- 您现在的位置：买卖IC网 > PDF目录20866 > LT3755IMSE-2#TRPBF (Linear Technology)IC LED DRVR HP CONS CURR 16-MSOP PDF资料下载
参数资料
| 型号： | LT3755IMSE-2#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/26页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR HP CONS CURR 16-MSOP |
| 标准包装： | 2,500 |
| 恒定电流： | 是 |
| 恒定电压： | 是 |
| 拓扑： | 回扫，低端，PWM，SEPIC，降压（降压），升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 无 |
| 类型 - 主要： | 车载 |
| 类型 - 次要： | 白色 LED |
| 频率： | 100kHz ~ 1MHz |
| 电源电压： | 4.5 V ~ 40 V |
| 输出电压： | 75V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TFSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 16-MSOP，裸露焊盘 |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 125°C |
LT3755/LT3755-1/LT3755-2
PIN FUNCTIONS
(MSOP/QFN)
CTRL (Pin 6/Pin 16): Current Sense Threshold Adjustment
Pin. Regulating threshold V (ISP – ISN) is 1/10th V CTRL plus
an offset for 0V < V CTRL < 1V. For V CTRL > 1.2V the current
sense threshold is constant at the full-scale value of 100mV.
For 1V < V CTRL < 1.2V, the dependence of current sense
threshold upon V CTRL transitions from a linear function
to a constant value, reaching 98% of full-scale value by
V CTRL = 1.1V. Do not leave this pin open.
V REF (Pin 7/Pin 1): Voltage Reference Output Pin, Typically
2V. This pin drives a resistor divider for the CTRL pin, either
for analog dimming or for temperature limit/compensation
of LED load. Can supply up to 100μA.
PWM (Pin 8/Pin 2): A signal low turns off switcher, idles
oscillator and disconnects VC pin from all internal loads.
PWMOUT pin follows PWM pin. PWM has an internal
pull-down resistor. If not used, connect to INTV CC .
OPENLED (Pin 9/Pin 3, LT3755 and LT3755-2): An open-
collector pull-down on OPENLED asserts if the FB input
is greater than the FB regulation threshold minus 50mV
(typical). To function, the pin requires an external pull-up
current less than 1mA. When the PWM input is low and
the DC/DC converter is idle, the OPENLED condition is
latched to the last valid state when the PWM input was
high. When PWM input goes high again, the OPENLED
pin will be updated. This pin may be used to report an
open LED fault.
SYNC (Pin 9/Pin 3, LT3755-1 Only): The SYNC pin is used
to synchronize the internal oscillator to an external logic
level signal. The R T resistor should be chosen to program
an internal switching frequency 20% slower than the SYNC
pulse frequency. Gate turn-on occurs a fixed delay after
the rising edge of SYNC. For best PWM performance, the
PWM rising edge should occur at least 200ns before the
SYNC rising edge. Use a 50% duty cycle waveform to
drive this pin. This pin replaces OPENLED on LT3755-1
option parts. If not used, tie this pin to GND.
SS (Pin 10/Pin 4): Soft-Start Pin. This pin modulates
oscillator frequency and compensation pin voltage (VC)
clamp. The soft-start interval is set with an external capaci-
tor. The pin has a 10μA (typical) pull-up current source
to an internal 2.5V rail. The soft-start pin is reset to GND
by an undervoltage condition (detected by SHDN /UVLO
pin) or thermal limit.
RT (Pin 11/Pin 5): Switching Frequency Adjustment Pin.
Set the frequency using a resistor to GND (for resistor
values, see the Typical Performance curve or Table 1).
Do not leave the RT pin open.
SHDN /UVLO (Pin 12/Pin 6): Shutdown and Undervoltage
Detect Pin. An accurate 1.22V falling threshold with ex-
ternally programmable hysteresis detects when power is
OK to enable switching. Rising hysteresis is generated
by the external resistor divider and an accurate internal
2.1μA pull-down current. Above the threshold (but below
6V), SHDN /UVLO input bias current is sub-μA. Below the
falling threshold, a 2.1μA pull-down current is enabled so
the user can define the hysteresis with the external resis-
tor selection. An undervoltage condition resets soft-start.
Tie to 0.4V, or less, to disable the device and reduce V IN
quiescent current below 1μA.
INTV CC (Pin 13/Pin 7): Regulated Supply for Internal
Loads, GATE Driver and PWMOUT Driver. Supplied from
V IN and regulates to 7.15V (typical). INTV CC must be
bypassed with a 4.7μF capacitor placed close to the pin.
Connect INTV CC directly to V IN if V IN is always less than
or equal to 8V.
V IN (Pin 14/Pin 8): Input Supply Pin. Must be locally
bypassed with a 0.22μF (or larger) capacitor placed close
to the IC.
SENSE (Pin 15/Pin 9): The current sense input for the
control loop. Kelvin connect this pin to the positive ter-
minal of the switch current sense resistor, R SENSE , in the
source of the NFET. The negative terminal of the current
sense resistor should be Kelvin connected to the GND
plane of the IC.
GATE (Pin 16/Pin 10): N-channel FET Gate Driver Output.
Switches between INTV CC and GND. Driven to GND during
shutdown, fault or idle states.
Exposed Pad (Pin 17/Pin 17): Ground. This pin also serves
as current sense input for control loop, sensing negative
terminal of current sense resistor. Solder the Exposed Pad
directly to ground plane.
37551fd
相关PDF资料 |
PDF描述 |
|---|---|
| LT3599EUH#TRPBF | IC LED DRIVR WHITE BCKLGT 32-QFN |
| TH3C686K010C1000 | CAP TANT 68UF 10V 10% 2312 |
| LT3755IMSE-1#TRPBF | IC LED DRVR HP CONS CURR 16-MSOP |
| P51-2000-S-C-I12-4.5V-000-000 | SENSOR 2000PSI M12-1.5 6G 4.5V |
| P51-15-S-P-MD-4.5V-000-000 | SENSOR 15PSI M20-1.5 6G .5-4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3755IMSE-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:40VIN, 75VOUT LED Controller |
| LT3755IMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:40VIN, 75VOUT LED Controller |
| LT3755IUD#PBF | 功能描述:IC LED DRVR HP CONST CURR 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3755IUD#PBF | 制造商:Linear Technology 功能描述:LED DRIVER PWM 1MHZ QFN-16 制造商:Linear Technology 功能描述:LED DRIVER, PWM, 1MHZ, QFN-16 |
| LT3755IUD#TRPBF | 功能描述:IC LED DRVR HP CONST CURR 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
发布紧急采购，3分钟左右您将得到回复。