参数资料
型号: LT3688EFE#TRPBF
厂商: Linear Technology
文件页数: 14/28页
文件大小: 0K
描述: IC REG BUCK ADJ 0.8A DL 24TSSOP
标准包装: 2,500
类型: 降压(降压)
输出类型: 可调式
输出数: 2
输出电压: 0.8 V ~ 32.4 V
输入电压: 3.8 V ~ 36 V
PWM 型: 电流模式,Burst Mode?
频率 - 开关: 500kHz ~ 2.1MHz
电流 - 输出: 800mA
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 24-TSSOP(0.173",4.40mm)裸露焊盘
包装: 带卷 (TR)
供应商设备封装: 24-TSSOP
LT3688
APPLICATIONS INFORMATION
V IN(MIN) = OUT
– V F + V SW
The LT3688 will regulate the output voltage at input volt-
ages greater than V IN(PS) . For example, an application
with an output voltage of 3.3V and switching frequency
of 2.1MHz has a V IN(PS) of 12.7V, as shown in Figure 1.
Figure 2 shows operation at 27V. Output ripple and peak
inductor current have signi?cantly increased. A saturating
inductor may further reduce performance. In pulse skip
mode, the LT3688 skips switching pulses to maintain
output regulation. The LT3688 will also skip pulses at very
low load currents. V IN(PS) vs load current is plotted in the
Typical Performance section.
V OUT
50mV/DIV
(AC)
I L
500mA/DIV
Unlike many ?xed frequency regulators, the LT3688 can
extend its duty cycle by remaining on for multiple cycles.
The LT3688 will not switch off at the end of each clock
cycle if there is suf?cient voltage across the boost capacitor
(C3 in the Block Diagram). Eventually, the voltage on the
boost capacitor falls and requires refreshing. Circuitry
detects this condition and forces the switch to turn off,
allowing the inductor current to charge up the boost
capacitor. This places a limitation on the maximum duty
cycle as follows:
DC MAX = 90%
This leads to a minimum input voltage of:
V + V F
DC MAX
where V F is the forward voltage drop of the catch diode
2μs/DIV
3688 F01
(~0.4V) and V SW is the voltage drop of the internal switch
(~0.3V at maximum load).
V IN(MIN) =
– 0.4 + 0.3V = 4V
2μs/DIV
L = ( V OUT + V F ) ?
Figure 1. Operation Below Pulse-Skipping
Voltage. V OUT = 3.3V and f SW = 2.1MHz
V OUT
50mV/DIV
(AC)
I L
500mA/DIV
3688 F02
Figure 2. Operation Above V IN(ps) . V IN = 27V,
V OUT = 3.3V and f SW = 2.1MHz. Output Ripple
and Peak Inductor Current Increase
Minimum Operating Voltage Range
The minimum input voltage is determined either by the
LT3688’s minimum operating voltage of ~3.6V or by its
maximum duty cycle. The duty cycle is the fraction of
time that the internal switch is on and is determined by
the input and output voltages:
Example: I SW =0.8A and V OUT = 3.3V
3.3V + 0.4V
90%
For best performance in dropout, use a 1μF or larger
boost capacitor.
Inductor Selection and Maximum Output Current
A good ?rst choice for the inductor value is
1.8MHz
f SW
where V F is the voltage drop of the catch diode (~0.4V),
f SW is in MHz, and L is in μH. The inductor ’s RMS current
rating must be greater than the maximum load current
and its saturation current should be at least 30% higher.
For robust operation in fault conditions (start-up or short-
circuit) and high input voltage (>30V), use an 8.2μH or
greater inductor with a saturation rating of 2.2A, or higher.
For highest ef?ciency, the series resistance (DCR) should
be less than 0.1Ω. Table 2 lists several vendors and types
DC =
V OUT + V F
V IN – V SW + V F
that are suitable.
3688f
14
相关PDF资料
PDF描述
MAX6720AUTTZD6+T IC SUPERVISOR MPU SOT23-6
USR0G470MDD CAP ALUM 47UF 4V 20% RADIAL
RGM10DTAN CONN EDGECARD 20POS R/A .156 SLD
VI-J3V-EY-S CONVERTER MOD DC/DC 5.8V 50W
USA1V4R7MDD CAP ALUM 4.7UF 35V 20% RADIAL
相关代理商/技术参数
参数描述
LT3688EUF#PBF 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压(升压) 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型,TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT
LT3688EUF#TRPBF 功能描述:IC REG BUCK ADJ 0.8A DL 24QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压(升压) 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型,TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT
LT3688EUFPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 800mA Step-Down Switching Regulator with Power-On Reset
LT3688HFE#PBF 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘,8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?(2x2) 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2
LT3688HFE#TRPBF 功能描述:IC REG BUCK ADJ 0.8A DL 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压(升压) 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型,TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT