参数资料
型号: LT1618EMS#TRPBF
厂商: Linear Technology
文件页数: 5/16页
文件大小: 0K
描述: IC REG BOOST ADJ 1.5A 10MSOP
标准包装: 2,500
类型: 升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 1.26 V ~ 36 V
输入电压: 1.6 V ~ 18 V
PWM 型: 电流/电压模式
频率 - 开关: 1.4MHz
电流 - 输出: 1.5A
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 10-TFSOP,10-MSOP(0.118",3.00mm 宽)
包装: 带卷 (TR)
供应商设备封装: 10-MSOP
LT1618
BLOCK DIAGRA
V IN
L1
D1
R SENSE
V OUT
C1
9
SHDN
8
V IN
7
SW
C2
DRIVER
Q1
+
+
3
ISP
0.02 ?
1.4MHz
OSCILLATOR
× 5
+
Σ
+
A1
× 25
2
4
ISN
I ADJ
Q
S
R
A3
+
A2
1
FB
R1
OPERATIO
5
GND
10
V C
R C
C C
Figure 1. LT1618 Block Diagram
+
1.263V
R2
The LT1618 uses a constant frequency, current mode
control scheme to provide excellent line and load regula-
tion. Operation can be best understood by referring to the
Block Diagram in Figure 1. At the start of each oscillator
cycle, the SR latch is set, turning on power switch Q1. The
signal at the noninverting input of PWM comparator A3 is
a scaled-down version of the switch current (summed
together with a portion of the oscillator ramp). When this
signal reaches the level set by the output of error amplifier
A2, comparator A3 resets the latch and turns off the power
switch. In this manner, A2 sets the correct peak current
level to keep the output in regulation. If the error amplifier’s
output increases, more current is delivered to the output;
if it decreases, less current is delivered. A2 has two
inverting inputs, one from the voltage feedback loop, and
one from the current feedback loop. Whichever inverting
input is higher takes precedence, forcing the converter
into either a constant-current or a constant-voltage mode.
The LT1618 is designed to transition cleanly between the
two modes of operation. Current sense amplifier A1 senses
the voltage between the ISP and ISN pins and provides a
25 × level-shifted version to error amplifier A2. When the
voltage between ISP and ISN reaches 50mV, the output of
A1 provides 1.263V to one of the noninverting inputs of A2
and the converter is in constant-current mode. If the
current sense voltage exceeds 50mV, the output of A1 will
increase causing the output of A2 to decrease, thus
reducing the amount of current delivered to the output. In
this manner the current sense voltage is regulated to
50mV. Similarly, if the FB pin increases above 1.263V, the
output of A2 will decrease to reduce the peak current level
and regulate the output (constant-voltage mode).
sn1618 1618fas
5
相关PDF资料
PDF描述
LT1619EMS8#PBF IC REG CTRLR PWM CM 8-MSOP
LT1676IS8#TRPBF IC REG BUCK ADJ 0.7A 8SOIC
LT1680ISW#PBF IC REG CTRLR BST PWM CM 16-SOIC
LT1683EG#PBF IC REG CTRLR PWM CM 20-SSOP
LT1725IGN#TR IC REG CTRLR FLYBK ISO CM 16SSOP
相关代理商/技术参数
参数描述
LT1619 制造商:LINER 制造商全称:Linear Technology 功能描述:2-Phase Step-Up DC/DC Controller
LT1619EMS8 功能描述:IC REG CTRLR PWM CM 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LT1619EMS8#PBF 功能描述:IC REG CTRLR PWM CM 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LT1619EMS8#TR 功能描述:IC REG CTRLR PWM CM 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LT1619EMS8#TRPBF 功能描述:IC REG CTRLR PWM CM 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)