- 您现在的位置：买卖IC网 > PDF目录44986 > LT3692IUH#PBF (LINEAR TECHNOLOGY CORP) 5.8 A DUAL SWITCHING CONTROLLER, 2750 kHz SWITCHING FREQ-MAX, PQCC32 PDF资料下载
参数资料
| 型号： | LT3692IUH#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 5.8 A DUAL SWITCHING CONTROLLER, 2750 kHz SWITCHING FREQ-MAX, PQCC32 |
| 封装： | 5 X 5 MM, LEAD FREE, PLASTIC, MO-220WHHD, QFN-32 |
| 文件页数： | 10/36页 |
| 文件大小： | 526K |
| 代理商： | LT3692IUH#PBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LT3692
18
3692f
APPLICATIONS INFORMATION
Loop compensation determines the stability and transient
performance.Designingthecompensationnetworkisabit
complicated and the best values depend on the application
and in particular the type of output capacitor. A practical
approach is to start with one of the circuits in this data
sheet that is similar to your application and tune the com-
pensation network to optimize the performance. Stability
should then be checked across all operating conditions,
including load current, input voltage and temperature.
The LT1375 data sheet contains a more thorough discus-
sion of loop compensation and describes how to test the
stability using a transient load.
Figure 8 shows an equivalent circuit for the LT3692 control
loop. The error amp is a transconductance amplifier with
finite output impedance. The power section, consisting of
the modulator, power switch and inductor, is modeled as
a transconductance amplifier generating an output cur-
rent proportional to the voltage at the VC pin. Note that
the output capacitor integrates this current, and that the
capacitor on the VC pin (CC) integrates the error amplifier
output current, resulting in two poles in the loop. In most
cases a zero is required and comes from either the output
capacitor ESR or from a resistor in series with CC.
This simple model works well as long as the value of the
inductor is not too high and the loop crossover frequency
is much lower than the switching frequency. A phase lead
capacitor (CPL) across the feedback divider may improve
the transient response.
Synchronization
The RT/SYNC pin can also be used to synchronize the
regulatorstoanexternalclocksource.DrivingtheRT/SYNC
resistor with a clock source triggers the synchronization
detection circuitry. Once synchronization is detected, the
rising edge of SW1 will be synchronized to the rising edge
of the RT/SYNC signal and the rising edge of SW2 syn-
chronized to the falling edge of the RT/SYNC signal (see
Figures 10 and 11). During synchronization, a 0V to 2.4V
square wave with the same frequency and duty cycle as
the synchronization signal is output via the CLKOUT pin
with a typical propagation delay of 250ns. In addition, an
internal AGC loop will adjust slope compensation to avoid
subharmonic oscillation. If the synchronization signal is
halted, the synchronization detection circuitry will timeout
in typically 10s at which time the LT3692 reverts to the
free-runningfrequencybasedontheRT/SYNCpinvoltage.
The synchronizing clock signal input to the LT3692 must
have a frequency between 200kHz and 2MHz, a duty cycle
between 20% and 80%, a low state below 0.5V and a high
state above 1.6V. Synchronization signals outside of these
parameters will cause erratic switching behavior. If the
RT/SYNC pin is held above 1.6V at any time, switching
will be disabled.
If the synchronization signal is not present during regu-
lator start-up (for example, the synchronization circuitry
is powered from the regulator output) the RT/SYNC pin
must remain below 1V until the synchronization circuitry
is active for proper start-up operation.
Figure 8. Model for Loop Response
+
–
0.806V
LT3692
FB
VC
CF
CPL
OUTPUT
C1
3692 F08
CC
RC
R1
ESR
TANTALUM
OR
POLYMER
CERAMIC
R2
3.6M
ERROR
AMP
gm = 400mho
CURRENT MODE
POWER STAGE
gm = 4.8mho
相关PDF资料 |
PDF描述 |
|---|---|
| LT3692EUH#PBF | 5.8 A DUAL SWITCHING CONTROLLER, 2750 kHz SWITCHING FREQ-MAX, PQCC32 |
| LT3724MPFE#TR | SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3740EDHC | 0.14 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3741EFE#PBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3741IFE#TRPBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PDSO20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3693 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking |
| LT36931DD#PBF | 制造商:Linear Technology 功能描述: |
| LT3693EDD#PBF | 功能描述:IC REG BUCK ADJ 3.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3693EDD#TRPBF | 功能描述:IC REG BUCK ADJ 3.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3693EDDPBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Down 3.6-36V DFN10 |
发布紧急采购，3分钟左右您将得到回复。