- 您现在的位置：买卖IC网 > PDF目录4588 > LT3008MPTS8-2.5#TRPBF (Linear Technology)IC REG LDO 2.5V 20MA TSOT23-8 PDF资料下载
参数资料
| 型号： | LT3008MPTS8-2.5#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 2.5V 20MA TSOT23-8 |
| 标准包装： | 2,500 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 2.5V |
| 输入电压： | 最高 45 V |
| 电压 - 压降（标准）： | 0.3V @ 20mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 20mA |
| 电流 - 限制（最小）： | 22mA |
| 工作温度： | -55°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-8 薄型，TSOT-23-8 |
| 供应商设备封装： | TSOT-23-8 |
| 包装： | 带卷 (TR) |
LT3008 Series
ELECTRICAL CHARACTERISTICS The l denotes the speci?cations which apply over the full operating
temperature range, otherwise speci?cations are at T J = 25°C. (Note 2)
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
Current Limit
V IN = 45V, V OUT = 0
V IN = V OUT(NOMINAL) + 1V, ΔV OUT = – 5%
l
22
75
mA
mA
Input Reverse-Leakage Current
Reverse-Output Current
V IN = –45V, V OUT = 0
V OUT = 1.2V, V IN = 0
l
1
0.6
30
10
μA
μA
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT3008 regulators are tested and speci?ed under pulse
load conditions such that T J ? T A . The LT3008E is guaranteed to meet
performance speci?cations from 0°C to 125°C operating junction
temperature. Speci?cations over the –40°C to 125°C operating junction
temperature range are assured by design, characterization and correlation
with statistical process controls. The LT3008I is guaranteed over the full
– 40°C to 125°C operating junction temperature range. The LT3008MP is
100% tested and guaranteed over the –55°C to 125°C operating junction
temperature range.
Note 3: The LT3008 adjustable version is tested and speci?ed for these
conditions with the ADJ pin connected to the OUT pin.
Note 4: Operating conditions are limited by maximum junction
temperature. The regulated output voltage speci?cation will not apply
for all possible combinations of input voltage and output current. When
operating at the maximum input voltage, the output current range must be
limited. When operating at the maximum output current, the input voltage
Note 5: Dropout voltage is the minimum input to output voltage differential
needed to maintain regulation at a speci?ed output current. In dropout, the
output voltage equals (V IN – V DROPOUT ). For the LT3008-1.2 and LT3008-
1.5, dropout voltage will be limited by the minimum input voltage.
Note 6: To satisfy minimum input voltage requirements, the LT3008
adjustable version is tested and speci?ed for these conditions with an
external resistor divider (61.9k bottom, 280k top) which sets V OUT to 3.3V.
The external resistor divider adds 9.69μA of DC load on the output. This
external current is not factored into GND pin current.
Note 7: GND pin current is tested with V IN = V OUT(NOMINAL) + 0.55V and
a current source load. GND pin current will increase in dropout. For the
?xed output voltage versions, an internal resistor divider will add about
1μA to the GND pin current. See the GND Pin Current curves in the Typical
Performance Characteristics section.
Note 8: The SHDN pin can be driven below GND only when tied to the IN
pin directly or through a pull-up resistor. If the SHDN pin is driven below
GND by more than –0.3V while IN is powered, the output will turn on.
Note 9: Output noise is listed for the adjustable version with the ADJ pin
connected to the OUT pin. See the RMS Output Noise vs Load Current
curve in the Typical Performance Characteristics Section.
must be limited.
3008fc
6
相关PDF资料 |
PDF描述 |
|---|---|
| LT3015IQ-12#TRPBF | IC REG LDO -12V 1.5A DDPAK-5 |
| LT3015IQ#TRPBF | IC REG LDO NEG ADJ 1.5A 5DD-PAK |
| LFXP10C-3F256C | IC FPGA 9.7KLUTS 188I/O 256-BGA |
| IDT72V51236L6BB8 | IC FLOW CTRL MULTI QUEUE 256-BGA |
| LFECP10E-3FN484C | IC FPGA 10.2KLUTS 484FPBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3008MPTS8-3.3#TRM | 制造商:Linear Technology 功能描述:Conn Subminiature Cylindrical PIN 42 POS Crimp ST Wall Mount 42 Terminal 1 Port |
| LT3008MPTS8-3.3#TRMPBF | 功能描述:IC REG LDO 3.3V 20MA TSOT23-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:2.3 V ~ 5.5 V 电压 - 压降（标准）:0.035V @ 150mA 稳压器数量:2 电流 - 输出:150mA 电流 - 限制（最小）:300mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:6-UFDFN 裸露焊盘，6-TMLF? 供应商设备封装:6-TMLF?（1.6x1.6） 包装:Digi-Reel® 产品目录页面:1104 (CN2011-ZH PDF) 其它名称:576-3018-6 |
| LT3008MPTS8-3.3#TRPBF | 功能描述:IC REG LDO 3.3V 20MA TSOT23-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:2.3 V ~ 5.5 V 电压 - 压降（标准）:0.035V @ 150mA 稳压器数量:2 电流 - 输出:150mA 电流 - 限制（最小）:300mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:6-UFDFN 裸露焊盘，6-TMLF? 供应商设备封装:6-TMLF?（1.6x1.6） 包装:Digi-Reel® 产品目录页面:1104 (CN2011-ZH PDF) 其它名称:576-3018-6 |
| LT3008MPTS8-5#PBF | 制造商:Linear Technology 功能描述:SP-LINREG, Cut Tape 3uA Iq, 20mA Low Dropout Linear Regulators |
| LT3008MPTS8-5#TRMPBF | 功能描述:IC REG LDO 5V 20MA TSOT23-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:2.3 V ~ 5.5 V 电压 - 压降（标准）:0.035V @ 150mA 稳压器数量:2 电流 - 输出:150mA 电流 - 限制（最小）:300mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:6-UFDFN 裸露焊盘，6-TMLF? 供应商设备封装:6-TMLF?（1.6x1.6） 包装:Digi-Reel® 产品目录页面:1104 (CN2011-ZH PDF) 其它名称:576-3018-6 |
发布紧急采购，3分钟左右您将得到回复。