- 您现在的位置：买卖IC网 > PDF目录20886 > LT3497EDDB#TRPBF (Linear Technology)IC LED DRIVR WHITE BCKLGT 10-DFN PDF资料下载
参数资料
| 型号： | LT3497EDDB#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR WHITE BCKLGT 10-DFN |
| 标准包装： | 2,500 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 2 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 1.8MHz ~ 2.8MHz |
| 电源电压： | 2.5 V ~ 10 V |
| 输出电压： | 35V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN-EP（3x2） |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
LT3497
OPERATION
Main Control Loop
The LT3497 uses a constant frequency, current mode con-
trol scheme to provide excellent line and load regulation.
It incorporates two identical, but fully independent PWM
converters. Operation can be best understood by referring
to the Block Diagram in Figure 1. The oscillator, start-up
bias and the band gap reference are shared between the two
converters. The control circuitry, power switch, Schottky
diode etc., are identical for both the converters.
At power up, the capacitors at CAP1 and CAP2 pins are
charged up to V IN (input supply voltage) via their respective
inductor and the internal Schottky diode. If either CTRL1
and CTRL2 or both are pulled higher than 100mV, the
bandgap reference, the start-up bias and the oscillator
are turned on.
The main control loop can be understood by following the
operation of converter 1. At the start of each oscillator cycle,
the power switch, Q1, is turned on. A voltage proportional
to the switch current is added to a stabilizing ramp and the
resulting sum is fed into the positive terminal of the PWM
comparator, A2. When this voltage exceeds the level at the
negative input of A2, the PWM logic turns off the power
switch. The level at the negative input of A2 is set by the
error ampli?er, A1, and is simply an ampli?ed version of
the difference between the V CAP1 and V LED1 voltage and
the bandgap reference. In this manner the error ampli?er,
I L
50mA/DIV
V SW
10V/DIV
A1, sets the correct peak current level in inductor L1 to
keep the output in regulation. The CTRL1 pin is used to
adjust the LED current.
If only one of the converters is turned on, the other converter
will stay off and its output will remain charged up to V IN
(input supply voltage). The LT3497 enters into shutdown
when both CTRL1 and CTRL2 pins are pulled lower than
50mV. The CTRL1 and CTRL2 pins perform independent
dimming and shutdown control for the two converters.
Minimum Output Current
The LT3497 can drive a 4-LED string at 2mA LED current
without pulse skipping. As current is further reduced, the
device may begin skipping pulses.
This will result in some low frequency ripple, although the
average LED current remains regulated down to zero. The
photo in Figure 2 details circuit operation driving 4 white
LEDs at 2mA. Peak inductor current is less than 50mA and
the regulator operates in discontinuous mode, meaning
the inductor current reaches zero during the discharge
phase. After the inductor current reaches zero, the SW
pin exhibits ringing due to the LC tank circuit formed
by the inductor in combination with the switch and the
diode capacitance. This ringing is not harmful; far less
spectral energy is contained in the ringing than in the
switch transitions.
V IN = 4.2V
200ns/DIV
3497 F02
I LED = 2mA
4 LEDs
Figure 2. Switching Waveforms
3497f
8
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3217EUD#PBF | IC LED DRVR FLASH TORCH 16QFN |
| LTC3210EUD-1#PBF | IC LED DRIVR WHITE BCKLGT 16-QFN |
| P51-200-S-B-MD-4.5V-000-000 | SENSOR 200PSI 1/8-27NPT .5-4.5V |
| P51-1000-S-S-D-4.5V-000-000 | SENSOR 1000PSI 1/4-18NPT .5-4.5V |
| P51-1000-A-D-M12-4.5OVP-000-000 | SENSOR 1000PSI 7/16-20UNF 4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3498 | 制造商:LINER 制造商全称:Linear Technology 功能描述:20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN |
| LT3498EDDB | 制造商:LINER 制造商全称:Linear Technology 功能描述:20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN |
| LT3498EDDB#TRMPBF | 功能描述:IC LED DRVR WT/OLED BCKLGT 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3498EDDB#TRPBF | 功能描述:IC LED DRVR WT/OLED BCKLGT 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT34-SC | 制造商:THOMAS & BETTS 功能描述: |
发布紧急采购，3分钟左右您将得到回复。