- 您现在的位置：买卖IC网 > PDF目录30767 > LT3694IUFD#PBF (LINEAR TECHNOLOGY CORP) 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 PDF资料下载
参数资料
| 型号： | LT3694IUFD#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 |
| 封装： | 4 X 5 MM, LEAD FREE, PLASTIC, MO-220, QFN-28 |
| 文件页数： | 2/28页 |
| 文件大小： | 276K |
| 代理商： | LT3694IUFD#PBF |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3694/LT3694-1
10
36941fa
STEP DOWN SWITCHING REGULATOR
Feedback Resistor Network
The output voltage is programmed with a resistor divider
(refer to the Block Diagram in Figure 1) between the output
and the FB pin. Choose the resistors according to:
R1
=R2
V
OUT
750mV
1
The parallel combination of R1 and R2 should be 10k or
less to avoid bias current errors.
Input Overvoltage Lockout
An important feature of the LT3694 is the ability to survive
transient surges on the input voltage of up to 70V. This is
accomplished by shutting off the regulators to keep this
high voltage off the critical components. The overvoltage
lockout trips when the input voltage exceeds 38V.
Input Voltage Range
The minimum operating voltage is determined either by the
LT3694’s internal undervoltage lockout or by its maximum
duty cycle. The duty cycle is the fraction of time that the
internal switch is on and is determined by the input and
output voltage:
DC
=
V
OUT + VF
V
IN VSW + VF
where VF is the forward voltage drop of the catch diode
and VSW is the voltage drop of the internal switch (~0.3V
at maximum load). This leads to a minimum input
voltage of:
V
IN(MINCF) =
V
OUT + VF
DC
MAX(CF)
V
F + VSW
The duty cycle is the fraction of time that the internal
switch is on during a clock cycle. The maximum duty cycle
for constant-frequency operation given by DCMAX(CF) = 1
– tOFF(MIN) fSW. However, unlike most fixed frequency
regulators, the LT3694 will not switch off at the end of
each clock cycle if there is sufficient voltage across the
boost capacitor (C3 in Figure 1) to fully saturate the output
switch. A forced switch off for a minimum time will only
occur at the end of a clock cycle when the boost capaci-
tor needs to be recharged. This operation has the same
effect as lowering the clock frequency for a fixed off time,
resulting in a higher duty cycle and lower minimum input
voltage. The resultant duty cycle depends on the charging
times of the boost capacitor and can be approximated by
the following equation:
DC
MAX =
B
+ 1
where B is the output current divided by the typical
boost current from the BST Pin Current vs Switch Cur-
rent curve in the Typical Performance Characteristics
section.
The maximum voltage, VIN, for constant-frequency opera-
tion is determined by the minimum duty cycle DCMIN:
V
IN(MAXCF) =
V
OUT + VF
DC
MIN
V
F + VSW
with DCMIN = tON(MIN) fSW
Thus, both the maximum and minimum input voltages
for constant-frequency operation are a function of the
switching frequency and output voltage. Therefore, the
maximum switching frequency must be set to a value that
accommodates the input and output voltage parameters
and must meet both of the following criteria:
f
MAX1=
V
OUT + VF
V
IN(MAXCF) VSW + VF
1
t
ON(MIN)
f
MAX2 = 1
V
OUT + VF
V
IN(MINCF) VSW + VF
1
t
OFF(MIN)
The values of tON(MIN) and tOFF(MIN) are functions of
ISW and temperature (see chart in the Typical Perform-
ance Characteristics section). Worst-case values for
switch currents greater than 0.5A are tON(MIN) = 130ns and
APPLICATIONS INFORMATION
相关PDF资料 |
PDF描述 |
|---|---|
| LT3694-1IFE#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3694-1EFE#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3695IMSE-5#PBF | 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3695EMSE-5#TRPBF | 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3695IMSE-5#TRPBF | 2 A SWITCHING REGULATOR, 2420 kHz SWITCHING FREQ-MAX, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3695 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1A Fault Tolerant Micropower Step-Down Regulator |
| LT3695EMSE#PBF | 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3695EMSE#TRPBF | 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3695EMSE-3.3#PBF | 功能描述:IC REG BUCK 3.3V 1A 16MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V，1.5V，1.8V，2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘 |
| LT3695EMSE-3.3#PBF | 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR MSOP-16 |
发布紧急采购，3分钟左右您将得到回复。