- 您现在的位置：买卖IC网 > PDF目录13956 > LT3480EDD#TRPBF (Linear Technology)IC REG BUCK ADJ 2A 10DFN PDF资料下载
参数资料
| 型号： | LT3480EDD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2A 10DFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.79 V ~ 20 V |
| 输入电压： | 3.6 V ~ 36 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 200kHz ~ 2.4MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-DFN（3x3） |
LT3480
APPLICATIONS INFORMATION
g m = 3.5mho
ESR
C1
+
V C
GND
CeramicCapacitors
Ceramic capacitors are small, robust and have very low
ESR. However, ceramic capacitors can cause problems
when used with the LT3480 due to their piezoelectric nature.
When in Burst Mode operation, the LT3480’s switching
frequency depends on the load current, and at very light
loads the LT3480 can excite the ceramic capacitor at audio
frequencies, generating audible noise. Since the LT3480
operates at a lower current limit during Burst Mode
operation, the noise is typically very quiet to a casual ear.
If this is unacceptable, use a high performance tantalum
or electrolytic capacitor at the output.
A final precaution regarding ceramic capacitors concerns
the maximum input voltage rating of the LT3480. A ceramic
input capacitor combined with trace or cable inductance
forms a high quality (under damped) tank circuit. If the
LT3480 circuit is plugged into a live supply, the input volt-
age can ring to twice its nominal value, possibly exceeding
the LT3480’s rating. This situation is easily avoided (see
the Hot Plugging Safely section).
Frequency Compensation
The LT3480 uses current mode control to regulate the
output. This simplifies loop compensation. In particular, the
LT3480 does not require the ESR of the output capacitor
for stability, so you are free to use ceramic capacitors to
achieve low output ripple and small circuit size. Frequency
compensation is provided by the components tied to the
V C pin, as shown in Figure 2. Generally a capacitor (C C )
and a resistor (R C ) in series to ground are used. In addi-
tion, there may be lower value capacitor in parallel. This
capacitor (C F ) is not part of the loop compensation but
is used to filter noise at the switching frequency, and is
required only if a phase-lead capacitor is used or if the
output capacitor has high ESR.
this data sheet that is similar to your application and tune
the compensation network to optimize the performance.
Stability should then be checked across all operating
conditions, including load current, input voltage and
temperature. The LT1375 data sheet contains a more
thorough discussion of loop compensation and describes
how to test the stability using a transient load. Figure 2
shows an equivalent circuit for the LT3480 control loop.
The error amplifier is a transconductance amplifier with
finite output impedance. The power section, consisting
of the modulator, power switch and inductor, is modeled
as a transconductance amplifier generating an output
current proportional to the voltage at the V C pin. Note that
the output capacitor integrates this current, and that the
capacitor on the V C pin (C C ) integrates the error amplifier
output current, resulting in two poles in the loop. In most
cases a zero is required and comes from either the output
capacitor ESR or from a resistor R C in series with C C .
This simple model works well as long as the value of the
inductor is not too high and the loop crossover frequency
is much lower than the switching frequency. A phase lead
capacitor (C PL ) across the feedback divider may improve
the transient response. Figure 3 shows the transient
response when the load current is stepped from 500mA
to 1500mA and back to 500mA.
LT3480
CURRENT MODE SW
POWER STAGE OUTPUT
ERROR
AMPLIFIER R1 C PL
FB
g m =
420μmho
0.8V
3M
C1
POLYMER CERAMIC
OR
TANTALUM
Loop compensation determines the stability and transient
performance. Designing the compensation network is
a bit complicated and the best values depend on the
application and in particular the type of output capacitor.
A practical approach is to start with one of the circuits in
C F
R C
C C
R2
Figure 2. Model for Loop Response
3480 F02
3480fe
For more information www.linear.com/LT3480
13
相关PDF资料 |
PDF描述 |
|---|---|
| HM73-106R0LFTR13 | INDUCTOR 6.0UH LOW PRO SHLD SMD |
| ESM28DRXH | CONN EDGECARD 56POS DIP .156 SLD |
| HM73-151R5LFTR13 | INDUCTOR 1.5UH LOW PRO SHLD SMD |
| ECM43DRTI | CONN EDGECARD 86POS DIP .156 SLD |
| HM55-21R95LF | SHIELDED DRUM COMPACT INDUCTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3480EMSE | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2A, 2.4MHz Step-Down Switching Regulator with 70μA Quiescent Current |
| LT3480EMSE#PBF | 功能描述:IC REG BUCK ADJ 2A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3480EMSE#PBF | 制造商:Linear Technology 功能描述:DC/DC Converter IC 制造商:Linear Technology 功能描述:IC, BUCK REGULATOR, MSOP-10 |
| LT3480EMSE#TRPBF | 功能描述:IC REG BUCK ADJ 2A 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3480EMSEPBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single-Out Step Down |
发布紧急采购，3分钟左右您将得到回复。