- 您现在的位置：买卖IC网 > PDF目录80216 > LT1201-7DFB1 (POWER-ONE INC) 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | LT1201-7DFB1 |
| 厂商： | POWER-ONE INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
| 封装： | CASE T01, MODULE |
| 文件页数： | 33/33页 |
| 文件大小： | 838K |
| 代理商： | LT1201-7DFB1 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页当前第33页
Rugged Environment
AC-DC Converters >100 Watt
T Series
Edition 4/4.99
9/33
MELCHER
The Power Partners.
Uo
Uo min u
Ut
mains failure
warning time
thold
t
U
low load
heavy load
05049
Fig. 10
Hold up and warning time with power down output signal.
The table:
Hold up time also gives information about the
warning time of the power down signal. If for example the
threshold level
Ut of the power down signal is set to 43 V
and the minimum acceptable voltage of the load is 38 V the
time between the activation of the power down signal and
the switch-off of the load (550 W) will be 15 ms (55 ms -
40 ms).
Pulse Loading (Rectifier Version)
To prevent an overload of the output and filter capacitors
the superimposed AC ripple current at the output should be
limited as shown below. For high current pulse loads exter-
nal capacitors are recommended.
For other pulse loads than stated in the figure below, e.g.
Ui
< U
i nom, Io
> I
o nom, please contact Melcher.
15
10
5
0
100
1 k
10 k
Io PL [Arms]
fPL [Hz]
TC = 50°C
TC = TC max
Ui = Ui nom
Average output current = Io nom
Sinusoidal
ripple
current
50
05050
Fig. 11
Maximum allowable AC ripple output current superim-
posed on the average output current Io nom with LT 1701
unit.
Fig. 12
Dynamic characteristics under varying load conditions
(see: Electrical Output Data)
Uo
t d
DUo I
10%
DUo d
t
Io /Io nom
1
0.9
0.1
DUod
05051
Uo
Table 6: Characteristics of the inhibit signal
Characteristics
Conditions
min
typ max
Unit
Uinh Inhibit
Uo = on
Ui min...Ui max
2.5
60
V
voltage
TC min...TC max
Rinh Resistance Uo = on
30
k
to Vo–
Uinh Inhibit
Uo = off
-0.7
0.4
V
voltage
Rinh Resistance Uo = off
50
tr
Switch-on time
Ui nom
100
ms
until full power avail.
Pinh Input power with
3
W
inhibited unit
Fig. 13
Inhibit signal connection
Inhibit input (Rectifier Version)
The rectifier versions are equipped with the inhibit function
only. (The Ucr remote control is used with the battery char-
ger version.)
The unit is enabled by a logic high signal and disabled by a
logic low signal. This input is TTL/CMOS compatible, a re-
sistor
<50 disables the unit, a resistor >30 k enables it.
The switch-on time
tr of the unit, i.e. the time delay between
powering until the full output power is available, is typically
100 ms.
The hold up time at the output after inhibiting depends on
the load, the internal capacitance of the unit and additional
capacitance on the DC bus.
The inhibit input is protected against DC overvoltage up to
60 V.
P~
N~
Vo–
i/Ucr
Vo+
Iinh
Uinh
06116
4
28
12
22
6
T1000
相关PDF资料 |
PDF描述 |
|---|---|
| LPC1901-9D | 1-OUTPUT 190 W AC-DC PWR FACTOR CORR MODULE |
| LES008ZD38N | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| LKP5660-6PD3B1 | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
| LKP5660-6RD4T | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
| LKP5660-6RTB1 | 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1202CN | 制造商:Linear Technology 功能描述: |
| LT1203 | 制造商:LINER 制造商全称:Linear Technology 功能描述:650MHz Gain of 2 Triple 2:1Video Multiplexer |
| LT1203CN8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin PDIP N |
| LT1203CN8#PBF | 功能描述:IC VIDEO MULTIPLEXER SPDT 8DIP RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:250 系列:- 功能:开关 电路:单刀单掷 导通状态电阻:48 欧姆 电压电源:单电源 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V 电流 - 电源:5µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:48-LQFP 供应商设备封装:48-LQFP（7x7） 包装:托盘 |
| LT1203CS8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin SOIC N |
发布紧急采购，3分钟左右您将得到回复。