- 您现在的位置：买卖IC网 > PDF目录44987 > LT3837IFE#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LT3837IFE#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | 4.40 MM, LEAD FREE, PLASTIC, TSSOP-16 |
| 文件页数： | 10/28页 |
| 文件大小： | 247K |
| 代理商： | LT3837IFE#TRPBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3837
18
3837fc
APPLICATIONS INFORMATION
Enable Delay Time (ENDLY)
Enable delay time provides a programmable delay between
turn-off of the primary gate drive node and the subsequent
enabling of the feedback amplier. As discussed earlier, this
delay allows the feedback amplier to ignore the leakage
inductance voltage spike on the primary side.
The worst-case leakage spike pulse width is at maximum
load conditions. So set the enable delay time at these
conditions.
While the typical applications for this part use forced
continuous operation, it is conceivable that a secondary-
side controller might cause discontinuous operation at
light loads. Under such conditions the amount of energy
stored in the transformer is small. The yback waveform
becomes “lazy” and some time elapses before it indicates
the actual secondary output voltage. The enable delay time
should be made long enough to ignore the “irrelevant”
portion of the yback waveform at light load.
Even though the LT3837 has a robust gate drive, the gate
transition-time slows with very large MOSFETs. Increase
delay time is as required when using such MOSFETs.
The enable delay resistor is set with the following equa-
tion:
Rk
tns
ENDLY
()
() –
.
Ω=
30
2 616
Keep RENDLY greater than 40k. A good starting point
is 56k.
Primary Gate Delay Time (PGDLY)
Primary gate delay is the programmable time from the
turn-off of the synchronous MOSFET to the turn-on of
the primary side MOSFET. Correct setting eliminates
overlap between the primary side switch and secondary
side synchronous switch(es) and the subsequent current
spike in the transformer. This spike will cause additional
component stress and a loss in regulator efciency.
The primary gate delay resistor is set with the following
equation:
Rk
tns
PGDLY
()
.
Ω=
+ 47
901
A good starting point is 27k.
Soft-Start Functions
The LT3837 contains an optional soft-start function that is
enabled by connecting an external capacitor between the
SFST pin and ground. Internal circuitry prevents the control
voltage at the VC pin from exceeding that on the SFST pin.
There is an initial pull-up circuit to quickly bring the SFST
voltage to approximately 0.8V. From there it charges to
approximately 2.8V with a 20μA current source.
The SFST node is then discharged to 0.8V when a fault
occurs. A fault is VCC too low (undervoltage lockout),
current sense voltage greater than 200mV or the IC’s
thermal (overtemperature) shutdown is tripped. When
SFST discharges, the VC node voltage is also pulled low
to below the minimum current voltage. Once discharged,
the SFST recharges up again.
In this manner, switch currents are reduced and the stresses
in the converter are reduced during fault conditions.
The time it takes to fully charge soft-start is:
t
CV
μA
ms C
μF
SS
SFST
==
.
(
)
14
20
70
UVLO Pin Function
The UVLO pin provides a user programming undervoltage
lockout. This is usually used to provide undervoltage
lockout based on VIN. The gate drivers are disabled when
UVLO is below the 1.24V UVLO threshold. An external
resistive divider between the input supply and ground is
used to set the turn-on voltage.
The bias current on this pin depends on the pin volt-
age and UVLO state. The change provides the user with
adjustable UVLO hysteresis. When the pin rises above
the UVLO threshold a small current is sourced out of the
pin, increasing the voltage on the pin. As the pin voltage
drops below this threshold, the current is stopped, further
相关PDF资料 |
PDF描述 |
|---|---|
| LT3845AMPFE#TRPBF | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3845AIFE#TRPBF | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3845AMPFE#PBF | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3845EFE#TR | SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3956IUHE#TRPBF | SWITCHING REGULATOR, PQCC36 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT383L313 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| LT3844 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency |
| LT3844EFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency |
| LT3844EFE#PBF | 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3844EFE#TRPBF | 功能描述:IC REG CTRLR BST INV PWM 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。