参数资料
型号: LT3474IFE-1#TRPBF
厂商: Linear Technology
文件页数: 10/20页
文件大小: 0K
描述: IC LED DRVR HP CONS CURR 16TSSOP
标准包装: 2,500
恒定电流:
拓扑: PWM,降压(降压)
输出数: 1
内部驱动器:
类型 - 主要: 车载,背光
类型 - 次要: 颜色,白色 LED
频率: 200kHz ~ 2MHz
电源电压: 3.5 V ~ 36 V
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
供应商设备封装: 16-TSSOP-EP
包装: 带卷 (TR)
工作温度: -40°C ~ 125°C
LT3474/LT3474-1
APPLICATIONS INFORMATION
( V IN SW F V )
Setting the Switching Frequency
The LT3474 uses a constant frequency architecture that
can be programmed over a 200kHz to 2MHz range with a
single external timing resistor from the R T pin to ground.
DC =
( V OUT + V F )
– V +
V IN ( MIN ) =
– V F SW
V OUT + V F
The current that ?ows into the timing resistor is used
to charge an internal oscillator capacitor. A graph for
selecting the value of R T for a given operating frequency
is shown in the Typical Performance Characteristics
section. Table 1 shows suggested R T selections for a
variety of switching frequencies.
Table 1. Switching Frequencies
SWITCHING FREQUENCY (MHz) R T (k Ω)
where V F is the forward voltage drop of the catch diode
(~0.4V) and V SW is the voltage drop of the internal switch
(~0.4V at maximum load). This leads to a minimum input
voltage of:
+ V
DC MAX
with DC MAX = 1–t OFF(MIN) ? f
2
1.5
1
0.7
0.5
10
18.7
33.2
52.3
80.6
where t 0FF(MIN) is equal to 200ns and f is the switching
frequency.
Example: f = 500kHz, V OUT = 4V
DC MAX = 1 ? 200 ns ? 500 kHz = 0 . 90
0.3
0.2
147
232
V IN ( MIN ) =
4 V + 0.4 V
0 .99
– 0 . 4 V + 0 . 4 V = 4 . 9 V
Operating Frequency Selection
The choice of operating frequency is determined by sev-
The maximum operating voltage is determined by the
absolute maximum ratings of the V IN and BOOST pins,
and by the minimum duty cycle.
eral factors. There is a tradeoff between ef?ciency and
component size. Higher switching frequency allows the
use of smaller inductors at the cost of increased switching
V IN ( MAX ) =
V OUT + V F
DC MIN
– V F + V SW
V IN ( MAX ) =
losses and decreased ef?ciency.
Another consideration is the maximum duty cycle. In
certain applications, the converter needs to operate at a
high duty cycle in order to work at the lowest input voltage
possible. The LT3474 has a ?xed oscillator off-time and
a variable on-time. As a result, the maximum duty cycle
increases as the switching frequency is decreased.
Input Voltage Range
The minimum operating voltage is determined either by the
LT3474’s undervoltage lockout of 4V, or by its maximum
duty cycle. The duty cycle is the fraction of time that the
internal switch is on and is determined by the input and
output voltages:
with DC MIN = t ON(MIN) ? f
where t ON(MIN) is equal to 160ns and f is the switching
frequency.
Example: f = 500kHz, V OUT = 2.5V
DC MIN = 160 ns ? 500 kHz = 0 . 08
2.5 V + 0.4 V
– 0 . 4 V + 0 . 4 V = 36 V
0 .008
The minimum duty cycle depends on the switching fre-
quency. Running at a lower switching frequency might
allow a higher maximum operating voltage. Note that this
is a restriction on the operating input voltage; the circuit
will tolerate transient inputs up to the Absolute Maximum
Rating.
3474fd
10
相关PDF资料
PDF描述
LT3956EUHE#TRPBF IC LED DVR BUCK BOOST 36-VQFN
XLN3640-GL POWER SUPPLY PROGRAM DC 36V/40A
REC8-243.3SRW/H2/A/M CONV DC/DC 8W 24VIN 3.3VOUT
EBC13DRTH CONN EDGECARD 26POS DIP .100 SLD
P51-500-A-R-M12-4.5OVP-000-000 SENSOR 500PSI M12-1.0 6G .5-4.5V
相关代理商/技术参数
参数描述
LT3474IFE-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Step-Down 1A LED Driver
LT3474IFE-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Step-Down 1A LED Driver
LT3475 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475-1 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver
LT3475EFE 制造商:Linear Technology 功能描述:LED DRVR 2Segment 5V/9V/12V/15V/18V/24V 20-Pin TSSOP EP