参数资料
型号: LT1963AES8-3.3
厂商: Linear Technology
文件页数: 20/28页
文件大小: 0K
描述: IC REG LDO 3.3V 1.5A 8SOIC
标准包装: 100
稳压器拓扑结构: 正,固定式
输出电压: 3.3V
输入电压: 最高 20V
电压 - 压降(标准): 0.34V @ 1.5A
稳压器数量: 1
电流 - 输出: 1.5A
电流 - 限制(最小): 1.6A
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
LT1963A Series
APPLICATIONS INFORMATION
LT1963A
V OUT = V FB
LT1963A-3.3
OUTPUT VOLTAGE (V)
The output of the LT1963A can be pulled below ground
without damaging the device. If the input is left open circuit
or grounded, the output can be pulled below ground by
20V. For fixed voltage versions, the output will act like a
large resistor, typically 5k or higher, limiting current flow
to typically less than 600μA. For adjustable versions, the
output will act like an open circuit; no current will flow out
of the pin. If the input is powered by a voltage source, the
output will source the short-circuit current of the device
and will protect itself by thermal limiting. In this case,
grounding the SHDN pin will turn off the device and stop
the output from sourcing the short-circuit current.
The ADJ pin of the adjustable device can be pulled above
or below ground by as much as 7V without damaging the
device. If the input is left open circuit or grounded, the ADJ
pin will act like an open circuit when pulled below ground
and like a large resistor (typically 5k) in series with a diode
when pulled above ground.
In situations where the ADJ pin is connected to a resistor
divider that would pull the ADJ pin above its 7V clamp volt-
age if the output is pulled high, the ADJ pin input current
must be limited to less than 5mA. For example, a resistor
divider is used to provide a regulated 1.5V output from the
1.21V reference when the output is forced to 20V. The top
resistor of the resistor divider must be chosen to limit the
current into the ADJ pin to less than 5mA when the ADJ
pin is at 7V. The 13V difference between OUT and ADJ
pins divided by the 5mA maximum current into the ADJ
pin yields a minimum top resistor value of 2.6k.
In circuits where a backup battery is required, several
different input/output conditions can occur. The output
voltage may be held up while the input is either pulled
to ground, pulled to some intermediate voltage, or is left
open circuit. Current flow back into the output will follow
the curve shown in Figure 12.
When the IN pin of the LT1963A is forced below the OUT
pin or the OUT pin is pulled above the IN pin, input cur-
rent will typically drop to less than 2μA. This can happen
if the input of the device is connected to a discharged
(low voltage) battery and the output is held up by either
a backup battery or a second regulator circuit. The state
of the SHDN pin will have no effect on the reverse output
current when the output is pulled above the input.
5.0
4.5 V OUT = V ADJ
4.0 LT1963A-1.5
3.5
LT1963A-1.8
3.0 V OUT = V FB
2.5 LT1963A-2.5
V OUT = V FB
2.0
1.5 V OUT = V FB
1.0 T J = 25°C
V IN = 0V
0.5 CURRENT FLOWS
INTO OUTPUT PIN
0
0 1 2 3 4 5 6 7 8 9 10
1963A F12
Figure 12. Reverse Output Current
20
For more information www.linear.com/LT1963A
1963aff
相关PDF资料
PDF描述
350MXC180MEFCSN30X25 CAP ALUM 180UF 350V 20% SNAP-IN
ADP3339AKCZ-3-RL7 IC REG LDO 3V 1.5A SOT-223
VI-JWD-EZ-B1 CONVERTER MOD DC/DC 85V 25W
450VXH150MEFCSN22X35 CAP ALUM 150UF 450V 20% SNAP-IN
ABC08DRYH-S13 CONN EDGECARD 16POS .100 EXTEND
相关代理商/技术参数
参数描述
LT1963AES8PBF 制造商:Linear Technology 功能描述:
LT1963AES8-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response LDO Regulators
LT1963AES8TR 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators
LT1963AES8TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise,Fast Transient Response LDO Regulators
LT1963AEST 制造商:LINER 制造商全称:Linear Technology 功能描述:1.5A, Low Noise, Fast Transient Response