参数资料
型号: LT3020EMS8-1.8#TR
厂商: Linear Technology
文件页数: 8/16页
文件大小: 0K
描述: IC REG LDO 1.8V .1A 8MSOP
标准包装: 2,500
稳压器拓扑结构: 正,固定式
输出电压: 1.8V
输入电压: 最高 10V
电压 - 压降(标准): 0.15V @ 100mA
稳压器数量: 1
电流 - 输出: 100mA
电流 - 限制(最小): 110mA
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-MSOP
包装: 带卷 (TR)
LT3020/LT3020-1.2/
LT3020-1.5/LT3020-1.8
TYPICAL PERFOR A CE CHARACTERISTICS
RMS Output Noise vs Load
Current (10Hz to 100kHz)
No-Load Recovery Threshold
300
V OUT = 1.2V
C OUT = 2.2 μ F
18
16
250
14
200
12
10
150
8
100
6
4
50
2
0
0.01
0.1
1 10
100
0
0
5
10
15
20
LOAD CURRENT (mA)
3020 G19
PI FU CTIO S
OUT (Pins 1, 2): These pins supply power to the load. Use
a minimum output capacitor of 2.2 μ F to prevent oscillations.
Applications with large load transients require larger out-
put capacitors to limit peak voltage transients. See the
Applications Information section for more information on
output capacitance and reverse output characteristics.
OUT (Pin 3, Fixed Voltage Device Only): This pin is the
sense point for the internal resistor divider. It should be
tied directly to the other OUT pins (1, 2) for best results.
ADJ (Pin 3, Adjustable Device Only): This pin is the
inverting terminal to the error amplifier. Its typical input
bias current of 20nA flows out of the pin (see curve of ADJ
Pin Bias Current vs Temperature in the Typical Perfor-
mance Characteristics). The ADJ pin reference voltage is
200mV (referred to GND).
GND (Pin 4): Ground.
SHDN (Pin 5): The SHDN pin puts the LT3020 into a low
power state. Pulling the SHDN pin low turns the output off.
Drive the SHDN pin with either logic or an open collector/
drain device with a pull-up resistor. The pull-up resistor
OUTPUT OVERSHOOT (%)
3020 G20
supplies the pull-up current to the open collector/drain
logic, normally several microamperes, and the SHDN pin
current, typically 2.3 μ A. If unused, connect the SHDN pin
to V IN . The LT3020 does not function if the SHDN pin is not
connected.
IN (Pins 7, 8): These pins supply power to the device. The
LT3020 requires a bypass capacitor at IN if it is more than
six inches away from the main input filter capacitor. The
output impedance of a battery rises with frequency, so
include a bypass capacitor in battery-powered circuits. A
bypass capacitor in the range of 2.2 μ F to 10 μ F suffices. The
LT3020 withstands reverse voltages on the IN pin with
respect to ground and the OUT pin. In the case of a reversed
input, which occurs if a battery is plugged in backwards,
the LT3020 acts as if a diode is in series with its input. No
reverse current flows into the LT3020 and no reverse volt-
age appears at the load. The device protects itself and the
load.
GND (Pin 9, DD8 Package Only): Ground. Solder Pin 9
(the exposed pad) to the PCB. Connect directly to Pin 4 for
best performance.
3020fc
8
相关PDF资料
PDF描述
LT3020EMS8-1.5#TR IC REG LDO 1.5V .1A 8MSOP
LT3020EMS8#TRPBF IC REG LDO ADJ .1A 8-MSOP
LT3020EMS8#TR IC REG LDO ADJ .1A 8MSOP
LT3020EDD-1.5#TRPBF IC REG LDO 1.5V .1A 8-DFN
LT3020EDD-1.5#TR IC REG LDO 1.5V .1A 8-DFN
相关代理商/技术参数
参数描述
LT3020EMS8PBF 制造商:Linear Technology 功能描述:LT3020 adjustable 100mA LDO regulator
LT3020IDD 制造商:Linear Technology 功能描述:LDO Regulator Pos 0.2V to 9.5V 0.1A 8-Pin DFN EP
LT3020IDD#PBF 功能描述:IC REG LDO ADJ .1A 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:MIC5365/66 Ultra-small LDO Regulators 标准包装:1 系列:- 稳压器拓扑结构:正,固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降(标准):0.155V @ 150mA 稳压器数量:1 电流 - 输出:150mA 电流 - 限制(最小):200mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-UDFN 裸露焊盘,4-TMLF? 供应商设备封装:4-TMLF?(1x1) 包装:Digi-Reel® 其它名称:576-3192-6
LT3020IDD#TRPBF 功能描述:IC REG LDO ADJ .1A 8-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 产品培训模块:More Information on LDOs 标准包装:50 系列:- 稳压器拓扑结构:正,固定式 输出电压:3.3V 输入电压:最高 15V 电压 - 压降(标准):1.1V @ 800mA 稳压器数量:1 电流 - 输出:800mA 电流 - 限制(最小):800mA 工作温度:0°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-263-4,D²Pak(3 引线+接片),TO-263AA 供应商设备封装:D2PAK-3 包装:管件
LT3020IDD-1.2 制造商:LINER 制造商全称:Linear Technology 功能描述:100mA, Low Voltage, Very Low Dropout Linear Regulator