- 您现在的位置：买卖IC网 > PDF目录79923 > LT3688EFE#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, PDSO24 PDF资料下载
参数资料
| 型号： | LT3688EFE#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, PDSO24 |
| 封装： | LEAD FREE, PLASTIC, TSSOP-24 |
| 文件页数： | 6/28页 |
| 文件大小： | 415K |
| 代理商： | LT3688EFE#TRPBF |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3688
14
3688f
APPLICATIONS INFORMATION
The LT3688 will regulate the output voltage at input volt-
ages greater than VIN(PS). For example, an application
with an output voltage of 3.3V and switching frequency
of 2.1MHz has a VIN(PS) of 12.7V, as shown in Figure 1.
Figure 2 shows operation at 27V. Output ripple and peak
inductor current have signicantly increased. A saturating
inductor may further reduce performance. In pulse skip
mode, the LT3688 skips switching pulses to maintain
output regulation. The LT3688 will also skip pulses at very
low load currents. VIN(PS) vs load current is plotted in the
Typical Performance section.
VOUT
50mV/DIV
(AC)
IL
500mA/DIV
2μs/DIV
3688 F01
Figure 1. Operation Below Pulse-Skipping
Voltage. VOUT = 3.3V and fSW = 2.1MHz
VOUT
50mV/DIV
(AC)
IL
500mA/DIV
2μs/DIV
3688 F02
Figure 2. Operation Above VIN(ps). VIN = 27V,
VOUT = 3.3V and fSW = 2.1MHz. Output Ripple
and Peak Inductor Current Increase
Minimum Operating Voltage Range
The minimum input voltage is determined either by the
LT3688’s minimum operating voltage of ~3.6V or by its
maximum duty cycle. The duty cycle is the fraction of
time that the internal switch is on and is determined by
the input and output voltages:
DC
=
VOUT + VF
VIN –VSW + VF
Unlike many xed frequency regulators, the LT3688 can
extend its duty cycle by remaining on for multiple cycles.
The LT3688 will not switch off at the end of each clock
cycle if there is sufcient voltage across the boost capacitor
(C3 in the Block Diagram). Eventually, the voltage on the
boost capacitor falls and requires refreshing. Circuitry
detects this condition and forces the switch to turn off,
allowing the inductor current to charge up the boost
capacitor. This places a limitation on the maximum duty
cycle as follows:
DCMAX = 90%
This leads to a minimum input voltage of:
VIN(MIN) =
VOUT + VF
DCMAX
–VF + VSW
where VF is the forward voltage drop of the catch diode
(~0.4V) and VSW is the voltage drop of the internal switch
(~0.3V at maximum load).
Example: ISW=0.8A and VOUT = 3.3V
VIN(MIN) =
3.3V
+ 0.4V
90%
– 0.4
+ 0.3V = 4V
For best performance in dropout, use a 1μF or larger
boost capacitor.
Inductor Selection and Maximum Output Current
A good rst choice for the inductor value is
L
= VOUT + VF
()
1.8MHz
fSW
where VF is the voltage drop of the catch diode (~0.4V),
fSW is in MHz, and L is in μH. The inductor’s RMS current
rating must be greater than the maximum load current
and its saturation current should be at least 30% higher.
For robust operation in fault conditions (start-up or short-
circuit) and high input voltage (>30V), use an 8.2μH or
greater inductor with a saturation rating of 2.2A, or higher.
For highest efciency, the series resistance (DCR) should
be less than 0.1Ω. Table 2 lists several vendors and types
that are suitable.
相关PDF资料 |
PDF描述 |
|---|---|
| LT3585EDDB-3#PBF | 1.85 A BATTERY CHARGE CONTROLLER, PDSO10 |
| LM385BDG4-2-5 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO8 |
| LSM-5/10-D12 | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| LTC6992CDCB-4#TRMPBF | 0.02 A SWITCHING CONTROLLER, PDSO6 |
| LMH6581VS/NOPB | 8-CHANNEL, CROSS POINT SWITCH, PQFP48 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3688EUF#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3688EUF#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3688EUFPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA Step-Down Switching Regulator with Power-On Reset |
| LT3688HFE#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3688HFE#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。