- 您现在的位置：买卖IC网 > PDF目录79747 > LT3506AIDHD#TR (LINEAR TECHNOLOGY CORP) 3.6 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LT3506AIDHD#TR |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 3.6 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | 5 X 4 MM, PLASTIC, MO-229WJGD-2, DFN-16 |
| 文件页数： | 22/24页 |
| 文件大小： | 210K |
| 代理商： | LT3506AIDHD#TR |
LT3506/LT3506A
7
3506afc
The LT3506 is a dual, constant frequency, current mode
buck regulator with internal 2A power switches. The two
regulators share common circuitry including voltage
reference and oscillator. In addition, the analog blocks
on both regulators share the VIN1 supply voltage, but are
otherwise independent. This section describes the opera-
tion of the LT3506.
If the RUN/SS (run/soft-start) pins are both tied to ground,
the LT3506 is shut down and draws 30μA from VIN1.
Internal 2μA current sources charge external soft-start
capacitors, generating voltage ramps at these pins. If either
RUN/SS pin exceeds 0.6V, the internal bias circuits turn
on, including the internal regulator, 800mV reference and
575kHz master oscillator. In this state, the LT3506 draws
3.8mA from VIN1, whether one or both RUN/SS pins are
high. Neither switching regulator will begin to operate
until its RUN/SS pin reaches ~0.8V. The master oscillator
generates two clock signals of opposite phase.
The two switchers are current mode, step-down regulators.
This means that instead of directly modulating the duty
cycle of the power switch, the feedback loop controls the
peak current in the switch during each cycle. This cur-
rent mode control improves loop dynamics and provides
cycle-by-cycle current limit.
The Block Diagram in Figure 2 shows only one of the two
switching regulators. A pulse from the slave oscillator
sets the RS ip-op and turns on the internal NPN bipolar
power switch. Current in the switch and the external induc-
tor begins to increase. When this current exceeds a level
determined by the voltage at VC, current comparator C1
resets the ip-op, turning off the switch. The current in
the inductor ows through the external Schottky diode,
and begins to decrease. The cycle begins again at the next
pulse from the oscillator. In this way the voltage on the VC
pin controls the current through the inductor to the output.
The internal error amplier regulates the output voltage
by continually adjusting the VC pin voltage.
The threshold for switching on the VC pin is 0.75V, and an
active clamp of 1.9V limits the output current. The VC pin
is also clamped to the RUN/SS pin voltage. As the internal
current source charges the external soft-start capacitor,
the current limit increases slowly. Each switcher contains
an independent oscillator. This slave oscillator is normally
synchronized to the master oscillator. However, during
start-up, short-circuit or overload conditions, the FB pin
voltage will be near zero and an internal comparator gates
the master oscillator clock signal. This allows the slave
oscillator to run the regulator at a lower frequency. This
frequency foldback behavior helps to limit switch current
and power dissipation under fault conditions.
The switch driver operates from either the input or from
the BOOST pin. An external capacitor and diode are used
to generate a voltage at the BOOST pin that is higher than
the input supply. This allows the driver to fully saturate
the internal bipolar NPN power switch for efcient opera-
tion.
A power good comparator trips when the FB pin is at 90%
of its regulated value. The PG output is an open collector
transistor that is off when the output is in regulation, al-
lowing an external resistor to pull the PG pin high. Power
good is valid when the LT3506 is enabled (either RUN/SS
pin is high) and VIN is greater than ~3.4V.
(Refer to the Block Diagram)
OPERATION
相关PDF资料 |
PDF描述 |
|---|---|
| LT1460DCS8-10#TR1460 | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PDSO8 |
| LT1460FCMS8-5#PBF1460 | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 5 V, PDSO8 |
| LM4040DIZ-2.0/NOPB | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.048 V, PBCY3 |
| LTC692IN8#PBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDIP8 |
| LT1009CDRE4 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3506AIDHD-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 1.6A Step-Down Switching Regulator |
| LT3506AIFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 1.6A Step-Down Switching Regulator |
| LT3506AIFE#PBF | 功能描述:IC REG BUCK ADJ 1.6A DL 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3506AIFE#TRPBF | 功能描述:IC REG BUCK ADJ 1.6A DL 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3506AIFE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Monolithic 1.6A Step-Down Switching Regulator |
发布紧急采购，3分钟左右您将得到回复。