- 您现在的位置：买卖IC网 > PDF目录14163 > LT3495BEDDB#TRMPBF (Linear Technology)IC REG BOOST ADJ 0.65A 10DFN PDF资料下载
参数资料
| 型号： | LT3495BEDDB#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST ADJ 0.65A 10DFN |
| 标准包装： | 1 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.24 V ~ 40 V |
| 输入电压： | 2.3 V ~ 16 V |
| PWM 型： | 混合物 |
| 电流 - 输出： | 650mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 10-DFN-EP（3x2） |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
| 其它名称： | LT3495BEDDB#TRMPBFDKR |
LT3495/LT3495B/
LT3495-1/LT3495B-1
APPLICATIONS INFORMATION
R1 = 76 ? ? OUT – 1 ? k Ω
SettingOutputVoltageandtheAuxiliaryReference
Input
The LT3495 series is equipped with both an internal
1.235V reference and an auxiliary reference input. This
allows the user to select between using the built-in refer-
ence and supplying an external reference voltage. The
voltage at the CTRL pin can be adjusted while the chip is
operating to alter the output voltage for purposes such
as display dimming or contrast adjustment. To use the
internal 1.235V reference, the CTRL pin must be held
higher than 1.5V. When the CTRL pin is held between 0V
and 1.235V, the parts will regulate the output such that
the FB pin voltage is nearly equal to the CTRL pin voltage.
At CTRL voltages close to 1.235V, a soft transition occurs
between the CTRL pin and the internal reference. Figure 1
shows this behavior.
To set the maximum output voltage, select the values of
R1 according to the following equation:
? V ?
? 1.235 ?
When CTRL is used to override the internal reference,
the output voltage can be lowered from the maximum
value down to nearly the input voltage level. If the volt-
age source driving the CTRL pin is located at a distance
to the LT3495, a small 0.1μF capacitor may be needed to
bypass the pin locally.
Choosing a Feedback Node
The single feedback resistor may be connected to the
V OUT pin or to the CAP pin (see Figure 2). Regulating the
V OUT pin eliminates the output offset resulting from the
voltage drop across the output disconnect PMOS. Regu-
lating the CAP pin does not compensate for the voltage
drop across the output disconnect, resulting in an output
voltage V OUT that is slightly lower than the voltage set by
the resistor divider. Under most conditions, it is advised
that the feedback resistor be tied to the V OUT pin.
Connecting the Load to the CAP Node
The efficiency of the converter can be improved by con-
necting the load to the CAP pin instead of the V OUT pin.
The power loss in the PMOS disconnect circuit is then
made negligible. By connecting the feedback resistor to
the V OUT pin, no quiescent current will be consumed in the
feedback resistor string during shutdown since the PMOS
transistor will be open (see Figure 3). The disadvantage
of this method is that the CAP node cannot go to ground
during shutdown, but will be limited to around a diode
drop below V CC . Loads connected to the part should only
sink current. Never force external power supplies onto
the CAP or V OUT pins.
C1 C1
SW CAP SW CAP
V CC V OUT V OUT V CC V OUT
LT3495
R1
C3
LT3495
R1
1.5
SHDN
CTRL
FB
GND
SHDN
CTRL
FB
GND
1.2
0.9
0.6
Figure 2. Feedback Connection Using
the CAP Pin or the V OUT Pin
3495 F02
0.3
SW
V CC
CAP
V OUT
C1
I LOAD
LT3495
0
0
0.3
0.6
0.9
1.2
1.5
SHDN
FB
CTRL VOLTAGE (V)
CTRL
GND
3495 F01
Figure 1. CTRL to FB Transfer Curve
3495 F03
Figure 3. Improved Efficiency Connection
3495b1b1fa
10
相关PDF资料 |
PDF描述 |
|---|---|
| ESC10DTEI | CONN EDGECARD 20POS .100 EYELET |
| EMC13DRAS | CONN EDGECARD 26POS R/A .100 SLD |
| LNX2V682MSEH | CAP ALUM 6800UF 350V 20% SCREW |
| ECC60DCMS | CONN EDGECARD 120POS .100 WW |
| LNX2V682MSEG | CAP ALUM 6800UF 350V 20% SCREW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3495BEDDB-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:650mA/350mA Micropower Low Noise Boost Converter with Output Disconnect |
| LT3495EDDB#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER BOOST DFN-10 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BOOST, DFN-10 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BOOST, DFN-10, Primary Input Voltage:16V, No. of Outputs:1, No. of Pins:10, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited, Package / Case:10-DFN , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape Micropower 650mA (|sw) Low Noise Boost Converter w |
| LT3495EDDB#TRMPBF | 功能描述:IC REG BOOST ADJ 0.65A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
| LT3495EDDB#TRPBF | 功能描述:IC REG BOOST ADJ 0.65A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LT3495EDDB-1#TRMPBF | 功能描述:IC REG BOOST ADJ 0.35A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。