- 您现在的位置：买卖IC网 > PDF目录13837 > LT3431IFE (Linear Technology)IC REG BUCK ADJ 3A 16TSSOP PDF资料下载
参数资料
| 型号： | LT3431IFE |
| 厂商： | Linear Technology |
| 文件页数： | 14/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A 16TSSOP |
| 标准包装： | 95 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 48 V |
| 输入电压： | 5.5 V ~ 60 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3431
APPLICATIO S I FOR ATIO
( )
I RIPPLE ( RMS ) = I OUT V OUT V IN – V OUT / V IN
Manyengineershaveheardthatsolidtantalumcapacitors
are prone to failure if they undergo high surge currents.
This is historically true, and type TPS capacitors are
specially tested for surge capability, but surge ruggedness
is not a critical issue with the output capacitor. Solid
tantalum capacitors fail during very high turn-on surges,
which do not occur at the output of regulators. High
discharge surges, such as when the regulator output is
dead shorted, do not harm the capacitors.
Unlike the input capacitor, RMS ripple current in the
output capacitor is normally low enough that ripple cur-
rent rating is not an issue. The current waveform is
triangular with a typical value of 250mA RMS . The formula
to calculate this is:
Output capacitor ripple current (RMS):
sheet for component references) C3 = 2.2 μ F, R C = 1.5k,
C C = 15nF, C F = 220pF and C1 = 47 μ F. See Application
Note 19 for further detail on techniques for proper loop
compensation.
INPUT CAPACITOR
Step-down regulators draw current from the input supply
in pulses. The rise and fall times of these pulses are very
fast. The input capacitor is required to reduce the voltage
ripple this causes at the input of LT3431 and force the
switching current into a tight local loop, thereby minimiz-
ing EMI. The RMS ripple current can be calculated from:
2
( )( )( f V IN )
I RIPPLE ( RMS ) =
0 . 29 ( V OUT ) ( V IN ? V OUT
L
)
Ceramic capacitors are ideal for input bypassing. At 500kHz
switching frequency, the energy storage requirement of
the input capacitor suggests that values in the range of
2.2 μ F to 10 μ F are suitable for most applications. If opera-
Ceramic Capacitors
Ceramic capacitors are generally chosen for their good
high frequency operation, small size and very low ESR
(effective series resistance). Their low ESR reduces out-
put ripple voltage but also removes a useful zero in the
loop frequency response, common to tantalum capaci-
tors. To compensate for this, a resistor R C can be placed
in series with the V C compensation capacitor C C . Care
must be taken however, since this resistor sets the high
frequency gain of the error amplifier, including the gain at
the switching frequency. If the gain of the error amplifier
is high enough at the switching frequency, output ripple
voltage (although smaller for a ceramic output capacitor)
may still affect the proper operation of the regulator. A
filter capacitor C F in parallel with the R C /C C network is
suggested to control possible ripple at the V C pin. An “All
Ceramic” solution is possible for the LT3431 by choosing
the correct compensation components for the given
application.
Example: For V IN = 8V to 20V, V OUT = 5V at 2A, the LT3431
can be stabilized, provide good transient response and
maintain very low output ripple voltage using the follow-
ing component values: (refer to the first page of this data
tion is required close to the minimum input required by the
output of the LT3431, a larger value may be required. This
is to prevent excessive ripple causing dips below the
minimum operating voltage resulting in erratic operation.
Depending on how the LT3431 circuit is powered up you
may need to check for input voltage transients.
The input voltage transients may be caused by input
voltage steps or by connecting the LT3431 converter to an
already powered up source such as a wall adapter. The
sudden application of input voltage will cause a large
surge of current in the input leads that will store energy in
the parasitic inductance of the leads. This energy will
cause the input voltage to swing above the DC level of input
power source and it may exceed the maximum voltage
rating of input capacitor and LT3431.
The easiest way to suppress input voltage transients is to
add a small aluminum electrolytic capacitor in parallel with
the low ESR input capacitor. The selected capacitor needs
to have the right amount of ESR in order to critically
dampen the resonant circuit formed by the input lead
inductance and the input capacitor. The typical values of
ESR will fall in the range of 0.5 ? to 2 ? and capacitance will
fall in the range of 5 μ F to 50 μ F.
sn3431 3431fs
14
相关PDF资料 |
PDF描述 |
|---|---|
| L06038R2DGWTR | INDUCTOR THIN FILM 8.2NH 0603 |
| LT3690IUFE#TRPBF | IC REG BUCK SYNC ADJ 4A 26QFN |
| L06038R2DFWTR | INDUCTOR THIN FILM 8.2NH 0603 |
| LT1171HVCT#30PBF | IC REG MULTI CONFIG ADJ TO220-5 |
| L06036R8DGWTR | INDUCTOR THIN FILM 6.8NH 0603 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3431IFE#PBF | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3431IFE#PBF | 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR 16-TSSOP 制造商:Linear Technology 功能描述:IC, STEP-DOWN REGULATOR, 16-TSSOP |
| LT3431IFE#TR | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3431IFE#TRPBF | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3433 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage Step-Up/Step-Down DC/DC Converter |
发布紧急采购，3分钟左右您将得到回复。