- 您现在的位置：买卖IC网 > PDF目录80216 > LT1201-7DFB1 (POWER-ONE INC) 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LT1201-7DFB1 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
| 封装： | CASE T01, MODULE |
| 文件页数： | 32/33页 |
| 文件大小： | 838K |
| 代理商： | LT1201-7DFB1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页当前第32页第33页
T Series
AC-DC Converters >100 Watt
Rugged Environment
Edition 4/4.99
8/33
MELCHER
The Power Partners.
Hold-up Time (Rectifier Version)
The hold-up time depends upon the output voltage at the
time of failure, the minimum acceptable output voltage and
the load according to the following formula:
Uo2 – Uo2 min u
thold = –––––––––––– (Co + Cext)
2
Po
where:
Uo
= Output voltage at the moment of mains failure
Uo min u = Minimum acceptable output voltage
Po
= Average output power during hold up time
Co
= Internal output capacitance
Cext
= External output capacitance (e.g. on backplane)
Examples of
t hold are given in the table below:
Table 5: Hold-up time thold for T1701
Uo = 54 V
Uo min u
Unit
Po [W]
46 V
43 V
40 V
38 V
100
164
219
270
302
ms
200
82
109
135
151
300
55
73
90
101
400
41
55
67
75
500
33
44
54
60
550
30
40
49
55
Output voltage regulation (Rectifier Version)
The output voltage of rectifier models is adjusted to a fixed
value
Uo set. It relates to the output current and the input
voltage which ensures automatic current sharing operation
without further precautions when several units are con-
nected in parallel. Rising output current and falling input
voltage lead to a decrease of the output voltage, according
to the formula:
Uo
≈ U
o set tol + (0.5 – Io/Ionom) DUo l + (Ui - Ui nom)/100 V
DUo U
Fig. 7
Typical output voltage versus input voltage and output
current of LT 1701
Note: Units with different output voltage regulation charac-
teristics (e.g. less output current dependency) are available
upon request.
Output power limitation (Rectifier Version)
Especially for power systems with an output voltage of 48V
and more, the rectifier models T 1701/1702 feature an out-
put power limitation mode. The output power is kept con-
stant down to an output voltage of approximately 38 V. This
provides improved start-up capabilities of power systems
including switched mode power supplies connected to the
DC bus (e.g. Melcher CQ units). At maximum load there is
no need for a special start-up procedure.
The maximum input current is limited to
I i L. At lower input
voltage
Ui red the maximum output power is limited to:
Po
≈ h U
i red Ii L
(
h = efficiency
≈ 90%)
The T 1201 types have no output power limitation charac-
teristic.
Output Overvoltage Protection (Rectifier Version)
A slight output voltage overshoot may occur at turn on, in-
hibit release or during fast load changes. A second, inde-
pendent control loop interrupts operation above
Uo L indi-
cated by the red LED. The output voltage remains below
60 V (SELV) under all operating conditions.
Note: There is no specific built-in protection against exter-
nally applied overvoltages or transient sources like e.g.
motors. Never apply voltages
>60 V (>35 V) to the output.
Otherwise the unit may be damaged.
2%
1%
0
–1%
–2%
0.01
0.5
1
Io/Io nom
Uo set
U
o
Load
regulation
05081
Output current limitation (Rectifier Version)
The output of the T units is fully protected against continu-
ous short circuit. The maximum constant current is limitted
to
Io L (see table: Electrical output data). As the LEDs indi-
cating the system status are driven from the output voltage,
in short circuit mode all LEDs switch off.
Io [A]
0
Uo [V]
48
04027
11
14.5
38
54.5
10
Fig. 8
Typical output voltage versus output current of UT/LT 1701/
1702
Io [A]
0
Uo [V]
05048
16
24
Fig. 9
Typical output voltage versus output current of UT/LT 1201
相关PDF资料 |
PDF描述 |
|---|---|
| LPC1901-9D | 1-OUTPUT 190 W AC-DC PWR FACTOR CORR MODULE |
| LES008ZD38N | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LKP5660-6PD3B1 | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
| LKP5660-6RD4T | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
| LKP5660-6RTB1 | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1202CN | 制造商:Linear Technology 功能描述: |
| LT1203 | 制造商:LINER 制造商全称:Linear Technology 功能描述:650MHz Gain of 2 Triple 2:1Video Multiplexer |
| LT1203CN8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin PDIP N |
| LT1203CN8#PBF | 功能描述:IC VIDEO MULTIPLEXER SPDT 8DIP RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:250 系列:- 功能:开关 电路:单刀单掷 导通状态电阻:48 欧姆 电压电源:单电源 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V 电流 - 电源:5µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:48-LQFP 供应商设备封装:48-LQFP（7x7） 包装:托盘 |
| LT1203CS8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin SOIC N |
发布紧急采购，3分钟左右您将得到回复。