- 您现在的位置：买卖IC网 > PDF目录20862 > LT3474IFE-1#TRPBF (Linear Technology)IC LED DRVR HP CONS CURR 16TSSOP PDF资料下载
参数资料
| 型号： | LT3474IFE-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/20页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR HP CONS CURR 16TSSOP |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 拓扑： | PWM，降压（降压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载，背光 |
| 类型 - 次要： | 颜色，白色 LED |
| 频率： | 200kHz ~ 2MHz |
| 电源电压： | 3.5 V ~ 36 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 供应商设备封装： | 16-TSSOP-EP |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 125°C |
LT3474/LT3474-1
APPLICATIONS INFORMATION
To minimize the error from variations in V ADJ pin current,
use resistors with a parallel resistance of less than 4k. Use
resistors with a series resistance of 5.11k or greater so as
not to exceed the 250μA current limit on the REF pin.
Dimming Control
There are several different types of dimming control cir-
cuits. One dimming control circuit (Figure 6) changes the
voltage on the V ADJ pin by tying a low on-resistance FET to
the resistor divider string. This allows the selection of two
different LED currents. For reliable operation, program an
LED current of no less than 35mA. The maximum current
the C-RC string (tied to the V C pin) shown in Figure 7 for
proper operation during start-up. When the PWM pin goes
high again, the LED current returns rapidly to its previous
on state since the compensation and output capacitors are
at the correct voltage. This fast settling time allows The
LT3474 to maintain diode current regulation with PWM
pulse widths as short as 40μs. If the NFET is omitted and
the cathode of the LED is instead tied to GND, use PWM
pulse widths of 1ms or greater. The maximmum PWM
dimming ratio (PWM RATIO ) can be calculated from the
maximum PWM period (t MAX ) and minimum PWM pulse
width (t MIN ) as follows:
dimming ratio (I RATIO ) can be calculated from the maxi-
mum LED current (I MAX ) and the minimum LED current
(I MIN ) as follows:
t MAX
t MIN
= PWM RATIO
I MAX
I MIN
= I RATIO
Total dimming ratio (DIM RATIO ) is the product of the PWM
dimming ratio and the current dimming ratio.
I RATIO = = 10:1
Anotherdimmingcontrolcircuit(Figure7)usesthePWM
pin and an external NFET tied to the cathode of the LED.
When the PWM signal goes low, the NFET turns off, turn-
Example: I MAX = 1A, I MIN = 0.1A, t MAX = 12ms, t MIN = 40μs
1A
0.1A
ing off the LED and leaving the output capacitor charged.
The PWM pin is pulled low as well, which disconnects the
PWM RATIO =
12ms
40 μ s
= 300:1
V C pin, storing the voltage in the capacitor tied there. Use
REF
DIM RATIO = 10 ? 300 = 3000:1
R1
LT3474
PWM
R2
V ADJ
GND
60Hz TO
10kHz
PWM
LT3474
DIM
3474 F05
LED
GND
3.3nF
10k
0.1μF
3474 F06
Figure 6. Dimming with an NFET and Resistor Divider
Figure 7. Dimming Using PWM Signal
3474fd
16
相关PDF资料 |
PDF描述 |
|---|---|
| LT3956EUHE#TRPBF | IC LED DVR BUCK BOOST 36-VQFN |
| XLN3640-GL | POWER SUPPLY PROGRAM DC 36V/40A |
| REC8-243.3SRW/H2/A/M | CONV DC/DC 8W 24VIN 3.3VOUT |
| EBC13DRTH | CONN EDGECARD 26POS DIP .100 SLD |
| P51-500-A-R-M12-4.5OVP-000-000 | SENSOR 500PSI M12-1.0 6G .5-4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3474IFE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Step-Down 1A LED Driver |
| LT3474IFE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Step-Down 1A LED Driver |
| LT3475 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver |
| LT3475-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Step-Down l 1.5A LED Driver |
| LT3475EFE | 制造商:Linear Technology 功能描述:LED DRVR 2Segment 5V/9V/12V/15V/18V/24V 20-Pin TSSOP EP |
发布紧急采购，3分钟左右您将得到回复。