参数资料
型号: LT1952IGN-1#PBF
厂商: Linear Technology
文件页数: 5/28页
文件大小: 0K
描述: IC REG CTRLR ISO PWM CM 16-SSOP
标准包装: 100
PWM 型: 电流模式
输出数: 1
频率 - 最大: 560kHz
占空比: 90%
电源电压: 6.82 V ~ 25 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 16-SSOP(0.154",3.90mm 宽)
包装: 管件
LT1952/LT1952-1
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the specified operating
junction temperature range, otherwise specifications are at T A = 25°C (Note 2). COMP = open, FB = 1.4V, R OSC = 178k, SYNC = 0V,
SS_MAXDC = V REF , V REF = 0.1μF, SD_V SEC = 2V, BLANK = 121k, DELAY = 121k, I SENSE = 0V, OC = 0V, OUT = 1nF, V IN = 15V, SOUT =
open, unless otherwise specified.
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
SOFT-START
SS_MAXDC Low Level: V OL
SS_MAXDC Soft-Start Reset Threshold
SS_MAXDC Active Threshold
SS_MAXDC Input Current (Soft-Start Pull-Down: Idis)
I (SS_MAXDC) = 150μA, OC = 1V
Measured on SS_MAXDC
FB = 1V, DC > 0%
SS_MAXDC = 1V, SD_V SEC = 1.4V, OC = 1V
0.2
0.45
0.8
800
V
V
V
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT1952/LT1952-1 are tested under pulsed load conditions
such that T J ≈ T A . The LT1952EGN/LT1952EGN-1 are guaranteed to meet
performance specifications from 0°C to 125°C junction temperature.
Specifications over the –40°C to 125°C operating junction temperature
range are assured by design, characterization and correlation with
statistical process controls. The LT1952IGN/LT1952IGN-1 are guaranteed
over the –40°C to 125°C operating junction temperature range and the
LT1952MPGN/LT1952MPGN-1 are tested and guaranteed over the full
–55°C to 125°C operating junction temperature range. Note that the
maximum ambient temperature consistent with these specifications is
determined by specific operating conditions in conjunction with board
layout, the rated package thermal impedance and other environmental
factors.
Note 3: Rise and Fall times are measured at 10% and 90% levels.
Note 4: Guaranteed by correlation to static test.
Note 5: Each IC includes over-temperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed 125°C when over-temperature protection is active.
Continuous operation above the specified maximum operating junction
temperature may impair device reliability.
Note 6: Guaranteed but not tested.
Note 7: Maximum recommended SYNC frequency = 500kHz.
Note 8: In applications where the V IN pin is supplied via an external RC
network from a SYSTEM V IN > 25V, an external zener with clamp voltage
V IN ON(MAX) < V Z < 25V should be connected from the V IN pin to ground.
Note 9: V IN start-up current is measured at V IN = V IN ON – 0.25V and
scaled by x 1.18 (to correlate to worst case V IN start-up current at V IN ON ).
Note 10: Timing for R = 40k derived from measurement with R = 240k.
19521fe
5
相关PDF资料
PDF描述
LT1956IFE-5#TRPBF IC REG BUCK 5V 1.5A 16TSSOP
LT1959IR#TR IC REG BUCK ADJ 4.5A D2PAK
LT1961IMS8E#TRPBF IC REG BOOST ADJ 1.5A 8MSOP
LT1962EMS8-1.8#TRPBF IC REG LDO 1.8V .3A 8MSOP
LT1963AMPQ#TRPBF IC REG LDO ADJ 1.5A 5-DD
相关代理商/技术参数
参数描述
LT1952IGN-1TR 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Switch Synchronous Forward Controller
LT1952IGN-1TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Switch Synchronous Forward Controller
LT1952IGNPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Switch Synchronous Forward Controller
LT1952IGNTR 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Switch Synchronous Forward Controller
LT1952IGNTRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Single Switch Synchronous Forward Controller