- 您现在的位置：买卖IC网 > PDF目录13970 > LT3689EUD#TRPBF (Linear Technology)IC REG BUCK ADJ 0.7A 16QFN PDF资料下载
参数资料
| 型号： | LT3689EUD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/34页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 0.7A 16QFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 34.2 V |
| 输入电压： | 3.6 V ~ 36 V |
| PWM 型： | 电流模式，Burst Mode? |
| 频率 - 开关： | 500kHz ~ 2MHz |
| 电流 - 输出： | 700mA |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-QFN-EP（3x3） |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LT3689/LT3689-5
PIN FUNCTIONS
BST: The BST pin is used to provide drive voltage higher
than the input voltage to the internal NPN power switch.
V IN : The V IN pin supplies current to the LT3689’s internal
circuitry and to the internal power switch and must be
locally bypassed.
SW: The SW pin is the output of the internal power switch.
Connect this pin to the inductor, catch diode and boost
capacitor.
DA: Tie the DA pin to the anode of the external catch
Schottky diode. If the DA pin current exceeds 1.2A,
which could occur in an overload or short-circuit condi-
tion, switching is disabled until the DA pin current falls
below 1.2A.
EN/UVLO: The EN/UVLO pin is used to put the LT3689 in
shutdown mode. Pull the pin below 0.3V to shut down the
LT3689. The 1.26V threshold can function as an accurate
undervoltage lockout (UVLO), preventing the regulator
from operating until the input voltage has reached the
programmed level.
FB : The LT3689 regulates the feedback pin to 0.800V. Con-
nect the feedback resistor divider tap to this pin. For the
fixed LT3689-5 output, this pin can be used to connect a
phase lead capacitor between the OUT pin and FB pin to
optimize transient response.
WDE : Watchdog Timer Enable Pin. This pin disables the
watchdog timer if the WDE voltage exceeds 1V. WDO is
high in this condition.
W /T: Setting W /T low puts the LT3689 watchdog timer into
window mode. If two or more negative edges occur on
WDI before the watchdog lower boundary (t WDL ) period
expires, or no negative edge occurs within the watchdog
upper boundary (t WDU ) period, the part will set WDO low. If
W /T is set high, the part will only set WDO low if no transi-
tion occurs within the watchdog upper boundary period.
WDI: Watchdog Timer Input Pin. This pin receives the
watchdog signal from a microprocessor. If the appropriate
signal is not received, the part will pulse WDO low for a
period equal to the reset timeout period. The watchdog
timer is disabled until the WDO pin goes high again.
RST : Active low, open collector logic output with a weak
pull-up to V OUT . After V OUT rises above 90% of its pro-
grammed value, the reset remains asserted for the period
set by the capacitor on the C POR pin.
WDO : Active low, open collector logic output with weak
pull-up to V OUT . WDO pulls low if the WDE is enabled
and the microprocessor fails to drive the WDI pin of the
LT3689 with an appropriate signal.
C WDT : Watchdog Timer Programming Pin. Place a capa-
citor (C WDT ) between this pin and ground to adjust the
watchdog upper and lower boundary period. To determine
the watchdog upper boundary period, and the lower bound-
ary period, use the following equations:
t WDU = 18.2 ? C WDT (watchdog upper boundary period)
t WDL = 0.588 ? C WDT (watchdog lower boundary period)
t WDU and t WDL are in ms and C WDT is in nF. As an example,
a 47nF capacitor will generate an 855ms watchdog upper
boundary period and a 27.6ms watchdog lower boundary
period.
C POR : Reset Delay Timer Programming Pin. Attach an
external capacitor (C POR ) to GND to set a reset delay time
of 2.3ms/nF.
RT: Sets the Internal Oscillator Frequency. Tie a 31.6k
resistor from RT to GND for a 500kHz switching frequency.
SYNC: Drive the SYNC pin with a logic level signal with
positive and negative pulse widths of at least 80ns. The
R T resistor should be chosen to set the LT3689 switching
frequency at least 20% below the lowest synchronization
input frequency.
OUT: The OUT pin supplies current to the internal circuitry
when OUT is above 3V, reducing input quiescent current.
The internal Schottky diode is connected from OUT to BST,
providing the charging path for the boost capacitor. For
the LT3689-5, this pin connects to the internal feedback
divider that programs the fixed 5V output.
GND: Ground. Tie the exposed pad directly to the ground
plane. The exposed pad metal of the package provides both
electrical contact to ground and good thermal contact to
the printed circuit board. The device must be soldered to
the circuit board for proper operation.
3689fe
For more information www.linear.com/LT3689
9
相关PDF资料 |
PDF描述 |
|---|---|
| V110B8C150B3 | CONVERTER MOD DC/DC 8V 150W |
| LTC3569EFE#TRPBF | IC REG BUCK SYNC ADJ 16TSSOP |
| AIAP-03-682-K | INDUCTOR 6800UH 10% .322A |
| RBM43DRYN | CONN EDGECARD 86POS DIP .156 SLD |
| AIAP-03-8R2-K | INDUCTOR 8.2UH 10% 9.89A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3689HMSE#PBF | 功能描述:IC REG BUCK ADJ 0.7A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| LT3689HMSE#TRPBF | 功能描述:IC REG BUCK ADJ 0.7A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3689HMSE-5#PBF | 功能描述:IC REG BUCK 5V 0.7A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3689HMSE-5#TRPBF | 功能描述:IC REG BUCK 5V 0.7A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3689HMSE-5-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Step-Down Regulator with Power-On Reset and Watchdog Timer |
发布紧急采购，3分钟左右您将得到回复。