- 您现在的位置：买卖IC网 > PDF目录10695 > LT6700IS6-1#TRPBF (Linear Technology)IC COMP DUAL 400MV REF TSOT23-6 PDF资料下载
参数资料
| 型号： | LT6700IS6-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 6/20页 |
| 文件大小： | 0K |
| 描述： | IC COMP DUAL 400MV REF TSOT23-6 |
| 标准包装： | 2,500 |
| 系列： | Over-The-Top® |
| 类型： | 通用 |
| 元件数： | 2 |
| 输出类型： | 开路集电极 |
| 电压 - 电源，单路/双路(±)： | 1.4 V ~ 18 V |
| 电流 - 输入偏压（最小值）： | 0.01µA @ 18V |
| 电流 - 静态（最大值）： | 17µA |
| 传输延迟（最大）： | 29µs |
| 磁滞： | 11.5mV |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SOT-23-6 细型，TSOT-23-6 |
| 安装类型： | 表面贴装 |
| 包装： | 带卷 (TR) |
LT6700/LT6700HV
14
6700123fh
For more information www.linear.com/LT6700
APPLICATIONS INFORMATION
The LT6700-1/LT6700-2/LT6700-3/LT6700HV-1/
LT6700HV-2/LT6700HV-3 devices are a family of dual
micropower comparators with a built-in 400mV refer-
ence. Features include wide supply voltage range (1.4V to
18V), Over-The-Top input and output range, 2% accurate
rising input threshold voltage and 6.5mV typical built-in
hysteresis. The comparator’s open-collector outputs can
sink up to 40mA typical.
Internal Reference
Each of the comparator sections has one input available
externally, with the three versions of the part differing by
the polarity of those available inputs (i.e., inverting or
noninverting). The other comparator inputs are connected
internallytothe400mVreference.Therisinginputthreshold
voltage of the comparators is designed to be equal to that
of the reference (i.e., ≈400mV). The reference voltage is
established with respect to the device GND connection.
Hysteresis
Each comparator has built-in 6.5mV (typical) hysteresis to
simplify designs, ensure stable operation in the presence
of noise at the inputs, and to reject supply rail noise that
might be induced by state change load transients. The
hysteresis is designed such that the falling input threshold
voltage is nominally 393.5mV. External positive feedback
circuitry can be employed with noninverting comparator
inputs to increase effective hysteresis if desired, but such
circuitry will provide an apparent effect on both the rising
and falling input thresholds (the actual internal thresholds
remain unaffected).
Comparator Inputs
A comparator input can swing from ground to 18V (36V
for LT6700HV), regardless of the supply voltage used. The
typical input current for inputs well above threshold (i.e.,
>800mV)isafewpAleakingintoaninput.Withdecreasing
input voltage, a small bias current begins to be drawn out
of the input, reaching a few nA when at ground potential.
The input may be forced 100mV below ground without
causing an improper output, though some additional bias
current will begin to flow from the parasitic ESD input pro-
tection diode. Inputs driven further negative than 100mV
below ground will not cause comparator malfunction or
damage (provided the current is limited to 10mA), but
the accuracy of the reference cannot be guaranteed, in
which case the output state of the alternate comparator
may be affected.
Comparator Outputs
The comparator outputs are open collector and capable
of sinking 40mA typical. Load currents are directed out
the GND pin of the part. The output off-state voltage may
range between –0.3V and 18V (36V for LT6700HV) with
respect to ground, regardless of the supply voltage used.
When the output high state bias voltage is above 18V, a
100k minimum pull-up resistor is required and total load
capacitor must be less than 100nF. If the output high state
is above 18V, caution must be taken to prevent a short
from the output directly to the bias voltage, even if the
outputisintheoffstate.Aswithanyopen-collectordevice,
the outputs may be tied together to implement wire-AND
logic functions.
Power Supplies
Thecomparatorfamilycorecircuitryoperatesfromasingle
1.4V to 18V supply. A minimum 0.1F bypass capacitor
is required between the VS pin and GND. When an output
load is connected to the supply rail near the part and the
output is sinking more than 5mA, a 1F bypass capaci-
tor is recommended. The voltage reference built into the
LT6700 can be susceptible to high noise on the supply
line, particularly noise that is less than 50kHz and larger
than 20mVP-P. In order to reduce the probability of a false
comparator output in the presence of high supply noise,
an RC filter should be used to reduce the noise. This filter
can be created simply by adding a series R between the
systemsupplyandtheLT6700VSpin,usingthedecoupling
capacitortocreatealowpassresponse.Itisrecommended
that the filter have a time constant:
tRC > VN/100
Where VN is the peak-peak supply noise in millivolts and
tRC is milliseconds.
This filter will also increase the start-up time of the LT6700
by reducing the rate at which the supply can change. When
相关PDF资料 |
PDF描述 |
|---|---|
| LT6700IS6-1#TR | IC COMP DUAL 400MV REF TSOT23-6 |
| LT1011IS8 | IC VOLTAGE COMPARATOR 5V 8-SOIC |
| VI-2T1-IX-B1 | CONVERTER MOD DC/DC 12V 75W |
| AD7277AUJZ-500RL7 | IC ADC 10BIT SER 3MSPS 6TSOT |
| LTC1440CDD#TRPBF | IC COMP SGL LP 1.182V REF 8-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT6700IS6-2 | 制造商:Linear Technology 功能描述:Comparator Dual 18V 6-Pin TSOT-23 |
| LT6700IS6-2#PBF | 制造商:Linear Technology 功能描述:COMPARATOR DUAL 18V 6TSOT23 |
| LT6700IS6-2#TR | 功能描述:IC COMP DUAL 400MV REF TSOT23-6 RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:Over-The-Top® 标准包装:25 系列:- 类型:带电压基准 元件数:4 输出类型:CMOS，开路漏极，TTL 电压 - 电源，单路/双路(±):2 V ~ 11 V，±1 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:12µs 磁滞:50mV 工作温度:0°C ~ 70°C 封装/外壳:16-DIP（0.300"，7.62mm） 安装类型:通孔 包装:管件 |
| LT6700IS6-2#TRM | 功能描述:IC COMP DUAL 400MV REF TSOT23-6 RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:Over-The-Top® 标准包装:25 系列:- 类型:带电压基准 元件数:4 输出类型:CMOS，开路漏极，TTL 电压 - 电源，单路/双路(±):2 V ~ 11 V，±1 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:12µs 磁滞:50mV 工作温度:0°C ~ 70°C 封装/外壳:16-DIP（0.300"，7.62mm） 安装类型:通孔 包装:管件 |
| LT6700IS6-2#TRMPBF | 功能描述:IC COMP DUAL 400MV REF TSOT23-6 RoHS:是 类别:集成电路 (IC) >> 线性 - 比较器 系列:Over-The-Top® 标准包装:25 系列:- 类型:带电压基准 元件数:4 输出类型:CMOS，开路漏极，TTL 电压 - 电源，单路/双路(±):2 V ~ 11 V，±1 V ~ 5.5 V 电压 - 输入偏移（最小值）:10mV @ 5V 电流 - 输入偏压（最小值）:- 电流 - 输出（标准）:0.015mA @ 5V 电流 - 静态（最大值）:8.5µA CMRR, PSRR（标准）:80dB CMRR，80dB PSRR 传输延迟（最大）:12µs 磁滞:50mV 工作温度:0°C ~ 70°C 封装/外壳:16-DIP（0.300"，7.62mm） 安装类型:通孔 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。