 16/32-位 |
| 速度： | 60MHz |
| 连通性： | I²C，Microwire，SPI，SSI，SSP，UART/USART |
| 外围设备： | POR，PWM，WDT |
| 输入/输出数： | 32 |
| 程序存储器容量： | 128KB（128K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 64K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.65 V ~ 3.6 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 48-LQFP |
| 包装： | 托盘 |
| 配用： | 622-1019-ND - BOARD FOR LPC2106 48-LQFP 622-1008-ND - BOARD FOR LPC9103 10-HVSON 568-1756-ND - BOARD EVAL FOR LPC210X ARM MCU |
| 其它名称： | 568-1890 935275298151 LPC2106FBD48-S |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页
LPC2104_2105_2106_7
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 07 — 20 June 2008
21 of 41
NXP Semiconductors
LPC2104/2105/2106
Single-chip 32-bit microcontrollers
With double edge controlled PWM outputs, specic match registers control the rising and
falling edge of the output. This allows both positive going PWM pulses (when the rising
edge occurs prior to the falling edge), and negative going PWM pulses (when the falling
edge occurs prior to the rising edge).
6.17.1 Features
Seven match registers allow up to six single edge controlled or three double edge
controlled PWM outputs, or a mix of both types.
The match registers also allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Supports single edge controlled and/or double edge controlled PWM outputs. Single
edge controlled PWM outputs all go HIGH at the beginning of each cycle unless the
output is a constant LOW. Double edge controlled PWM outputs can have either edge
occur at any position within a cycle. This allows for both positive going and negative
going pulses.
Pulse period and width can be any number of timer counts. This allows complete
exibility in the trade-off between resolution and repetition rate. All PWM outputs will
occur at the same repetition rate.
Double edge controlled PWM outputs can be programmed to be either positive going
or negative going pulses.
Match register updates are synchronized with pulse outputs to prevent generation of
erroneous pulses. Software must “release” new match values before they can become
effective.
May be used as a standard timer if the PWM mode is not enabled.
A 32-bit Timer/Counter with a programmable 32-bit Prescaler.
6.18 System control
6.18.1 Crystal oscillator
The oscillator supports crystals in the range of 1 MHz to 25 MHz. The oscillator output
frequency is called FOSC and the ARM processor clock frequency is referred to as CCLK
for purposes of rate equations, etc. FOSC and CCLK are the same value unless the PLL
is running and connected. Refer to Section 6.18.2 “PLL” for additional information.
6.18.2 PLL
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up into the range of 10 MHz to 60 MHz with a Current Controlled
Oscillator (CCO). The multiplier can be an integer value from 1 to 32 (in practice, the
multiplier value cannot be higher than 6 on this family of microcontrollers due to the upper
frequency limit of the CPU). The CCO operates in the range of 156 MHz to 320 MHz, so
there is an additional divider in the loop to keep the CCO within its frequency range while
the PLL is providing the desired output frequency. The output divider may be set to divide
相关PDF资料 |
PDF描述 |
|---|---|
| LPC2292FBD144,551 | IC ARM7 MCU FLASH 256K 144-LQFP |
| LPC3240FET296,551 | IC ARM9 MCU 256K 296-TFBGA |
| LT1025ACN8 | IC THERMO COMPNSATR MICRPWR 8DIP |
| LT1030CS#PBF | IC LINE DRVR LOWPWR QUAD 14-SOIC |
| LT1032IN#PBF | IC LINE DRIVER LOWPWR QUAD 14DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LPC2106FHN48 | 制造商:NXP Semiconductors 功能描述:IC MCU ARM7 FLASH SMD HVQFN-48 制造商:NXP Semiconductors 功能描述:IC, MCU ARM7 FLASH, SMD, HVQFN-48 制造商:NXP Semiconductors 功能描述:MCU 16-Bit/32-Bit LPC2000 ARM7TDMI-S RISC 128KB Flash 1.8V/3.3V 48-Pin HVQFN EP Tray |
| LPC2106FHN48,551 | 功能描述:ARM微控制器 - MCU ARM7 128KF/64KR/I2C RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| LPC2106FHN48/00 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Single-chip 32-bit microcontrollers; 128 kB ISP/IAP flash with 16/32/64 kB RAM |
| LPC2106FHN48/01 | 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48, Controller Family/Series:LPC2100, Core Size:1 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48, Controller Family/Series:LPC2100, Core Size:16bit / 32bit, No. of I/O's:32, Supply Voltage Min:1.65V, Supply Voltage Max:1.95V, Digital IC Case Style:HVQFN, No. of Pins:48, Program Memory |
| LPC2106FHN48/01,55 | 功能描述:ARM微控制器 - MCU 128K FL/64K RAM/2 UART/I2C/SPI RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。