参数资料
型号: LT1961IMS8E#PBF
厂商: Linear Technology
文件页数: 9/16页
文件大小: 0K
描述: IC REG BOOST ADJ 1.5A 8MSOP
标准包装: 50
类型: 升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 1.2 V ~ 35 V
输入电压: 3 V ~ 25 V
PWM 型: 电流模式
频率 - 开关: 1.25MHz
电流 - 输出: 1.5A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)裸露焊盘
包装: 管件
供应商设备封装: 8-MSOP-EP
LT1961
APPLICATIO N S I N FOR M ATIO N
CATCH DIODE
The suggested catch diode (D1) is a UPS120 or 1N5818
Schottky. It is rated at 1A average forward current and
20V/30V reverse voltage. Typical forward voltage is 0.5V
at 1A. The diode conducts current only during switch off
time. Peak reverse voltage is equal to regulator output
shutdown pin can be used. The threshold voltage of the
shutdown pin comparator is 1.35V. A 3 μ A internal current
source defaults the open pin condition to be operating (see
Typical Performance Graphs). Current hysteresis is added
above the SHDN threshold. This can be used to set voltage
hysteresis of the UVLO using the following:
voltage. Average forward current in normal operation is
equal to output current.
SHUTDOWN AND UNDERVOLTAGE LOCKOUT
Figure 4 shows how to add undervoltage lockout (UVLO)
to the LT1961. Typically, UVLO is used in situations where
the input supply is current limited, or has a relatively high
R 1 =
R 2 =
V H ? V L
7 μ A
1 . 35 V
( V H ? 1 . 35 V ) + 3 μ A
R 1
source resistance. A switching regulator draws constant
power from the source, so source current increases as
source voltage drops. This looks like a negative resistance
load to the source and can cause the source to current limit
or latch low under low source voltage conditions. UVLO
prevents the regulator from operating at source voltages
where these problems might occur.
V H – Turn-on threshold
V L – Turn-off threshold
Example: switching should not start until the input is
above 4.75V and is to stop if the input falls below 3.75V.
V H = 4.75V
V L = 3.75V
LT1961
= 143 k
INPUT
C1
R1
R2
IN
SHDN
3 μ A
7 μ A
1.35V
GND
V CC
1961 F04
R 1 =
R 2 =
4 .75V ? 3 .75V
7 μ A
1 . 35 V
( 4 . 75 V ? 1 . 35 V ) + 3 μ A
143 k
= 50 . 4 k
Figure 4. Undervoltage Lockout
An internal comparator will force the part into shutdown
below the minimum V IN of 2.6V. This feature can be used
to prevent excessive discharge of battery-operated sys-
tems. If an adjustable UVLO threshold is required, the
Keep the connections from the resistors to the SHDN pin
short and make sure that the interplane or surface capaci-
tance to the switching n odes are minimized. If high resis-
tor values are used, the SHDN pin should be bypassed with
a 1nF capacitor to prevent coupling problems from the
switch node.
1961fa
9
相关PDF资料
PDF描述
HM71-30331LFTR HIGH PERF LOW COST INDUCTORS
MAX6869UK20D3S+T IC MPU SUPERVISOR SOT23-5
LTC3532EMS#TRPBF IC REG BUCK BST SYNC 0.5A 10MSOP
HM71-30221LFTR HIGH PERF LOW COST INDUCTORS
MAX6869UK20D4L+T IC MPU SUPERVISOR SOT23-5
相关代理商/技术参数
参数描述
LT1961IMS8ETR 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, 1.25MHz Step-Up Switching Regulator
LT1961IMS8ETRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, 1.25MHz Step-Up Switching Regulator
LT1962 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower Low Dropout Regulators with Shutdown
LT1962EMS8 功能描述:IC REG LDO ADJ .3A 8-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:More Information on LDOs 标准包装:50 系列:- 稳压器拓扑结构:正,固定式 输出电压:3.3V 输入电压:最高 15V 电压 - 压降(标准):1.1V @ 800mA 稳压器数量:1 电流 - 输出:800mA 电流 - 限制(最小):800mA 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-4,D²Pak(3 引线+接片),TO-263AA 供应商设备封装:D2PAK-3 包装:管件
LT1962EMS8#PBF 功能描述:IC REG LDO ADJ .3A 8-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正,固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降(标准):0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制(最小):200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘,4-TMLF? 供应商设备封装:4-TMLF?(1x1) 包装:Digi-Reel® 其它名称:576-3192-6