- 您现在的位置：买卖IC网 > PDF目录13080 > LT1963AES8-3.3 (Linear Technology)IC REG LDO 3.3V 1.5A 8SOIC PDF资料下载
参数资料
| 型号： | LT1963AES8-3.3 |
| 厂商： | Linear Technology |
| 文件页数： | 13/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 3.3V 1.5A 8SOIC |
| 标准包装： | 100 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 3.3V |
| 输入电压： | 最高 20V |
| 电压 - 压降（标准）： | 0.34V @ 1.5A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 1.5A |
| 电流 - 限制（最小）： | 1.6A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT1963A Series
PIN FUNCTIONS
OUT: Output. The output supplies power to the load.
A minimum output capacitor of 10μF is required to
prevent oscillations. Larger output capacitors will be
required for applications with large transient loads to limit
peak voltage transients. See the Applications Information
section for more information on output capacitance and
reverse output characteristics.
SENSE: Sense. For fixed voltage versions of the LT1963A
(LT1963A-1.5/LT1963A-1.8/LT1963A-2.5/LT1963A-3.3),
the SENSE pin is the input to the error amplifier. Optimum
regulation will be obtained at the point where the SENSE
pin is connected to the OUT pin of the regulator. In criti-
cal applications, small voltage drops are caused by the
resistance (R P ) of PC traces between the regulator and the
load. These may be eliminated by connecting the SENSE
pin to the output at the load as shown in Figure 1 (Kelvin
Sense Connection). Note that the voltage drop across
the external PC traces will add to the dropout voltage of
the regulator. The SENSE pin bias current is 600μA at
the nominal rated output voltage. The SENSE pin can be
pulled below ground (as in a dual supply system where
the regulator load is returned to a negative supply) and
still allow the device to start and operate.
be off when the SHDN pin is pulled low. The SHDN pin can
be driven either by 5V logic or open-collector logic with a
pull-up resistor. The pull-up resistor is required to supply
the pull-up current of the open-collector gate, normally
several microamperes, and the SHDN pin current, typically
3μA. If unused, the SHDN pin must be connected to V IN .
The device will be in the low power shutdown state if the
SHDN pin is not connected.
IN: Input. Power is supplied to the device through the IN
pin. A bypass capacitor is required on this pin if the device
is more than six inches away from the main input filter
capacitor. In general, the output impedance of a battery
rises with frequency, so it is advisable to include a bypass
capacitor in battery-powered circuits. A bypass capacitor
in the range of 1μF to 10μF is sufficient. The LT1963A
regulators are designed to withstand reverse voltages
on the IN pin with respect to ground and the OUT pin. In
the case of a reverse input, which can happen if a battery
is plugged in backwards, the device will act as if there is
a diode in series with its input. There will be no reverse
current flow into the regulator and no reverse voltage
will appear at the load. The device will protect both itself
and the load.
ADJ: Adjust. For the adjustable LT1963A, this is the input
to the error amplifier. This pin is internally clamped to ± 7V.
It has a bias current of 3μA which flows into the pin. The
ADJ pin voltage is 1.21V referenced to ground and the
output voltage range is 1.21V to 20V.
V IN
+
IN OUT
LT1963A
SHDN SENSE
GND
R P
+
LOAD
SHDN : Shutdown. The SHDN pin is used to put the LT1963A
regulators into a low power shutdown state. The output will
R P
Figure 1. Kelvin Sense Connection
1963A F01
13
For more information www.linear.com/LT1963A
1963aff
相关PDF资料 |
PDF描述 |
|---|---|
| 350MXC180MEFCSN30X25 | CAP ALUM 180UF 350V 20% SNAP-IN |
| ADP3339AKCZ-3-RL7 | IC REG LDO 3V 1.5A SOT-223 |
| VI-JWD-EZ-B1 | CONVERTER MOD DC/DC 85V 25W |
| 450VXH150MEFCSN22X35 | CAP ALUM 150UF 450V 20% SNAP-IN |
| ABC08DRYH-S13 | CONN EDGECARD 16POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1963AES8PBF | 制造商:Linear Technology 功能描述: |
| LT1963AES8-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963AES8TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators |
| LT1963AES8TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators |
| LT1963AEST | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response |
发布紧急采购，3分钟左右您将得到回复。