- 您现在的位置：买卖IC网 > PDF目录14163 > LT3495BEDDB#TRMPBF (Linear Technology)IC REG BOOST ADJ 0.65A 10DFN PDF资料下载
参数资料
| 型号： | LT3495BEDDB#TRMPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST ADJ 0.65A 10DFN |
| 标准包装： | 1 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.24 V ~ 40 V |
| 输入电压： | 2.3 V ~ 16 V |
| PWM 型： | 混合物 |
| 电流 - 输出： | 650mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 10-DFN-EP（3x2） |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
| 其它名称： | LT3495BEDDB#TRMPBFDKR |
LT3495/LT3495B/
LT3495-1/LT3495B-1
APPLICATIONS INFORMATION
V IN ? 200 ? 10 –9
I PK = I LIMIT + amps
MaximumOutputLoadCurrent
The maximum output current of a particular LT3495 series
circuit is a function of several circuit variables. The fol-
lowing method can be helpful in predicting the maximum
load current for a given circuit:
Step 1: Calculate the peak inductor current:
L
where I LIMIT is 0.65A and 0.35A for LT3495/LT3495B and
LT3495-1/LT3495B-1 respectively. L is the inductance
value in Henrys and V IN is the input voltage to the boost
circuit.
Step 2: Calculate the inductor ripple current:
I RIPPLE = ( V OUT + 1– V IN ) ? 200 ? 10 –9 amps
L
where V OUT is the desired output voltage. If the inductor
ripple current is greater than the peak current, then the
circuit will only operate in discontinuous conduction mode.
The inductor value should be increased so that I RIPPLE < I PK .
An application circuit can be designed to operate only in
discontinuous mode, but the output current capability
will be reduced.
Step 3: Calculate the average input current:
Inrush Current
When V CC is stepped from ground to the operating voltage
while the output capacitor is discharged, a higher level of
inrush current may flow through the inductor and Schottky
diode into the output capacitor. Conditions that increase
inrush current include a larger more abrupt voltage step
at V IN , a larger output capacitor tied to the CAP pin and an
inductor with a low saturation current. While the chip is
designed to handle such events, the inrush current should
not be allowed to exceed 1.5A. For circuits that use output
capacitor values within the recommended range and have
input voltages of less than 5V, inrush current remains low,
posing no hazard to the device. In cases where there are
large steps at V CC (more than 5V) and/or a large capacitor
is used at the CAP pin, inrush current should be measured
to ensure safe operation.
Soft-Start
By connecting the SHDN and CTRL pins as shown in
Figure 4, using an RC filter at the CTRL pin to limit the
start-up current, the LT3495 is able to achieve soft-start.
The small bias current of the CTRL pin allows using a
small capacitor for a large RC time constant. The soft-
start waveform is shown in Figure 5. The soft-start time
SW CAP
V CC V OUT
I IN(AVG) = I PK –
I RIPPLE
2
amps
CHIP ENABLE
R CTRL
LT3495
SHDN FB
CTRL GND
Step 4: Calculate the nominal output current:
C CTRL
3495 F04
I OUT(NOM) =
I IN(AVG) ? V IN ? 0.8
V OUT
amps
Figure 4. Soft-Start Circuitry
Step 5: Derate output current:
I OUT = I OUT(NOM) ? 0.8 amps
SHDN VOLTAGE
5V/DIV
INDUCTOR CURRENT
500mA/DIV
For low output voltages the output current capability will
be increased. When using output disconnect (load cur-
rent taken from V OUT ), these higher currents will cause
the drop in the PMOS switch to be higher resulting in
reduced output current capability than those predicted
by the preceding equations.
CTRL VOLTAGE
2V/DIV
V OUT VOLTAGE
5V/DIV
500μs/DIV
V CC = 3.6V 3495 F05
V OUT = 16V
Figure 5. Soft-Start Waveform
3495b1b1fa
11
相关PDF资料 |
PDF描述 |
|---|---|
| ESC10DTEI | CONN EDGECARD 20POS .100 EYELET |
| EMC13DRAS | CONN EDGECARD 26POS R/A .100 SLD |
| LNX2V682MSEH | CAP ALUM 6800UF 350V 20% SCREW |
| ECC60DCMS | CONN EDGECARD 120POS .100 WW |
| LNX2V682MSEG | CAP ALUM 6800UF 350V 20% SCREW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3495BEDDB-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:650mA/350mA Micropower Low Noise Boost Converter with Output Disconnect |
| LT3495EDDB#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER BOOST DFN-10 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BOOST, DFN-10 制造商:Linear Technology 功能描述:DC-DC CONVERTER, BOOST, DFN-10, Primary Input Voltage:16V, No. of Outputs:1, No. of Pins:10, Operating Temperature Min:-40C, Operating Temperature Max:125C, MSL:MSL 1 - Unlimited, Package / Case:10-DFN , RoHS Compliant: Yes 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape Micropower 650mA (|sw) Low Noise Boost Converter w |
| LT3495EDDB#TRMPBF | 功能描述:IC REG BOOST ADJ 0.65A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
| LT3495EDDB#TRPBF | 功能描述:IC REG BOOST ADJ 0.65A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LT3495EDDB-1#TRMPBF | 功能描述:IC REG BOOST ADJ 0.35A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
发布紧急采购，3分钟左右您将得到回复。