- 您现在的位置：买卖IC网 > PDF目录14815 > LT3481EMSE#PBF (Linear Technology)IC REG BUCK ADJ 2A 10MSOP PDF资料下载
参数资料
| 型号： | LT3481EMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2A 10MSOP |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.27 V ~ 20 V |
| 输入电压： | 3.6 V ~ 34 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 300kHz ~ 2.8MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
LT3481
OPERATION
The LT3481 is a constant frequency, current mode step-
down regulator. An oscillator, with frequency set by RT,
enables an RS ?ip-?op, turning on the internal power
switch. An ampli?er and comparator monitor the current
?owing between the V IN and SW pins, turning the switch
off when this current reaches a level determined by the
voltage at V C . An error ampli?er measures the output
voltage through an external resistor divider tied to the FB
pin and servos the V C pin. If the error ampli?er’s output
increases, more current is delivered to the output; if it
decreases, less current is delivered. An active clamp on the
V C pin provides current limit. The V C pin is also clamped to
the voltage on the RUN/SS pin; soft-start is implemented
by generating a voltage ramp at the RUN/SS pin using an
external resistor and capacitor.
An internal regulator provides power to the control cir-
cuitry. The bias regulator normally draws power from the
V IN pin, but if the BIAS pin is connected to an external
voltage higher than 3V bias power will be drawn from the
external source (typically the regulated output voltage).
This improves ef?ciency. The RUN/SS pin is used to place
the LT3481 in shutdown, disconnecting the output and
The switch driver operates from either the input or from
the BOOST pin. An external capacitor and diode are used
to generate a voltage at the BOOST pin that is higher than
the input supply. This allows the driver to fully saturate
the internal bipolar NPN power switch for ef?cient
operation.
To further optimize ef?ciency, the LT3481 automatically
switches to Burst Mode operation in light load situations.
Between bursts, all circuitry associated with controlling
the output switch is shut down reducing the input supply
current to 50μA in a typical application.
The oscillator reduces the LT3481’s operating frequency
when the voltage at the FB pin is low. This frequency
foldback helps to control the output current during startup
and overload.
The LT3481 contains a power good comparator which trips
when the FB pin is at 91% of its regulated value. The PG
output is an open-collector transistor that is off when the
output is in regulation, allowing an external resistor to pull
the PG pin high. Power good is valid when the LT3481 is
enabled and V IN is above 3.6V.
reducing the input current to less than 1μA.
3481fc
8
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J5N-EY-F3 | CONVERTER MOD DC/DC 18.5V 50W |
| VI-JVT-EY-F4 | CONVERTER MOD DC/DC 6.5V 50W |
| 380LX222M050J202 | CAP ALUM 2200UF 50V 20% SNAP |
| VI-J5M-EY-F2 | CONVERTER MOD DC/DC 10V 50W |
| EYM28DTKH | CONN EDGECARD 56POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3481EMSE-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2A, 2.8MHz Step-Down Switching Regulator with 50μA Quiescent Current |
| LT3481EMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2A, 2.8MHz Step-Down Switching Regulator with 50μA Quiescent Current |
| LT3481HDD | 制造商:Linear Technology 功能描述:SW REG 36V 2A 2.8MHZ SD 10DFN |
| LT3481HDD#PBF | 功能描述:IC REG BUCK ADJ 2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3481HDD#PBF | 制造商:Linear Technology 功能描述:SW REG 36V 2A 2.8MHZ SD 10DFN |
发布紧急采购，3分钟左右您将得到回复。