- 您现在的位置：买卖IC网 > PDF目录1825 > LT3690MPUFE#TRPBF (Linear Technology)IC REG BUCK SYNC ADJ 4A 26QFN PDF资料下载
参数资料
| 型号： | LT3690MPUFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 17/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 4A 26QFN |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 20 V |
| 输入电压： | 3.9 V ~ 36 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 138kHz ~ 1.5MHz |
| 电流 - 输出： | 4A |
| 同步整流器： | 是 |
| 工作温度： | -55°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 26-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 26-QFN-EP（4x6） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3690
APPLICATIONS INFORMATION
Low-Ripple Burst Mode and Pulse-Skipping Mode
The LT3690 is capable of operating in either low ripple
Burst Mode operation or pulse-skipping mode, which is
selected using the SYNC pin. See the Synchronization and
Mode section for details.
To enhance efficiency at light loads, the LT3690 can be
operated in low ripple Burst Mode operation that keeps
the output capacitor charged to the proper voltage while
minimizing the input quiescent current. During Burst Mode
operation, the LT3690 delivers single cycle bursts of current
to the output capacitor followed by sleep periods where
the output capacitor is delivers output power to the load.
Because the LT3690 delivers power to the output with
single, low current pulses, the output ripple stays below
15mV for a typical application. In addition, V IN and BIAS
quiescent currents are reduced to 35μA and 70μA (typical),
respectively, during the sleep time. As the load current
decreases towards a no-load condition, the percentage
of time that the LT3690 operates in sleep mode increases
and the average input current is greatly reduced, resulting
in high efficiency even at very low loads (see Figure 3).
At higher output loads (above about 385mA at V IN = 12V
for the front page application) the LT3690 will run at the
frequency programmed by the R T resistor, and operate in
standard PWM mode. The transition between PWM and
low ripple Burst Mode operation is seamless, and does
not disturb the output voltage.
V SW
5V/DIV
I L
0.5A/DIV
V OUT
10mV/DIV
If low quiescent current is not required, the LT3690 can
operate in pulse-skipping mode. The benefit of this mode
is that the LT3690 will enter full frequency standard PWM
operation at a lower output load current than when in
Burst Mode operation. The front page application circuit
will switch at full frequency at output loads higher than
about 64mA at V IN = 12V.
Low Side Switch Considerations
The operation of the internal low side switch is optimized
for reliable, high efficiency operation. The low side switch
is connected in parallel with a catch diode. When the top
side switch turns off, the inductor current pulls the SW
pin low, and forward biases the internal catch diode. In
order to prevent shoot through currents, the internal low
side switch only turns on after detecting the SW pin going
low. Once the low side switch turns on, the voltage drop
between SW and GND is very small, minimizing power
loss and improving efficiency. At the end of the switching
cycle, the low side switch turns off, and after a delay, the
top side switch can turn on again. The switching sequence
is shown in Figure 4.
The overload comparator monitors the current flowing
through the low side switch and helps protect the circuit.
This comparator delays switching if the low side switch
current goes higher than 5A (typical) during a fault con-
dition such as a shorted output with high input voltage.
V IN = 12V
V OUT = 3.3V
L = 3.3μH
V SW
2V/DIV
0V
5μs/DIV
3690 F03
200ns/DIV
3690 F04
V IN = 12V: I LOAD = 20mA
FRONT PAGE APPLICATION
Figure 3. Burst Mode Operation
Figure 4. Switching Sequence of High Side,
Catch Diode and Low Side Switch
3690fa
17
相关PDF资料 |
PDF描述 |
|---|---|
| LT3692IUH#TRPBF | IC REG BUCK ADJ 3.5A DL 32QFN |
| LT3693IMSE#TRPBF | IC REG BUCK ADJ 3.5A 10MSOP |
| LT3695HMSE-5#TRPBF | IC REG BUCK 5V 1A 16MSOP |
| LT3710EFE#TRPBF | IC REG CTRLR BUCK PWM 16-TSSOP |
| LT3724EFE#PBF | IC REG CTRLR BST INV PWM 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3692 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking |
| LT3692A | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking |
| LT3692AEFE#PBF | 功能描述:IC REG BUCK ADJ 3.5A DL 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3692AEFE#TRPBF | 功能描述:IC REG BUCK ADJ 3.5A DL 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3692AEUH#PBF | 功能描述:IC REG BUCK ADJ 3.5A DL 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。