- 您现在的位置：买卖IC网 > PDF目录14829 > LT3436EFE#PBF (Linear Technology)IC REG BOOST ADJ 3A 16TSSOP PDF资料下载
参数资料
| 型号： | LT3436EFE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST ADJ 3A 16TSSOP |
| 标准包装： | 95 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 34 V |
| 输入电压： | 3 V ~ 25 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 800kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
LT3436
APPLICATIO N S I N FOR M ATIO N
The inductor must have a rating greater than its peak
operating current to prevent saturation resulting in effi-
ciency loss. Peak inductor current is given by:
thermal resistance number and add in worst-case ambient
temperature:
T J = T A + θ JA (P TOT )
+ IN OUT IN
I LPEAK =
( V OUT )( I OUT )
V IN ? η
V ( V ? V )
2 V OUT ( L )( f )
If a true die temperature is required, a measurement of
the SYNC to GND pin resistance can be used. The SYNC
pin resistance across temperature must first be cali-
( V OUT ? V IN )
=
( V OUT )( I OUT )
Also, consideration should be given to the DC resistance
of the inductor. Inductor resistance contributes directly to
the efficiency losses in the overall converter.
THERMAL CALCULATIONS
Power dissipation in the LT3436 chip comes from four
sources: switch DC loss, switch AC loss, drive current, and
input quiescent current. The following formulas show how
to calculate each of these losses. These formulas assume
continuous mode operation, so they should not be used
for calculating efficiency at light load currents.
DC , duty cycle =
V OUT
I SW
V IN
brated, with no device power, in an oven. The same
measurement can then be used in operation to indicate the
die temperature.
FREQUENCY COMPENSATION
Loop frequency compensation is performed on the output
of the error amplifier (V C pin) with a series RC network.
The main pole is formed by the series capacitor and the
output impedance ( ≈ 500k ? ) of the error amplifier. The
pole falls in the range of 2Hz to 20Hz. The series resistor
creates a “zero” at 1kHz to 5kHz, which improves loop
stability and transient response. A second capacitor, typi-
cally one-tenth the size of the main compensation capaci-
tor, is sometimes used to reduce the switching frequency
ripple on the V C pin. V C pin ripple is caused by output
voltage ripple attenuated by the output divider and multi-
plied by the error amplifier. Without the second capacitor,
P SW = ( DC )( I SW ) ( R SW ) + 17 n ( I SW ) ( V OUT ) ( f )
Switch loss:
V IN loss:
2
V C pin ripple is:
V C Pin Ripple =
1.2(V RIPPLE )(g m )(R C )
(V OUT )
P VIN =
+ 1 mA ( V IN )
(V IN )(I SW )(DC )
50
R SW = Switch resistance ( ≈ 0.16 ? hot)
Example: V IN = 5V, V OUT = 12V and I OUT = 0.8A
Total power dissipation = 0.34 + 0.31 + 0.11 + 0.005 =
0.77W
Thermal resistance for LT3436 package is influenced by
the presence of internal or backside planes. With a full
plane under the package, thermal resistance will be about
40 ° C/W. To calculate die temperature, use the appropriate
V RIPPLE = Output ripple (V P–P )
g m = Error amplifier transconductance
( ≈ 850 μ mho)
R C = Series resistor on V C pin
V OUT = DC output voltage
To prevent irregular switching, V C pin ripple should be
kept below 50mV P–P . Worst-case V C pin ripple occurs at
maximum output load current and will also be increased if
poor quality (high ESR) output capacitors are used. The
addition of a 150pF capacitor on the V C pin reduces
switching frequency ripple to only a few millivolts. A low
value for R C will also reduce V C pin ripple, but loop phase
margin may be inadequate.
3436fa
11
相关PDF资料 |
PDF描述 |
|---|---|
| MXD1810UR44+T | IC MPU RESET CIRC 4.37V SOT23-3 |
| RBM10DTAT-S189 | CONN EDGECARD 20POS R/A .156 SLD |
| LTC3530EMS#PBF | IC REG BUCK BST SYNC 0.6A 10MSOP |
| VI-J1Y-EW-F4 | CONVERTER MOD DC/DC 3.3V 66W |
| MXD1817UR23+T | IC MPU RESET CIRC 2.31V SOT23-3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3437 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage 500mA, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current |
| LT3437_1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage 500mA, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current |
| LT3437EDD | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.3V to 60V 10-Pin DFN EP |
| LT3437EDD#PBF | 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3437EDD#TRPBF | 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。