- 您现在的位置：买卖IC网 > PDF目录13917 > LT3688EFE#TRPBF (Linear Technology)IC REG BUCK ADJ 0.8A DL 24TSSOP PDF资料下载
参数资料
| 型号： | LT3688EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 0.8A DL 24TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 32.4 V |
| 输入电压： | 3.8 V ~ 36 V |
| PWM 型： | 电流模式，Burst Mode? |
| 频率 - 开关： | 500kHz ~ 2.1MHz |
| 电流 - 输出： | 800mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 24-TSSOP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3688
OPERATION
The LT3688 is a constant-frequency, current mode step-
down regulator with two reset timers and a watchdog
timer that perform microprocessor supervisory functions.
Operation can be best understood by referring to the Block
Diagram. Keeping the EN/UVLO pin at ground completely
shuts off the part drawing minimal current from the V IN
source. To turn on the internal bandgap and the rest of the
logic circuitry, raise the EN/UVLO pin above the accurate
threshold of 1.25V. Also, V IN needs to be higher than 3.5V
for the part to start switching.
Switching Regulator Operation
An oscillator, with frequency set by R T , enables an RS ?ip
?op, turning on the internal power switch. An ampli?er
and comparator monitor the current ?owing between the
V IN and SW pins, turning the switch off when this cur-
rent reaches a level determined by the voltage at V C . An
error ampli?er measures the output voltage through an
external resistor divider tied to the FB pin and servos the
V C voltage. If the error ampli?er’s output increases, more
current is delivered to the output; if it decreases, less
current is delivered. An active clamp on the V C voltage
provides current limit. The V C voltage is also controlled
by the internal soft-start circuit during start-up or after a
fault condition takes place.
An internal regulator provides power to the control cir-
cuitry. The internal regulator normally draws current from
the V IN pin, but if the BIAS pin is connected to an external
voltage higher than 3V, bias current will be drawn from the
external source (typically the regulated output voltage).
This improves ef?ciency. The BIAS pin also provides a
current path to the internal boost diode that charges up
the boost capacitor. The switch driver operates either from
the V IN or from the BST pin. An external capacitor is used
to generate a voltage at the BST pin that is higher than
the V IN supply. This allows the driver to fully saturate the
internal NPN power switch for ef?cient operation. To further
optimize ef?ciency, the LT3688 automatically switches to
Burst Mode operation in light load situations. Between
bursts, all circuitry associated with controlling the output
switch is shut down, reducing the input supply current to
115μA in a typical application.
A comparator monitors the current ?owing through the
catch diode via the DA pin. This comparator delays switch-
ing if the diode current goes higher than 1.2A (typical)
during a fault condition such as a shorted output with high
input voltage. Switching will only resume once the diode
current has fallen below the 1.2A limit. This way the DA
comparator regulates the valley current of the inductor
to 1.2A during short circuit. This will ensure that the part
will survive a short-circuit event.
Power-On Reset and Watchdog Timer Operation
The LT3688 has two power-on reset comparators that
monitor the regulated output voltages. If V OUT is 10%
below the regulation value, the RST pin is pulled low. Once
the output voltage crosses over 90% of the regulation
value, a reset timer is started and RST is released after
the programmed reset delay time. The reset delay is
programmable through the C POR pin.
The watchdog typically monitors a microprocessor’s
activity. The watchdog can be enabled or disabled by ap-
plying a logic signal to the WDE pin. The watchdog timer
requires successive negative edges on the WDI pin to
come within a programmed time window to keep WDO
from going low. If the time between the two negative WDI
edges is too short or too long, then the WDO pin will be
pulled low. When the WDO pin goes low, it stays low for
a time period equivalent to 1/8th of the watchdog window
upper boundary. The WDO pin will go high again once the
timer expires or if the RST pin goes low. The watchdog
window upper and lower boundaries can be set through
the C WDT pin.
3688f
10
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6720AUTTZD6+T | IC SUPERVISOR MPU SOT23-6 |
| USR0G470MDD | CAP ALUM 47UF 4V 20% RADIAL |
| RGM10DTAN | CONN EDGECARD 20POS R/A .156 SLD |
| VI-J3V-EY-S | CONVERTER MOD DC/DC 5.8V 50W |
| USA1V4R7MDD | CAP ALUM 4.7UF 35V 20% RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3688EUF#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3688EUF#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3688EUFPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA Step-Down Switching Regulator with Power-On Reset |
| LT3688HFE#PBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3688HFE#TRPBF | 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。