- 您现在的位置：买卖IC网 > PDF目录1823 > LT3008EDC-1.2#TRMPBF (Linear Technology)IC REG LDO 1.2V 20MA 6-DFN PDF资料下载
参数资料
| 型号： | LT3008EDC-1.2#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 1.2V 20MA 6-DFN |
| 产品培训模块： | More Information on LDOs |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 1.2V |
| 输入电压： | 2 V ~ 45 V |
| 电压 - 压降（标准）： | 0.3V @ 20mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 20mA |
| 电流 - 限制（最小）： | 22mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-WFDFN 裸露焊盘 |
| 供应商设备封装： | 6-DFN-EP（2x2） |
| 包装： | 标准包装 |
| 产品目录页面： | 1330 (CN2011-ZH PDF) |
| 其它名称： | LT3008EDC-1.2#TRMPBFDKR |
LT3008 Series
APPLICATIONS INFORMATION
Because the ADJ pin is relatively high impedance (de-
pending on the resistor divider used), stray capacitances
at this pin should be minimized. Special attention should
be given to any stray capacitances that can couple ex-
ternal signals onto the ADJ pin, producing undesirable
output transients or ripple.
Extra care should be taken in assembly when using high
valued resistors. Small amounts of board contamination
can lead to signi?cant shifts in output voltage. Appropriate
post-assembly board cleaning measures should be
implemented to prevent board contamination. If the
board is to be subjected to humidity cycling or if board
cleaning measures cannot be guaranteed, consideration
should be given to using resistors an order of magnitude
smaller than in Table 1 to prevent contamination from
causing unwanted shifts in the output voltage. A ?xed
voltage option in the LT3008 series will not need these
special considerations.
Output Capacitance and Transient Response
The LT3008 is stable with a wide range of output capacitors.
The ESR of the output capacitor affects stability, most
notably with small capacitors. Use a minimum output
capacitor of 2.2μF with an ESR of 3Ω or less to prevent
oscillations. The LT3008 is a micropower device and output
load transient response is a function of output capacitance.
Larger values of output capacitance decrease the peak
deviations and provide improved transient response for
larger load current changes.
Give extra consideration to the use of ceramic capacitors.
Manufacturers make ceramic capacitors with a variety of
dielectrics, each with different behavior across temperature
and applied voltage. The most common dielectrics are
speci?ed with EIA temperature characteristic codes of
Z5U, Y5V, X5R and X7R. The Z5U and Y5V dielectrics
provide high C-V products in a small package at low cost,
but exhibit strong voltage and temperature coef?cients as
shown in Figures 3 and 4. When used with a 5V regulator,
a 16V 10μF Y5V capacitor can exhibit an effective value
as low as 1μF to 2μF for the DC bias voltage applied and
over the operating temperature range. The X5R and
X7R dielectrics yield more stable characteristics and are
more suitable for use as the output capacitor. The X7R
type has better stability across temperature, while the
X5R is less expensive and is available in higher values.
One must still exercise care when using X5R and X7R
capacitors; the X5R and X7R codes only specify operating
temperature range and maximum capacitance change
over temperature. Capacitance change due to DC bias
with X5R and X7R capacitors is better than Y5V and Z5U
capacitors, but can still be signi?cant enough to drop
capacitor values below appropriate levels. Capacitor DC
bias characteristics tend to improve as component case
size increases, but expected capacitance at operating
voltage should be veri?ed.
Voltage and temperature coef?cients are not the only
sources of problems. Some ceramic capacitors have a
20
0
BOTH CAPACITORS ARE 16V,
1210 CASE SIZE, 10μF
40
20
X5R
0
X5R
–20
–20
–40
–40
Y5V
–60
Y5V
–60
–80
–80
BOTH CAPACITORS ARE 16V,
1210 CASE SIZE, 10μF
–100
0
2
4
6
8
10
12
14
16
–100
–50 –25
0
25
50
75
100
125
DC BIAS VOLTAGE (V)
3008 F03
TEMPERATURE (°C)
3008 F04
Figure 3. Ceramic Capacitor DC Bias Characteristics
Figure 4. Ceramic Capacitor Temperature Characteristics
3008fc
13
相关PDF资料 |
PDF描述 |
|---|---|
| LT3009ESC8-1.5#TRMPBF | IC REG LDO 1.5V 20MA SC70-8 |
| LT3010MPMS8E-5#TRPBF | IC REG LDO 5V 50MA 8-MSOP |
| LT3011HMSE#TRPBF | IC REG LDO ADJ 50MA 12-MSOP |
| LT3012HFE#TRPBF | IC REG LDO ADJ .2A 16-TSSOP |
| LT3013MPFE#PBF | IC REG LDO ADJ .25A 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3008EDC-2.5 | 制造商:LINER 制造商全称:Linear Technology 功能描述:3μA IQ, 20mA, 45V Low Dropout Linear Regulators |
| LT3008EDC-2.5#PBF | 制造商:Linear Technology 功能描述:Bulk |
| LT3008EDC-2.5#TRMPBF | 功能描述:IC REG LDO 2.5V 20MA 6-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| LT3008EDC-2.5#TRPBF | 功能描述:IC REG LDO 2.5V 20MA 6-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| LT3008EDC-2.5PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:3μA IQ, 20mA, 45V Low Dropout Linear Regulators |
发布紧急采购，3分钟左右您将得到回复。