参数资料
| 型号： | LT3513EUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/22页 |
| 文件大小： | 0K |
| 描述： | IC REG 5-OUT FOR TFT-LCD 38QFN |
| 标准包装： | 52 |
| 应用： | 转换器，TFT，LCD |
| 输入电压： | 4.5 V ~ 30 V |
| 输出数： | 5 |
| 输出电压： | 0.8 V ~ 40 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 管件 |
| 产品目录页面： | 1332 (CN2011-ZH PDF) |
LT3513
OPERATION
( 1– DC ) ( V OUT + V F )
? I L =
? I L
I SW(PK) = I LPK = I OUT +
= 2.5A ? ( 1– 0.57 ? DC ) –
? I L ? I L
I OUT(MAX) = I LIM –
? I L
V RIPPLE = for ceramic capacitors, and
? I L
I C(RMS) =
? I
?
C OUT > 10 ? L ? ? LIM ?
Thecurrentintheinductorisatrianglewavewithanaverage
value equal to the load current. The peak switch current
is equal to the output current plus half the peak-to-peak
inductor ripple current. The LT3513 limits its switch cur-
rent in order to protect itself and the system from overload
faults. Therefore, the maximum output current that the
LT3513 will deliver depends on the switch current limit, the
inductor value, and the input and output voltages. When
the switch is off, the potential across the inductor is the
output voltage plus the catch diode drop. This gives the
peak-to-peak ripple current in the inductor:
L ? f
where f is the switching frequency of the LT3513 and L
is the value of the inductor. The peak inductor and switch
current is:
2
To maintain output regulation, this peak current must be
less than the LT3513’s switch current limit of I LIM . For SW1,
I LIM is at least 2A at DC = 0.35, and decreases linearly to
1.5A at DC = 0.75 as shown in the Typical Performance
Characteristics section. The maximum output current is
a function of the chosen inductor value:
2 2
Choosing an inductor value so that the ripple current is
small will allow a maximum output current near the switch
current limit. One approach to choosing the inductor is to
start with the simple rule given above, look at the available
inductors and choose one to meet cost or space goals.
Then use these equations to check that the LT3513 will
be able to deliver the required output current. Note again
that these equations assume that the inductor current is
continuous. Discontinuous operation occurs when I OUT
is less than Δ I L /2.
OUTPUT CAPACITOR SELECTION
For 5V and 3.3V outputs, a 10μF 6.3V ceramic capacitor
(X5R or X7R) at the output results in very low output volt-
age ripple and good transient response. Other types and
values will also work; the following discussion explores
tradeoffs in output ripple and transient performance.
The output capacitor filters the inductor current to gen-
erate an output with low voltage ripple. It also stores
energy in order satisfy transient loads and stabilizes the
LT3513’s control loop. Because the LT3513 operates at a
high frequency, minimal output capacitance is necessary.
In addition, the control loop operates well with or without
the presence of output capacitor series resistance (ESR).
Ceramic capacitors, which achieve very low output ripple
and small circuit size, are therefore an option.
You can estimate output ripple with the following
equations:
8 ? f ? C OUT
V RIPPLE = Δ I L ? ESR for electrolytic capacitors (tantalum
and aluminum)
where Δ I L is the peak-to-peak ripple current in the inductor.
The RMS content of this ripple is very low so the RMS
current rating of the output capacitor is usually not of
concern. It can be estimated with the formula:
12
Another constraint on the output capacitor is that it must
have greater energy storage than the inductor; if the stored
energy in the inductor transfers to the output, the resulting
voltage step should be small compared to the regulation
voltage. For a 5% overshoot, this requirement indicates:
2
? V OUT ?
3513fc
14
相关PDF资料 |
PDF描述 |
|---|---|
| LT1580IQ#TR | IC REGULATOR LDO ADJ 7A DDPAK-5 |
| LT1580IQ#TRPBF | IC LDO REGULATOR 7A ADJ DDPKA-5 |
| ECM18DWWI | CONN EDGECARD 36POS .156 SQ WW |
| RBM43DTKD-S288 | CONN EDGECARD 86POS .156 EXTEND |
| GBM43DRMI | CONN EDGECARD 86POS .156 SQ WW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3513EUHF-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2MHz High Current 5-Output Regulator for TFT-LCD Panels |
| LT3513IUHF#PBF | 功能描述:IC REG 5-OUT FOR TFT-LCD 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LT3513IUHF#TRPBF | 功能描述:IC REG 5-OUT FOR TFT-LCD 38QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LT3513IUHF-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2MHz High Current 5-Output Regulator for TFT-LCD Panels |
| LT3513IUHF-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:2MHz High Current 5-Output Regulator for TFT-LCD Panels |
发布紧急采购，3分钟左右您将得到回复。