- 您现在的位置：买卖IC网 > PDF目录10693 > LT1719CS8#TRPBF (Linear Technology)IC COMP R-R I/O SGL 3/5V 8-SOIC PDF资料下载
参数资料
| 型号： | LT1719CS8#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/22页 |
| 文件大小： | 0K |
| 描述： | IC COMP R-R I/O SGL 3/5V 8-SOIC |
| 标准包装： | 2,500 |
| 系列： | UltraFast™ |
| 类型： | 通用 |
| 元件数： | 1 |
| 输出类型： | CMOS，满摆幅，TTL |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 6 V |
| 电压 - 输入偏移（最小值）： | 2.5mV @ ±5V |
| 电流 - 输入偏压（最小值）： | 6µA @ ±5V |
| 电流 - 输出（标准）： | 20mA |
| 电流 - 静态（最大值）： | 9mA |
| CMRR, PSRR（标准）： | 70dB CMRR，80dB PSRR |
| 传输延迟（最大）： | 4.2ns |
| 磁滞： | 7mV |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 安装类型： | 表面贴装 |
| 包装： | 带卷 (TR) |
LT1719
4
1719fa
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
IS
Positive Output Stage Supply Current
+ VS = VCC = 5V, VEE = –5V
l
4.2
8
mA
(LT1719S8 Only) VS = VCC = 3V, VEE = 0V
l
3.3
6
mA
I+
Supply Current
(LT1719S6) V+ = 5V
l
4.6
9
mA
V+ = 3V
l
4.2
7
mA
ISHDN5
Shutdown Pin Current
+VS or V+ = 5V
l
–300
–110
–30
μA
ISHDN3
Shutdown Pin Current
+VS or V+ = 3V
l
–200
–80
–20
μA
ICCS
ISS
IEES
I+S
ICCSO
ISSO
IEEO
I+O
Disabled Supply Currents (LT1719S8)
(LT1719S8)
(LT1719S6)
(LT1719S8)
(LT1719S6)
+VS = 6V, VCC = 5V, VEE = –5V
VSHDN = +VS – 0.5V
l
–30
0.2
7
–0.2
30
50
μA
V+ = 6V, VSHDN = +VS – 0.5V
l
780
μA
+VS = 6V, VCC = 5V, VEE = –5V
Shutdown Pin Open
l
–20
0.1
20
μA
V+ = 6V, Shutdown Pin Open
l
0.2
40
μA
ELECTRICAL CHARACTERISTICS The l denotes the specications which apply over the full operating
temperature range, otherwise specications are at TA = 25°C. VCM = 1V, VSHDN = 0.5V, VOVERDRIVE = 20mV, COUT = 10pF and for the
LT1719S8 VCC = +VS = 5V and VEE = –5V, for the LT1719S6 V+ = 5V, V– = 0V, unless otherwise specied.
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: If one input is within these common mode limits, the other input
can go outside the common mode limits and the output will be valid.
Note 3: The LT1719 comparator includes internal hysteresis. The trip
points are the input voltage needed to change the output state in each
direction. The offset voltage is dened as the average of VTRIP+ and VTRIP–,
while the hysteresis voltage is the difference of these two.
Note 4: The LT1719S8 common mode rejection ratio is measured with
VCC = 5V, VEE = –5V and is dened as the change in offset voltage measured
from VCM = –5.1V to VCM = 3.8V, divided by 8.9V.
Note 5: The LT1719S6 common mode rejection ratio is measured with
V+ = 5V and is dened as the change in offset voltage measured from
VCM = –0.1V to VCM = 3.8V, divided by 3.9V.
Note 6: The LT1719S8 power supply rejection ratio is measured with
VCM = 1V and is dened as the worst of: the change in offset voltage from
VEE = – 5.5V to VEE = 0V divided by 5.5V, or the change in offset voltage
from VCC = +VS = 2.7V to VCC = +VS = 6V (with VEE = 0V) divided by 3.3V.
Note 7: The LT1719S6 power supply rejection ratio is measured with
VCM = 1V and is dened as the change in offset voltage measured from
V+ = 2.7V to V+ = 6V, divided by 3.3V.
Note 8: Because of internal hysteresis, there is no small-signal region in
which to measure gain. Proper operation of internal circuity is ensured by
measuring VOH and VOL with only 10mV of overdrive.
Note 9: Propagation delay measurements made with 100mV steps.
Overdrive is measured relative to VTRIP±.
Note 10: tPD cannot be measured in automatic handling equipment with
low values of overdrive. The LT1719 is 100% tested with a 100mV step
and 20mV overdrive. Correlation tests have shown that tPD limits can be
guaranteed with this test, if additional DC tests are performed to guarantee
that all internal bias conditions are correct.
Note 11: Propagation Delay Skew is dened as:
tSKEW = |tPDLH – tPDHL|
相关PDF资料 |
PDF描述 |
|---|---|
| VE-JW3-MY-F2 | CONVERTER MOD DC/DC 24V 50W |
| LT1719CS8#TR | IC COMP R-R SINGLE 4.5NS 8SOIC |
| AD8561ARZ-REEL | IC COMP 7NS ULTRA-FAST 8-SOIC |
| VE-JW2-MY-F4 | CONVERTER MOD DC/DC 15V 50W |
| AD8561ARUZ-REEL | IC COMP 7NS ULTRA FAST 8TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1719IS6 | 制造商:Linear Technology 功能描述:Comparator Single R-R O/P |
| LT1719IS6#PBF | 制造商:Linear Technology 功能描述:Comparator Single R-R O/P 制造商:Linear Technology 功能描述:IC ANALOG COMP 1 4.5ns TSOT-23 制造商:Linear Technology 功能描述:IC, ANALOG COMP, 1, 4.5ns, TSOT-23 制造商:Linear Technology 功能描述:IC, ANALOG COMP, 1, 4.5ns, TSOT-23; Comparator Type:High Speed; No. of Comparators:1; Response Time:4.5ns; Supply Voltage Range:2.7V to 6V; Amplifier Case Style:TSOT-23; No. of Pins:6; IC Output Type:CMOS, TTL; Supply Current:4.6mA ;RoHS Compliant: Yes |
| LT1719IS6#TR | 功能描述:IC COMP R-RINOUT SINGLE SOT23-6 RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:UltraFast™ 标准包装:25 系列:- 类型:带电压基准 元件数:4 输出类型:CMOS，开路漏极，TTL 电压 - 电源，单路/双路(±):2 V ~ 11 V，±1 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:12µs 磁滞:50mV 工作温度:0°C ~ 70°C 封装/外壳:16-DIP（0.300"，7.62mm） 安装类型:通孔 包装:管件 |
| LT1719IS6#TRM | 功能描述:IC COMP R-RINOUT SINGLE SOT23-6 RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:UltraFast™ 标准包装:25 系列:- 类型:带电压基准 元件数:4 输出类型:CMOS，开路漏极，TTL 电压 - 电源，单路/双路(±):2 V ~ 11 V，±1 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:12µs 磁滞:50mV 工作温度:0°C ~ 70°C 封装/外壳:16-DIP（0.300"，7.62mm） 安装类型:通孔 包装:管件 |
| LT1719IS6#TRMPBF | 功能描述:IC COMP R-RINOUT SINGLE SOT23-6 RoHS:是 类别:集成电路 (IC) >> 线性 - 比较器 系列:UltraFast™ 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:带电压基准 元件数:4 输出类型:开路漏极 电压 - 电源，单路/双路(±):2.5 V ~ 11 V，±1.25 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:- 磁滞:- 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 安装类型:表面贴装 包装:管件 产品目录页面:1386 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。