- 您现在的位置：买卖IC网 > PDF目录14815 > LT3481EMSE#PBF (Linear Technology)IC REG BUCK ADJ 2A 10MSOP PDF资料下载
参数资料
| 型号： | LT3481EMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2A 10MSOP |
| 标准包装： | 50 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.27 V ~ 20 V |
| 输入电压： | 3.6 V ~ 34 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 300kHz ~ 2.8MHz |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
LT3481
APPLICATIONS INFORMATION
R 1 = R 2 ? OUT – 1 ?
DC MIN SW t ON ( MIN )
DC MAX SW t OFF ( MIN )
FB Resistor Network
The output voltage is programmed with a resistor divider
between the output and the FB pin. Choose the 1% resis-
tors according to:
? V ?
? 1 . 265 ?
Reference designators refer to the Block Diagram.
Setting the Switching Frequency
The LT3481 uses a constant frequency PWM architecture
that can be programmed to switch from 300kHz to 2.8MHz
by using a resistor tied from the RT pin to ground. A table
showing the necessary R T value for a desired switching
frequency is in Figure 1.
where V IN is the typical input voltage, V OUT is the output
voltage, is the catch diode drop (~0.5V), V SW is the internal
switch drop (~0.5V at max load). This equation shows
that slower switching frequency is necessary to safely
accommodate high V IN /V OUT ratio. Also, as shown in
the next section, lower frequency allows a lower dropout
voltage. The reason input voltage range depends on the
switching frequency is because the LT3481 switch has
?nite minimum on and off times. The switch can turn on
for a minimum of ~150ns and turn off for a minimum of
~150ns. This means that the minimum and maximum
duty cycles are:
= f
= 1– f
SWITCHING FREQUENCY (MHz)
0.2
0.3
0.4
0.6
0.8
1.0
1.2
1.4
1.6
1.8
2.0
2.2
2.4
2.6
2.8
R T VALUE (k Ω )
267
187
133
84.5
60.4
45.3
36.5
29.4
23.7
20.5
16.9
14.3
12.1
10.2
8.66
where f SW is the switching frequency, the t ON(MIN) is the
minimum switch on-time (~150ns), and the t OFF(MIN) is
the minimum switch off-time (~150ns). These equations
show that duty cycle range increases when switching
frequency is decreased.
A good choice of switching frequency should allow ad-
equate input voltage range (see next section) and keep
the inductor and capacitor values small.
Input Voltage Range
The maximum input voltage for LT3481 applications
depends on switching frequency, the absolute maximum
V IN ( MAX ) =
+ V
Figure 1. Switching Frequency vs R T Value
Operating Frequency Trade-Offs
Selection of the operating frequency is a trade-off between
ef?ciency, component size, minimum dropout voltage, and
maximum input voltage. The advantage of high frequency
operation is that smaller inductor and capacitor values may
be used. The disadvantages are lower ef?ciency, lower
maximum input voltage, and higher dropout voltage. The
highest acceptable switching frequency (f SW(MAX) ) for a
given application can be calculated as follows:
ratings on V IN and BOOST pins, and on operating mode.
If the output is in start-up or short-circuit operating modes,
then V IN must be below 34V and below the result of the
following equation:
V OUT + V D
– V D SW
f SW t ON ( MIN )
where V IN(MAX) is the maximum operating input voltage,
V OUT is the output voltage, V D is the catch diode drop
(~0.5V), V SW is the internal switch drop (~0.5V at max
t ON ( MIN ) ( V D IN SW )
f SW ( MAX ) =
V D + V OUT
+ V – V
load), f SW is the switching frequency (set by R T ), and
t ON(MIN) is the minimum switch on-time (~150ns). Note that
a higher switching frequency will depress the maximum
operating input voltage. Conversely, a lower switching
3481fc
9
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J5N-EY-F3 | CONVERTER MOD DC/DC 18.5V 50W |
| VI-JVT-EY-F4 | CONVERTER MOD DC/DC 6.5V 50W |
| 380LX222M050J202 | CAP ALUM 2200UF 50V 20% SNAP |
| VI-J5M-EY-F2 | CONVERTER MOD DC/DC 10V 50W |
| EYM28DTKH | CONN EDGECARD 56POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3481EMSE-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2A, 2.8MHz Step-Down Switching Regulator with 50μA Quiescent Current |
| LT3481EMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:36V, 2A, 2.8MHz Step-Down Switching Regulator with 50μA Quiescent Current |
| LT3481HDD | 制造商:Linear Technology 功能描述:SW REG 36V 2A 2.8MHZ SD 10DFN |
| LT3481HDD#PBF | 功能描述:IC REG BUCK ADJ 2A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3481HDD#PBF | 制造商:Linear Technology 功能描述:SW REG 36V 2A 2.8MHZ SD 10DFN |
发布紧急采购，3分钟左右您将得到回复。