- 您现在的位置：买卖IC网 > PDF目录15310 > LT3759HMSE#PBF (Linear Technology)IC REG CTRLR BST INV PWM 12-MSOP PDF资料下载
参数资料
| 型号： | LT3759HMSE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 9/32页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST INV PWM 12-MSOP |
| 标准包装： | 37 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 电源电压： | 1.6 V ~ 42 V |
| 降压： | 无 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 是 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 12-TSSOP （0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LT3759
APPLICATIONS INFORMATION
V VIN(FALLING) = 1.22 ?
MainControlLoop
The LT3759 uses a fixed frequency, current mode control
scheme to provide excellent line and load regulation.
Operation can be best understood by referring to the Block
Diagram in Figure 1.
The start of each oscillator cycle sets the SR latch (SR1) and
turns on the external power MOSFET switch M1 through
driver G2. The switch current flows through the external
current sensing resistor R SENSE and generates a voltage
proportional to the switch current. This current sense
voltage V ISENSE (amplified by A5) is added to a stabilizing
slope compensation ramp and the resulting sum (SLOPE)
is fed into the positive terminal of the PWM comparator A7.
When SLOPE exceeds the level at the negative input of A7
(VC pin), SR1 is reset, turning off the power switch. The
level at the negative input of A7 is set by the error amplifier
A1 (or A2) and is an amplified version of the difference
between the feedback voltage (FBX pin) and the reference
voltage (1.6V or –0.8V, depending on the configuration).
In this manner, the error amplifier sets the correct peak
switch current level to keep the output in regulation.
The LT3759 has a switch current limit function. The current
sense voltage is input to the current limit comparator A6.
If the SENSE pin voltage is higher than the sense current
limit threshold V SENSE(MAX) (50mV, typical), A6 will reset
SR1 and turn off M1 immediately.
The LT3759 is capable of generating either positive or nega-
tive output voltage with a single FBX pin. It can be configured
as a boost or SEPIC converter to generate positive output
voltage, or as an inverting converter to generate negative
output voltage. When configured as a SEPIC converter, as
shown in Figure 1, the FBX pin is pulled up to the internal bias
voltage of 1.6V by a voltage divider (R1 and R2) connected
from V OUT to GND. Comparator A2 becomes inactive and
comparator A1 performs the inverting amplification from
FBX to VC. When the LT3759 is in an inverting configuration,
the FBX pin is pulled down to –0.8V by a voltage divider
connected from V OUT to GND. Comparator A1 becomes
inactive and comparator A2 performs the noninverting
amplification from FBX to VC.
The LT3759 has overvoltage protection functions to protect
the converter from excessive output voltage overshoot
during start-up or recovery from a short-circuit condition.
An overvoltage comparator A11 (with 40mV hysteresis)
senses when the FBX pin voltage exceeds the positive
regulated voltage (1.6V) by 7.5% and turns off M1.
Similarly, an overvoltage comparator A12 (with 20mV
hysteresis) senses when the FBX pin voltage exceeds the
negative regulated voltage (–0.8V) by 7.5% and turns
off M1. Both reset pulses are sent to the main RS latch
(SR1) through G6 and G5. The external power MOSFET
switch M1 is actively held off for the duration of an output
overvoltage condition.
Programming Turn-On and Turn-Off Thresholds with
EN/UVLO Pin
The EN/UVLO pin controls whether the LT3759 is enabled
or is in shutdown state. A micropower 1.22V reference, a
comparator A10 and controllable current source I S1 allow
the user to accurately program the supply voltage at which
the IC turns on and off. The falling value can be accurately
set by the resistor dividers R3 and R4. When EN/UVLO
is above 0.7V, and below the 1.22V threshold, the small
pull-down current source I S1 (typical 2μA) is active.
The purpose of this current is to allow the user to program
the rising hysteresis. The Block Diagram of the comparator
and the external resistors is shown in Figure 1. The typical
falling threshold voltage and rising threshold voltage can
be calculated by the following equations:
(R3 + R4)
R4
V VIN(RISING) = 2μA ? R3 + V IN(FALLING)
For applications where the EN/UVLO pin is only used as
a logic input, the EN/UVLO pin can be connected directly
to the input voltage V IN for always-on operation.
INTV CC Low Dropout Voltage Regulators
The LT3759 features two internal low dropout (LDO) volt-
age regulators (V IN LDO and DRIVE LDO) powered from
different supplies (V IN and DRIVE respectively). Both LDO’s
regulate the internal INTV CC supply which powers the gate
driver and the internal loads, as shown in Figure 1. Both
regulators are designed so that current does not flow from
INTV CC to the LDO input under a reverse bias condition.
DRIVE LDO regulates the INTV CC to 4.75V, while V IN LDO
3759fc
For more information www.linear.com/3759
9
相关PDF资料 |
PDF描述 |
|---|---|
| LT1725CGN#TR | IC REG CTRLR FLYBK ISO CM 16SSOP |
| UCA2V330MHD1TN | CAP ALUM 33UF 350V 20% RADIAL |
| B41042A3827M | 820UF 10V 10X20 SINGLE END |
| LT3757HMSE#TRPBF | IC REG CTRLR PWM CM 10-MSOP |
| LTC3830-1ES8#TRPBF | IC REG CTRLR BUCK PWM VM 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3759IMSE#PBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3759IMSE#TRPBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT375B | 制造商:EDSYN 功能描述:TIP SPADE 1.5X12.2MM |
| LT375-C | 制造商:EDSYN 功能描述: |
| LT376 | 制造商:EDSYN 功能描述: 制造商:EDSYN 功能描述:SOLDERING TIP, Tip / Nozzle Length:0.48" |
发布紧急采购，3分钟左右您将得到回复。