- 您现在的位置：买卖IC网 > PDF目录98002 > LT3503EDCB (LINEAR TECHNOLOGY CORP) 1 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO6 PDF资料下载
参数资料
| 型号： | LT3503EDCB |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 1 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO6 |
| 封装： | 2 X 3 MM, PLASTIC, MO-229, DFN-6 |
| 文件页数： | 8/20页 |
| 文件大小： | 423K |
| 代理商： | LT3503EDCB |
16
LT3503
3503f
APPLICATIO S I FOR ATIO
WU
U
damps the circuit and eliminates the voltage overshoot.
The extra capacitor improves low frequency ripple filtering
and can slightly improve the efficiency of the circuit,
though it is likely to be the largest component in the circuit.
An alternative solution is shown in Figure 10c. A 1
resistor is added in series with the input to eliminate the
voltage overshoot (it also reduces the peak input current).
A 0.1
F capacitor improves high frequency filtering. This
solution is smaller and less expensive than the electrolytic
capacitor. For high input voltages its impact on efficiency
is minor, reducing efficiency less than one half percent for
a 5V output at full load operating from 20V.
Frequency Compensation
The LT3503 uses current mode control to regulate the
output. This simplifies loop compensation. In particular,
the LT3503 does not require the ESR of the output
capacitor for stability allowing the use of ceramic capaci-
tors to achieve low output ripple and small circuit size.
Figure 11 shows an equivalent circuit for the LT3503
control loop. The error amp is a transconductance ampli-
fier with finite output impedance. The power section,
consisting of the modulator, power switch and inductor,
is modeled as a transconductance amplifier generating an
output current proportional to the voltage at the VC node.
Note that the output capacitor integrates this current, and
that the capacitor on the VC node (CC) integrates the error
amplifier output current, resulting in two poles in the loop.
RC provides a zero. With the recommended output
capacitor, the loop crossover occurs above the RCCC zero.
This simple model works well as long as the value of the
inductor is not too high and the loop crossover frequency
is much lower than the switching frequency. With a larger
ceramic capacitor (very low ESR), crossover may be
lower and a phase lead capacitor (CPL) across the feed-
back divider may improve the phase margin and transient
response. Large electrolytic capacitors may have an ESR
large enough to create an additional zero, and the phase
lead may not be necessary.
If the output capacitor is different than the recommended
capacitor, stability should be checked across all operating
conditions, including load current, input voltage and tem-
perature. The LT1375 data sheet contains a more thor-
ough discussion of loop compensation and describes how
to test the stability using a transient load.
PCB Layout
For proper operation and minimum EMI, care must be
taken during printed circuit board layout. Figure 12 shows
the recommended component placement with trace,
ground plane and via locations. Note that large, switched
currents flow in the LT3503’s VIN and SW pins, the catch
diode (D1) and the input capacitor (C2). The loop formed
by these components should be as small as possible and
tied to system ground in only one place. These compo-
nents, along with the inductor and output capacitor,
should be placed on the same side of the circuit board, and
their connections should be made on that layer. Place a
Figure 11. Model for Loop Response
–
+
–
+
780mV
SW
VC
LT3503
GND
3503 F11
R1
OUT
ESR
ERROR
AMPLIFIER
CURRENT MODE
POWER STAGE
FB
R2
2M
RC
24k
CC
100pF
C1
gm =
200
A/V
gm =
1.1A/V
+
CPL
0.8V
相关PDF资料 |
PDF描述 |
|---|---|
| LT3585EDDB-2 | 0.95 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3585EDDB-0#TRMPDF | 1.3 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3585EDDB-3 | 1.85 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LT3587EUD#PBF | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
| LT3587EUD#TRPBF | SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PQCC20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3503EDCB#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP 制造商:Linear Technology 功能描述:REG SWITCHING STEP DOWN 1A 2.2MHZ 制造商:Linear Technology 功能描述:REG, SWITCHING, STEP DOWN, 1A 2.2MHZ 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, Cut Tape 1A, 2.2MHz Buck Regulator ;RoHS Compliant: Yes |
| LT3503EDCB#TR | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.6V to 20V 6-Pin DFN EP T/R |
| LT3503EDCB#TRMPBF | 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3503EDCB#TRPBF | 功能描述:IC REG BUCK ADJ 1A 6DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:1.24 V ~ 30 V 输入电压:1.5 V ~ 12 V PWM 型:电流模式，混合 频率 - 开关:600kHz 电流 - 输出:500mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:8-SOIC |
| LT3503EDCBTRMPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 3.6-20V DFN6EP |
发布紧急采购，3分钟左右您将得到回复。