参数资料
| 型号： | LT3070IUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 5/28页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO ADJ 5A 28QFN |
| 产品培训模块： | LT3070 - 5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| 标准包装： | 73 |
| 稳压器拓扑结构： | 正，可调式 |
| 输出电压： | 0.8 V ~ 1.8 V |
| 输入电压： | 0.95 V ~ 3 V |
| 电压 - 压降（标准）： | 0.085V @ 5A |
| 稳压器数量： | 1 |
| 电流 - 输出： | 5A |
| 电流 - 限制（最小）： | 5.1A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-QFN（4x5） |
| 包装： | 管件 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3070
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at T A = 25°C. C OUT = 15μF (Note 9), V IN = V OUT + 0.3V (Note 5), V BIAS = 2.5V unless
otherwise noted.
PARAMETER
V BIAS Ripple Rejection
V IN Ripple Rejection
(Notes 3, 4, 5)
Reference Voltage Noise
(REF/BYP Pin)
Output Voltage Noise
CONDITIONS
V BIAS = V OUT + 1.5V AVG , V RIPPLE =0.5V P-P , f RIPPLE = 120Hz,
V IN – V OUT = 300mV, I OUT = 2.5A
V BIAS = 2.5V, V RIPPLE = 50mV P-P , f RIPPLE = 120Hz,
V IN – V OUT = 300mV, I OUT = 2.5A
C REF/BYP = 10nF, BW = 10Hz to 100kHz
V OUT = 1V, I OUT = 5A, C REF/BYP = 10nF, C OUT = 15μF,
BW = 10Hz to 100kHz
MIN
TYP
75
66
10
25
MAX
UNITS
dB
dB
μV RMS
μV RMS
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT3070 regulators are tested and specified under pulse load
conditions such that T J ? T A . The LT3070E is 100% tested at T A = 25°C.
Performance at –40°C and 125°C is assured by design, characterization
and correlation with statistical process controls. The LT3070I is
guaranteed over the –40°C to 125°C operating junction temperature range.
The LT3070MP is 100% tested and guaranteed over the –55°C to 125°C
operating junction temperature range.
Note 3: To maintain proper performance and regulation, the BIAS supply
voltage must be higher than the IN supply voltage. For a given V OUT , the
BIAS voltage must satisfy the following conditions: 2.2V ≤ V BIAS ≤ 3.6V
and V BIAS ≥ (1.25 ? V OUT + 1V). For V OUT ≤ 0.95V, the minimum BIAS
voltage is limited to 2.2V.
Note 4: Operating conditions are limited by maximum junction
temperature. The regulated output voltage specification does not apply
for all possible combinations of input voltage and output current. When
operating at maximum output current, limit the input voltage range to
V IN < V OUT + 500mV.
Note 5: The LT3070 incorporates safe operating area protection circuitry.
Current limit decreases as the V IN -V OUT voltage increases. Current limit
foldback starts at V IN – V OUT > 500mV. See the Typical Performance
Characteristics for a graph of Current Limit vs V IN – V OUT voltage. The
current limit foldback feature is independent of the thermal shutdown
circuity.
Note 6: Dropout voltage, V DO , is the minimum input to output voltage
differential at a specified output current. In dropout, the output voltage
equals V IN – V DO .
Note 7: GND pin current is tested with V IN = V OUT(NOMINAL) + 300mV and a
current source load. VIOC is a buffered output determined by the value of
V OUT as programmed by the V O2 -V O0 pins. VIOC’s output is independent of
the margining function.
Note 8: Reverse output current is tested with the IN pins grounded and the
OUT + SENSE pins forced to the rated output voltage. This is measured as
current into the OUT + SENSE pins.
Note 9: Frequency Compensation: The LT3070 must be frequency
compensated at its OUT pins with a minimum C OUT of 15μF configured
as a cluster of (15 × ) 1μF ceramic capacitors or as a graduated cluster
of 10μF/4.7μF/2.2μF ceramic capacitors of the same case size. Linear
Technology only recommends X5R or X7R dielectric capacitors.
3070fb
For more information www.linear.com/LT3070
5
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6422EVEZ | IC VREG DUAL LNB W/I2C 38EPTSSOP |
| AMC15DREN-S93 | CONN EDGECARD 30POS .100 EYELET |
| ECC50DRTF | CONN EDGECARD 100PS DIP .100 SLD |
| AMC15DREH-S93 | CONN EDGECARD 30POS .100 EYELET |
| HBC49DRTS-S734 | CONN EDGECARD 98POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3070IUFDTR | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| LT3070IUFDTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| LT3070MPUFD | 制造商:LINER 制造商全称:Linear Technology 功能描述:5A, Low Noise, Programmable Output, 85mV Dropout Linear Regulator |
| LT3070MPUFD#PBF | 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:300mA（最小值） 电流 - 限制（最小）:360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) |
| LT3070MPUFD#TRPBF | 功能描述:IC REG LDO ADJ 5A 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:2.5V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:300mA（最小值） 电流 - 限制（最小）:360mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。